1)10 m3 /h of water flows through a pipe with 100 mm inside diameter. Calculate the...

1)10 m³ /h of water flows through a pipe with 100 mm inside diameter. Calculate the flow velocity inside this pipe. ?

2) A river discharges 100 m³ of water to the sea every 2 seconds. What is the flow-rate of this river expressed in m3/s?

Solutions

Expert Solution

(1)

Given,

Also,

Now,

_______________________________________________________________________________

(2)

Given,

We know, flow-rate is given as;

samet mamat answered 1 year ago

Next > < Previous

Related Solutions

Water flows through a cast iron pipe with a diameter of 30 mm. The pipe is...

Water flows through a cast iron pipe with a diameter of 30 mm. The pipe is inclined at an angle of 3 degrees from horizontal and is 40 m long. The water flows due to gravity only. What is the maximum volume flow rate of the water? You may ignore any minor loses.

A cast iron water pipe of 500 mm inside diameter and 20 mm thick, is supported...

A cast iron water pipe of 500 mm inside diameter and 20 mm thick, is supported over a span of 10 meters. Find the maximum bending stress in the pipe metal, when the pipe is running full. Take density of cast iron = 70.6 kN/m3 and water = 9.8 kN/m3

a- Water enters a house through a pipe with inside diameter of 3.0 cm at an...

a- Water enters a house through a pipe with inside diameter of 3.0 cm at an absolute pressure of 5.0 X 105 Pa. A 1.5 cm diameter pipe leads to the second-floor bathroom 6.0 m above. When the flow speed at the inlet pipe is 2.0 m/s find: - Flow speed (velocity) of the water in the bathroom - Pressure water in the bathroom? - Calculate the volume flow rate in the bathroom.

Air flows through a pipe that has a length of 45 m with an inside diameter...

Air flows through a pipe that has a length of 45 m with an inside diameter of 0.025 m. The Mach number of the flow exiting the pipe is 0.26, with a static pressure of 1 atmosphere and a temperature of 300 K. If the friction factor is assumed constant at 0.007, calculate the Mach number, static pressure, static temperature and total pressure at the entrance.

Water flows through a 3 inch diameter pipe at a velocity of 10 ft/s. Find the...

Water flows through a 3 inch diameter pipe at a velocity of 10 ft/s. Find the a) volume flow rate in cfs(cubic feet per second) and gpm(gallons per minute) b) mass flow rate in slug/second.

Water (1,000 kg/m3) flows into a 10.2 cm diameter, inlet pipe (a.k.a Zone 1) at a...

Water (1,000 kg/m3) flows into a 10.2 cm diameter, inlet pipe (a.k.a Zone 1) at a pressure of 1.671E5 Pa. The liquid then flows out of a 8.7 cm diameter, open faucet situated 1.6 m above the inlet pipe, a.k.a Zone 2. a) Calculate the flow speed of the Water in Zone 2. b) Calculate the volume flow rate of the Water in either Zone.

a) Water (Densitywater = 1,000 kg/m3) flows through a pipe that narrows. At point A it...

a) Water (Densitywater = 1,000 kg/m3) flows through a pipe that narrows. At point A it is determined that the water flows with a velocity of VA = 93 m/s. At point B it is determined that the water flows with a velocity of VB = 193 m/s.What is the nagnitude of the difference in pressure between points A and B. b) Two trains pass each other. Train A is traveling 36 m/s east. Train B is traveling 23 m/s...

A liquid of density 1.33 × 103 kg/m3 flows steadily through a pipe of varying diameter...

A liquid of density 1.33 × 103 kg/m3 flows steadily through a pipe of varying diameter and height. At location 1 along the pipe the flow speed is 9.09 m/s and the pipe diameter is 10.9 cm. At location 2 the pipe diameter is 14.3 cm. At location 1 the pipe is 9.75 m higher than it is at location 2. Ignoring viscosity, calculate the difference between the fluid pressure at location 2 and the fluid pressure at location 1.

) A 50 mm-diameter propeller was installed in a 150 mm-diameter water pipe and the propeller...

) A 50 mm-diameter propeller was installed in a 150 mm-diameter water pipe and the propeller speed was measured for a range of water discharge in the pipe. The water had a density and dynamic viscosity of 1000 kg/m3 and 0.00112 Ns/m2 respectively. The measured results were as follows: Q (litres/s): 12 28 45 63 95 120 160 180 N (rps): 5 10 15 20 30 40 60 80 Plot the dependence of propeller coefficient against propeller Reynolds number. A...

Two water reservoirs are joined by a sharp ended flexible pipe 100 mm in diameter and...

Two water reservoirs are joined by a sharp ended flexible pipe 100 mm in diameter and 36 m long. The ends of the pipe differ in level by 4 m. The surface level of the upper reservoir is 1.8 m above the pipe inlet whilst that of the lower reservoir is 1.2 m above the pipe outlet. At a position 7.5 m horizontally from the upper reservoir, the pipe is required to pass over a barrier. Assuming that the pipe...

Subjects