Questions
Explain what the process is for installing and removing a sheet pile retaining wall system. What...

Explain what the process is for installing and removing a sheet pile retaining wall system. What are some of the benefits and limitations of this system?

In: Civil Engineering

PROBLEM 1: A standard split-spoon penetration sampler is proposed for a geotechnical field exploration project. Calculate...

PROBLEM 1:
A standard split-spoon penetration sampler is proposed for a geotechnical field exploration project. Calculate the area ratio of the sampler if its outside and cutting-edge diameter are 45 mm and 40 mm respectively
PROBLEM 2:
A soil sample has a mass of 2290 g and a volume of 0.00115 cu.m. After being completely dried in an oven, the mass of the sample is found to be 2035 g. If Gs=2.68, determine the air content in percent
PROBLEM 3:
A soil sample has a unit weight of 120 pcf and a degree of saturation of 65%. When its degree of saturation is increased to 80%, its unit weight increases to 124 pcf. Determine the saturated unit weight of the soil sample (lb/ft^3 ) if the unit weight of water is 62.35 lb/ft^3

In: Civil Engineering

can you descibe in detail the different temporary structure used for the replacement of Kenneth f...

can you descibe in detail the different temporary structure used for the replacement of Kenneth f burns bridge in Massachussets (usa)? and how they implement them?

In: Civil Engineering

Denitrification is commonly accomplished as a separate process after carbonaceous BOD removal. An alternative is to...

Denitrification is commonly accomplished as a separate process after carbonaceous BOD removal. An alternative is to recycle mixed liquor to an anaerobic stage at the head end of the aeration tank. What potential advantage does the alternative offer? Explain.

In: Civil Engineering

introduction about Types of Parking and parking regulations

introduction about Types of Parking and parking regulations

In: Civil Engineering

Write an essay about surface runoff generation defining the process descriptively and quantitatively, discuss it’s behavior...

Write an essay about surface runoff generation defining the process descriptively and quantitatively, discuss it’s behavior in cold regions and it’s importance to hydrology

In: Civil Engineering

(a) What is the chemical form of most nitrogen as it arrives at a wastewater treatment...

(a) What is the chemical form of most nitrogen as it arrives at a wastewater treatment plant? (b) What are the main chemical forms of nitrogen relevant to wastewater and its treatment? Show these in a simple nitrogen cycle.

In: Civil Engineering

you are a client asked an architect to design a villa for yourself. You as a...

you are a client asked an architect to design a villa for yourself. You as a client didn’t ask for fees. The architect finished design and tried to collect the fees, and you were reasonable thinking that the fees will be around $3000. Since, this was paid for similar villa design of your friend. The architect argued that the fees should be $5000, discuss the possible action by judge if architect sued you and explain why?     

In: Civil Engineering

1. Explain the effect of S.S.A of all-in aggregates and NMS of aggregates on the conpressive...

1. Explain the effect of S.S.A of all-in aggregates and NMS of aggregates on the conpressive strength of concrete.

2. At a given water-cement ratio, either a change in the cement content or aggregate grading can be made to increase the consistency of a concrete mixture. Which one of the two options would you recommend ? Why is it not desirable to produce concrete mixture of a higher consitency than neccessary ?

In: Civil Engineering

The velocity field of a permanent, incompressible and isothermal flow is given by u = a...

The velocity field of a permanent, incompressible and isothermal flow is given by

u = a (x^2 - y^2)   (1)
v = −2axy   (2)
w = 0    (3)

Gravitational acceleration acts on the z axis only.

a) Write the Navier-Stokes equations for this flow, canceling the appropriate terms
and replacing the non-zero derivatives with their detailed expression. Be sure to indicate
clearly your assumptions. (4 points)

b) From the result obtained in (a), demonstrate that the pressure field is continuous and therefore
physically possible (2 points)

c) Get the expression for the flow pressure field (4 points)

In: Civil Engineering

Design a community drainage system for 20O people

Design a community drainage system for 20O people

In: Civil Engineering

In the Rational Method the peak runoff resulting from a rainfall event depends on which of...

  1. In the Rational Method the peak runoff resulting from a rainfall event depends on which of the following factors

  1. The frequency and duration of the rainfall event.
  2. The size of the area on which the rainfall lands.
  3. The characteristics of the surface over which the rainwater flows.
  4. The time that has elapsed since the last rainfall event.

  1. I, II, III and IV.
  2. I, II and III only.
  3. I and III only.
  4. II and III only.
  1. Which of the following are assumptions of the Rational Method?

  1. Peak flow occurs when the entire watershed is contributing to the flow.
  2. Rainfall intensity is the same over the entire drainage area.
  3. Rainfall intensity is uniform over a time duration equal to the time of concentration.
  4. Frequency of the computed peak flow is the same as that of the rainfall intensity.

  1. I, II, III and IV.
  2. I, II, and III only.
  3. I and III only.
  4. II and IV only.

In: Civil Engineering

What are the detailed tasks of each of the following traffic areas to complete the transport/traffic...

What are the detailed tasks of each of the following traffic areas to complete the transport/traffic part of the project??

Please provide all the breakdown of the tasks which are required to perform in the following areas to complete the project:

I. traffic generation

II. traffic distribution

III. Traffic simulation

III. Mode distribution


What are the tasks breakdown of Traffic generation?


What are the tasks breakdown of Traffic distribution?


What are the tasks breakdown of Mode distribution ?


What are the tasks breakdown of Traffic simulation?


Please provide the answer of all the parts in detail.

In: Civil Engineering

Why did king Henry VIII of England break with the Roman Catholic Church? Make sure to...

Why did king Henry VIII of England break with the Roman Catholic Church? Make sure to also list and explain the legislations that were approved under Henry VIII by the English Parliament that officially split the Church of England from the Catholic Church. Under Henry, was the Church of England dramatically different from the Roman Catholic Church?

Source:   https://ilearn.laccd.edu/courses/69580/files/5834351/download?wrap=1

Five-paragraph specific and thoughtful response to prompt.

In: Civil Engineering

Discuss the effects of carbon content on the properties of steel. What is the percentage of...

Discuss the effects of carbon content on the properties of steel. What is the percentage of carbon content recommended for structural steel? (1 mark)






Give one situation where you would consider using fiber reinforced concrete instead of normal reinforced concrete. (1 mark)

In: Civil Engineering