Question
In: Mechanical Engineering
a.) What is the thermal efficiency of a steam power plant operating on the Rankine cycle...
a.) What is the thermal efficiency of a steam power plant
operating on the Rankine cycle if saturated steam is supplied to
the turbine at 1000 psia, and the condenser is at 1 psia. Use a
turbine efficiency of 95% and a pump efficiency of 85%. Refer to
Chapter 9, Sections 10-11, as necessary.
b.) Determine the thermal efficiency if the steam is superheated to
1000 F, assuming all else equal.
Solutions
samet mamat answered 2 years agoRelated Solutions
Consider a steam power plant operating on a simple ideal Rankine cycle in which the steam...
Consider a steam power plant operating on a simple ideal Rankine
cycle in which the steam enters the turbine at 3 MPa and 350C and
is condensed in the condenser at 75 kPa. Determine the thermal
efficiency of this cycle and sketch an appropriately labeled T-s
diagram. Also compare this thermal efficiency to that a Carnot heat
engine operating between these same two limits.
The change in enthalpy across the pump = work done by the pump:
h2-h1= v1(P2– P1)
The net power of a steam power plant operating according to the simple ideal Rankine cycle...
The net power of a steam power plant operating according to the
simple ideal Rankine cycle is 30.5 MW. Water vapor enters the
turbine at 7 MPa pressure and 500 ° C, expands to 10 kPa condenser
pressure in the turbine. The steam is condensed in the condenser by
cooling it with water from a lake. The flow rate of the lake water
is 1950 kg / h. Get the pump and turbine adiabatic efficiency of
87%. Show the cycle...
Consider a steam power plant operating on the simple ideal Rankine cycle. Steam enters the turbine...
Consider a steam power plant operating on the simple ideal
Rankine cycle. Steam enters the turbine at 15 MPa and 600°C. The
steam condenses in the condenser at 10 kPa. Use the EES software to
study the effects of the following cases on the cycle performance
and to sketch the T-s diagram for each case:
Plot the variation of the cycle thermal efficiency with the
turbine isentropic efficiency. Take the isentropic efficiency of
the turbine in the range 70% to...
Consider a steam power plant operating on the simple ideal Rankine cycle. Steam enters the turbine...
Consider a steam power plant operating on the simple ideal
Rankine cycle. Steam enters the turbine at 15 MPa and 600°C. The
steam condenses in the condenser at 10 kPa. Use the EES software to
study the effects of the following cases on the cycle performance
and to sketch the T-s diagram for each case:
#Plot the variation of the cycle thermal efficiency with the
turbine isentropic efficiency. Take the isentropic efficiency of
the turbine in the range 70% to...
Consider a steam power plant operating on the ideal reheat Rankine cycle. Steam enters the high-pressure...
Consider a steam power plant operating on the ideal reheat
Rankine cycle. Steam enters the high-pressure turbine at
PH MPa and
TH °C and is condensed in the
condenser at a pressure of PL
kPa. Assume the steam is reheated to the inlet
temperature of the high-pressure turbine, and that pump work is NOT
negligible. If the moisture content of the steam at the exit of the
low-pressure turbine is not to exceed
w% percent, determine:
(a) the pressure at...
Ideal Reheat Steam Cycle (10) Consider a steam power plant operating on the ideal reheat Rankine...
Ideal Reheat Steam Cycle (10)
Consider a steam power plant operating on the ideal
reheat Rankine cycle. Steam enters the high-pressure turbine at PH
MPa and TH °C and is condensed in the condenser at a pressure of PL
kPa. Assume the steam is reheated to the inlet temperature of the
high-pressure turbine, and that pump work is NOT negligible. If the
moisture content of the steam at the exit of the low-pressure
turbine is not to exceed w% percent,...
Consider a steam power plant operating on a simple ideal Rankine cycle and having a net...
Consider a steam power plant operating on a simple ideal
Rankine cycle and having a net power output of 57 MW. The steam
enters the turbine at 9 MPa and 575 ° C and exits at 150 ° C, then
it is cooled in the condenser to a pressure of 100 kPa by means of
the cooling water from a lake and that circulates through the
condenser tubes to a rate of 1370 kg / s. Consider leaving the pump...
A steam power plant operates on a practical Rankine Cycle. The steam enters the turbine at...
A steam power plant operates on a practical Rankine Cycle. The
steam enters the turbine at 3 MPa and “648” K and is condensed in
the condenser at a pressure of 46 kPa. You are assigned on a
project to improve the thermal efficiency of this plant. a) Draw
the schematic of the plant and determine the thermal efficiency of
the practical cycle assuming that the efficiencies of pump and
turbine are 0.75 and 0.7, respectively. ( b) Draw a...
Question 2: In a steam power plant operating according to the ideal intermediate superheated Rankine cycle,...
Question 2: In a steam power plant operating
according to the ideal intermediate superheated Rankine cycle,
water vapor enters the high pressure turbine at 8 MPa pressure and
500 oC temperature and expands to 3 MPa pressure. Then,
the steam is re-heated to a temperature of 500 oC in the
boiler and expands to 20 kPa condenser pressure in the low pressure
turbine.
I. Show the cycle in the T-s diagram and explain for what
purpose intermediate superheating is done....
1. The thermal efficiency of a Rankine power cycle may be improved by i. Superheating the...
1. The thermal efficiency of a Rankine power cycle may be
improved by i. Superheating the steam ii. Reheating the steam
between high and lower pressure sections of the turbine iii.
Regenerative Feedwater Heating iv. Insulating the turbine and
decreasing the entropy production during the expansion process v.
Incorporating a Rankine cycle power system as part of a
cogeneration system a. Items i), ii), and iv) only b. Items i),
iii), and v) only c. Items ii), iv) and v)...
ADVERTISEMENT
ADVERTISEMENT
Latest Questions
- JAVASCRIPT: Please create an array of student names and another array of student grades. - Create...
- Topic - Construction: Structural, loads, tension 1.) Explain why pure tension members are the most efficient...
- Procter and Gamble (PG) paid an annual dividend of $ 1.62$1.62 in 2009. You expect PG...
- locate a recent case of online child pornography. Write a summary of the incident and describe...
- #Python 5. Write function called evaluate() that evaluates the following Python expressions or assignments as specified:...
- Suggest journal, research paper link reference. i need this as reference for writing a research with...
- Cryptography is used heavily in internet communications. True or false? Explain
ADVERTISEMENT