Question
In: Mechanical Engineering
Consider a steam power plant operating on the ideal reheat Rankine cycle. Steam enters the high-pressure...
Consider a steam power plant operating on the ideal reheat Rankine cycle. Steam enters the high-pressure turbine at PH MPa and TH °C and is condensed in the condenser at a pressure of PL kPa. Assume the steam is reheated to the inlet temperature of the high-pressure turbine, and that pump work is NOT negligible. If the moisture content of the steam at the exit of the low-pressure turbine is not to exceed w% percent, determine:
(a) the pressure at which the steam should be reheated ,
(b) the total turbine work ,
(c) the net work ,
(d) the total heat input , and
(e) the thermal efficiency of the cycle .
PH = 17.5 MPa, TH = 600 °C, PL = 15 kPa and w% = 9.9%.
Solutions
samet mamat answered 1 year agoRelated Solutions
Ideal Reheat Steam Cycle (10) Consider a steam power plant operating on the ideal reheat Rankine...
Ideal Reheat Steam Cycle (10)
Consider a steam power plant operating on the ideal
reheat Rankine cycle. Steam enters the high-pressure turbine at PH
MPa and TH °C and is condensed in the condenser at a pressure of PL
kPa. Assume the steam is reheated to the inlet temperature of the
high-pressure turbine, and that pump work is NOT negligible. If the
moisture content of the steam at the exit of the low-pressure
turbine is not to exceed w% percent,...
Consider a steam power plant operating on the simple ideal Rankine cycle. Steam enters the turbine...
Consider a steam power plant operating on the simple ideal
Rankine cycle. Steam enters the turbine at 15 MPa and 600°C. The
steam condenses in the condenser at 10 kPa. Use the EES software to
study the effects of the following cases on the cycle performance
and to sketch the T-s diagram for each case:
Plot the variation of the cycle thermal efficiency with the
turbine isentropic efficiency. Take the isentropic efficiency of
the turbine in the range 70% to...
Consider a steam power plant operating on the simple ideal Rankine cycle. Steam enters the turbine...
Consider a steam power plant operating on the simple ideal
Rankine cycle. Steam enters the turbine at 15 MPa and 600°C. The
steam condenses in the condenser at 10 kPa. Use the EES software to
study the effects of the following cases on the cycle performance
and to sketch the T-s diagram for each case:
#Plot the variation of the cycle thermal efficiency with the
turbine isentropic efficiency. Take the isentropic efficiency of
the turbine in the range 70% to...
Steam enters the high-pressure turbine of a steam power plant that operates on the ideal reheat...
Steam enters the high-pressure turbine of a steam power plant
that operates on the ideal reheat Rankine cycle at 6 MPa and 500°C
and leaves as saturated vapor. Steam is then reheated to 400°C
before it expands to a pressure of 10 kPa. Heat is transferred to
the steam in the boiler at a rate of 6*104 kW. Steam is
cooled in the condenser by the cooling water from a nearby river,
which enters the condenser at 7°C. Show the...
Consider a steam power plant operating on a simple ideal Rankine cycle in which the steam...
Consider a steam power plant operating on a simple ideal Rankine
cycle in which the steam enters the turbine at 3 MPa and 350C and
is condensed in the condenser at 75 kPa. Determine the thermal
efficiency of this cycle and sketch an appropriately labeled T-s
diagram. Also compare this thermal efficiency to that a Carnot heat
engine operating between these same two limits.
The change in enthalpy across the pump = work done by the pump:
h2-h1= v1(P2– P1)
Steam is the working fluid in an ideal Rankine cycle with superheat and reheat. Steam enters...
Steam is the working fluid in an ideal Rankine cycle with
superheat and reheat. Steam
enters the high-pressure turbine at 8.0MPa, 480̊C, and expands to
0.6MPa. It is then reheatedto 450̊C before entering the
low-pressure turbine where it expands to the condenser pressure of
10kPa. The net power output is 110MW.
A closed feedwater heater (CFWH) which uses steam extracted fromthe
low-pressure turbine at 0.5MP. The extracted steam leaves the CFWH
as a saturated liquid and is then pumped up...
A proposed steam power plant design consists of an ideal Rankine cycle with reheat and regeneration....
A proposed steam power plant design consists of an ideal Rankine
cycle with reheat and regeneration. Steam enters Turbine 1 at P1
and T1 at the rate of m1 and exits at P2. A fraction (y') of the
steam exiting Turbine 1 is diverted to an open feedwater heater
while the remainder is reheated to T3 before entering Turbine 2.
The condenser operates at P4. Saturated liquid exits the condenser
and is fed to Pump 1. The outlet of Pump...
A steam power plant operates on the simple ideal rankine cycle. the steam enters the turbine...
A
steam power plant operates on the simple ideal rankine cycle. the
steam enters the turbine at 4 MPa and 500 C and leaves it at 50 kPa
and 150 C. the water leaves the condenser as a saturated liquid and
is subsequently displaced to the boiler by means of a pump at a
temperature of 85 C, which is the isentrophic efficiency of the
turbine?
Consider a steam power plant that operates on a reheat Rankine cycle and has a net...
Consider a steam power plant that operates on a reheat Rankine
cycle and has a net power output of 80 MW. Steam enters the
high-pressure turbine at 10 MPa and 500°C and the low-pressure
turbine at 1 MPa and 500°C. Steam leaves the condenser as a
saturated liquid at a pressure of 10 kPa. The isentropic efficiency
of the turbine is 78 percent and that of the pump is 95
percent.
a.)Determine the quality (or temperature, if superheated) of the...
Consider a steam power plant that operates on a reheat Rankine cycle and has a net...
Consider a steam power plant that operates on a reheat Rankine
cycle and has a net power output of 80 MW.
Steam enters the high-pressure turbine at 10 MPa and 500°C and the
low-pressure turbine at 1 MPa and 500°C. Steam leaves the condenser
as a saturated liquid at a pressure of 10 kPa. The isentropic
efficiency of the turbine is 80 percent, and that of the pump is 95
percent. Show the cycle on a T-s diagram with respect...
ADVERTISEMENT
ADVERTISEMENT
Latest Questions
- research paper: each student will be responsible for writing an argumentative research paper discussion a topic...
- In java based on the classes provided finish the program per the requirements: ----------------------------------------------Class1 package cardgame;...
- Identify two cultures and analyze the nurturing process within each culture and discuss the impact the...
- Digital security is an increasing concern is the Internet age. In order to protect sensitive information...
- the challenges experienced by companies considering full application of customer retention strategy in the face of...
- Respond to the following in a minimum of 175 words: The flow of a program is...
- Write a version of the binary search algorithm that can be used to search a string...
ADVERTISEMENT