Question
In: Physics
Question 2: In a steam power plant operating according to the ideal intermediate superheated Rankine cycle,...
Question 2: In a steam power plant operating according to the ideal intermediate superheated Rankine cycle, water vapor enters the high pressure turbine at 8 MPa pressure and 500 oC temperature and expands to 3 MPa pressure. Then, the steam is re-heated to a temperature of 500 oC in the boiler and expands to 20 kPa condenser pressure in the low pressure turbine.
I. Show the cycle in the T-s diagram and explain for what purpose intermediate superheating is done.
II. Calculate the total turbine work.
III. Calculate the thermal efficiency of the cycle.
Solutions
Expert Solution
Please rate
if any mistake in this answer please comment i will clarify your doubt . thank you
genius_generous answered 1 year agoRelated Solutions
The net power of a steam power plant operating according to the simple ideal Rankine cycle...
The net power of a steam power plant operating according to the
simple ideal Rankine cycle is 30.5 MW. Water vapor enters the
turbine at 7 MPa pressure and 500 ° C, expands to 10 kPa condenser
pressure in the turbine. The steam is condensed in the condenser by
cooling it with water from a lake. The flow rate of the lake water
is 1950 kg / h. Get the pump and turbine adiabatic efficiency of
87%. Show the cycle...
Consider a steam power plant operating on a simple ideal Rankine cycle in which the steam...
Consider a steam power plant operating on a simple ideal Rankine
cycle in which the steam enters the turbine at 3 MPa and 350C and
is condensed in the condenser at 75 kPa. Determine the thermal
efficiency of this cycle and sketch an appropriately labeled T-s
diagram. Also compare this thermal efficiency to that a Carnot heat
engine operating between these same two limits.
The change in enthalpy across the pump = work done by the pump:
h2-h1= v1(P2– P1)
Ideal Reheat Steam Cycle (10) Consider a steam power plant operating on the ideal reheat Rankine...
Ideal Reheat Steam Cycle (10)
Consider a steam power plant operating on the ideal
reheat Rankine cycle. Steam enters the high-pressure turbine at PH
MPa and TH °C and is condensed in the condenser at a pressure of PL
kPa. Assume the steam is reheated to the inlet temperature of the
high-pressure turbine, and that pump work is NOT negligible. If the
moisture content of the steam at the exit of the low-pressure
turbine is not to exceed w% percent,...
Consider a steam power plant operating on the simple ideal Rankine cycle. Steam enters the turbine...
Consider a steam power plant operating on the simple ideal
Rankine cycle. Steam enters the turbine at 15 MPa and 600°C. The
steam condenses in the condenser at 10 kPa. Use the EES software to
study the effects of the following cases on the cycle performance
and to sketch the T-s diagram for each case:
Plot the variation of the cycle thermal efficiency with the
turbine isentropic efficiency. Take the isentropic efficiency of
the turbine in the range 70% to...
Consider a steam power plant operating on the simple ideal Rankine cycle. Steam enters the turbine...
Consider a steam power plant operating on the simple ideal
Rankine cycle. Steam enters the turbine at 15 MPa and 600°C. The
steam condenses in the condenser at 10 kPa. Use the EES software to
study the effects of the following cases on the cycle performance
and to sketch the T-s diagram for each case:
#Plot the variation of the cycle thermal efficiency with the
turbine isentropic efficiency. Take the isentropic efficiency of
the turbine in the range 70% to...
Consider a steam power plant operating on a simple ideal Rankine cycle and having a net...
Consider a steam power plant operating on a simple ideal
Rankine cycle and having a net power output of 57 MW. The steam
enters the turbine at 9 MPa and 575 ° C and exits at 150 ° C, then
it is cooled in the condenser to a pressure of 100 kPa by means of
the cooling water from a lake and that circulates through the
condenser tubes to a rate of 1370 kg / s. Consider leaving the pump...
Consider a steam power plant operating on the ideal reheat Rankine cycle. Steam enters the high-pressure...
Consider a steam power plant operating on the ideal reheat
Rankine cycle. Steam enters the high-pressure turbine at
PH MPa and
TH °C and is condensed in the
condenser at a pressure of PL
kPa. Assume the steam is reheated to the inlet
temperature of the high-pressure turbine, and that pump work is NOT
negligible. If the moisture content of the steam at the exit of the
low-pressure turbine is not to exceed
w% percent, determine:
(a) the pressure at...
a steam power plant operates on a superheated rankine cycle where steam at 10kg/s entering the...
a steam power plant operates on a superheated rankine cycle
where steam at 10kg/s entering the turbine at 5MPa and 375 degree
celcius and leaving the turbine at saturated vapor at pressure 100
times less then initial. If the compressor efficiency is 85% ,
I) sketch the cycle of T-s diagram
ii) calculate the temperature and pressure for all points in the
cycle
iii) calculate the compressor work
iv) calculate the turbine work and turbine efficiency
v.) calculate the thermal...
Design a steam power plant that works as an ideal Regenerative Rankine cycle with 2 closed...
Design a steam power plant that works as an ideal Regenerative
Rankine cycle with 2 closed feedwater heaters cascaded backwards by
selecting their extraction pressures to optimize cycle efficiency.
The available steam conditions at the exit of the boiler are 3 MPa
and 590 °C and the condenser pressure is 20 kPa. The steam flow
rate at the inlet of the turbine is 80 kg/s. A T-s diagram for the
cycle should be provided along with a table showing the...
A steam power plant operates on the simple ideal rankine cycle. the steam enters the turbine...
A
steam power plant operates on the simple ideal rankine cycle. the
steam enters the turbine at 4 MPa and 500 C and leaves it at 50 kPa
and 150 C. the water leaves the condenser as a saturated liquid and
is subsequently displaced to the boiler by means of a pump at a
temperature of 85 C, which is the isentrophic efficiency of the
turbine?
ADVERTISEMENT
ADVERTISEMENT
Latest Questions
- #Python 5. Write function called evaluate() that evaluates the following Python expressions or assignments as specified:...
- Suggest journal, research paper link reference. i need this as reference for writing a research with...
- Cryptography is used heavily in internet communications. True or false? Explain
- Suppose Rialto is the only movie cinema in a small college town, so it is essentially...
- With VMI, members of the supply chain share planning, demand, forecasting, and inventory information.
- Large lots are desirable in supply chain coordination despite increasing holding costs.
- ***Convert the C++ to Python*** #include <iostream> using std::cout; using std::cin; using std::endl; int charClass; char...
ADVERTISEMENT