a copper plate .25m in diameter at 150C is to be cooled on one side, in...

a copper plate .25m in diameter at 150C is to be cooled on one side, in air with ambient temprature of 25C and h=30W/m^2k, by attaching 30 copper pin fins each 0.02m diameter and 6cm long. to the surface.calculate overall heat transfer rate and overall effectiveness

Expert Solution

samet mamat answered 2 years ago

A hot plate with a temperature of 60 ° C will be cooled by adding 50...

A hot plate with a temperature of 60 ° C will be cooled by adding 50 triangular profile needle blades k = 209 W / mK with a length of 59 mm and 10 mm. The ambient temperature is 20 C and the heat transfer coefficient on the surface is 20 W / m2K according to the situation; a-) Wing efficiency, b-) Total heat transfer rate (W) from the wings, c-) Calculate the effectiveness of a wing.

How much 1.0 mm diameter copper wire would it take to equal the resistance of one...

How much 1.0 mm diameter copper wire would it take to equal the resistance of one 100 Ω resistor? The resistivity of copper is 1.68*10-8 Ωm b) What would be the current if this wire was connected to a 12.0 V battery? c) How many electrons per second pass by a point on the wire? d) If this wire was coiled up and submerged in 100 mL of water at 20oC, how long would it take for the water to...

A Copper plate that is 588mm wide and 48 mm thick is to be reduced in...

A Copper plate that is 588mm wide and 48 mm thick is to be reduced in a single pass in a two high rolling mill by using a 321mm diameter roll. The coefficient of friction at roll workpiece interface is 0.14 and the roll rotates at 107rpm. The rolling process is performed above the recrystallization temperature of the material and the width of the plate does not change during this operation. What is the minimum final thickness (mm) possible

A hot silver plate is having its upper surface cooled by air forced convection of 15...

A hot silver plate is having its upper surface cooled by air forced convection of 15 °C with heat transfer coefficient of 220 W/m.K. The 10-cm thick plate (mass density ρ=8530 kg/m3, Cp=380J/kg.K, k=110 W/m.K, and α=33.9×10-6 m2/s) has a uniform initial temperature of 650 °C, and the bottom surface of the plate is insulated. (a) calculate the Bi number and determine whether the lumped capacitance method can be used. (2 points) (b) Determine the temperature at the center plane...

A hollow cube of copper that is 23.36cm on a side and 2.4mm thick is placed...

A hollow cube of copper that is 23.36cm on a side and 2.4mm thick is placed next to a small solid ball of plutonium-239. Its so small that it does not explode (criticallity), having a mass of only 23.78g. It is slightly warm to the touch (due to nuclear decay...alpha particles heat the skin). (a) How many copper atoms are there making up the cube? (b) What is the mass of the copper? (c) What is diameter of the ball...

A 0.500 mm diameter copper wire makes up a 136 turns, 7.60 cm diameter coil. There...

A 0.500 mm diameter copper wire makes up a 136 turns, 7.60 cm diameter coil. There is a magnetic field parallel to the axis of the coil. If the induced current in the coil is 2.80 A, what is the rate of change of the magnetic field? a) 0.0839 T/s b) 3.63×10-6 T/s c) 12.8 T/s d) 1.74×103 T/s

A thin, flat plate that is 0.2 m × 0.2 m on a side is oriented...

A thin, flat plate that is 0.2 m × 0.2 m on a side is oriented parallel to an atmospheric airstream having a velocity of 40 m/s. The air is at a temperature of ∞T∞= 20ºC, while the plate is maintained at Ts= 120ºC. The air flows over the top and bottom surfaces of the plate, and measurement of the drag force reveals a value of 0.075 N. What is the rate of heat transfer from both sides of the...

Steel plate is in contact with copper. give the schematic electrochemical corrosion in neutral and acidic...

Steel plate is in contact with copper. give the schematic electrochemical corrosion in neutral and acidic meduims and write the equations for the reactions that occur. Please write the equations for the reactions, not just the schematic

How long will it take to plate 1.25 grams of Copper metal from a solution of...

How long will it take to plate 1.25 grams of Copper metal from a solution of CuSO4, if a current of 2.0 A is used? Assume 100% efficiency.

1-What is the resistance of a 5km long copper wire with a diameter of 4mm? a....

1-What is the resistance of a 5km long copper wire with a diameter of 4mm? a. 1.65 ohms b. 0.0015 ohms c. .0065 ohms d. 6.7 ohms 2- three 4mF capacitor are connected in series across a 12 V battery. The total charges stored by this compination of capacitor is A. 24 mC B. 16 mC C. 48 mC D. 144 mC E. None of the above 3. What would be the energy stored in the capacitor in the previous...

Question