A thin, flat plate that is 0.2 m × 0.2 m on a side is oriented...

A thin, flat plate that is 0.2 m × 0.2 m on a side is oriented parallel to an atmospheric airstream having a velocity of 40 m/s. The air is at a temperature of ∞T∞= 20ºC, while the plate is maintained at Ts= 120ºC. The air flows over the top and bottom surfaces of the plate, and measurement of the drag force reveals a value of 0.075 N. What is the rate of heat transfer from both sides of the plate to the air?

Expert Solution

samet mamat answered 2 years ago

Sketch a 5 kg thin flat uniform homogeneous square plate of side 600 mm, with a...

Sketch a 5 kg thin flat uniform homogeneous square plate of side 600 mm, with a circular opening of radius 100 mm. Determine the area and the mass moments of inertia about the center of mass.

A thin airfoil can be approximated as a flat plate. The airfoil is set at an...

A thin airfoil can be approximated as a flat plate. The airfoil is set at an angle of 10° to an air flow with Mach 2, a temperature of –50°C, and a pressure of 50 kPa. Using linearized theory, find the pressures on the upper and lower surfaces of this wing.

Air at 15°C flows at 9 m/s parallel to a thin flat plate measuring 260 mm...

Air at 15°C flows at 9 m/s parallel to a thin flat plate measuring 260 mm × 390 mm. The direction of flow is parallel to the 260-mm edges. The surface of the plate is at a uniform temperature of 85°C. The plate is in a large chamber with walls at a temperature of 22°C. The emissivity of the plate’s surfaces is 0·75. (a) Determine the rate of convective heat transfer from one side of the plate to air. [16]...

A flat square sheet of thin aluminum foil, 30 cm on a side, carries a uniformly...

A flat square sheet of thin aluminum foil, 30 cm on a side, carries a uniformly distributed 285 nC charge. Part A What, approximately, is the electric field 1.0 cm above the center of the sheet? Express your answer using two significant figures. What, approximately, is the electric field 20 mm above the center of the sheet? Express your answer using two significant figures.

A uniform thin film of alcohol (n=1.36) lies on a flat glass plate (n=1.56). When monochromatic...

A uniform thin film of alcohol (n=1.36) lies on a flat glass plate (n=1.56). When monochromatic light, whose wavelength can be changed, is incident normally, the reflected light is a minimum for ?=515nm and a maximum for ?=644nm. What is the minimum thickness of the film? tmin = .....?..... nm

A thin rod (length = 1.85 m) is oriented vertically, with its bottom end attached to...

A thin rod (length = 1.85 m) is oriented vertically, with its bottom end attached to the floor by means of a frictionless hinge. The mass of the rod may be ignored, compared to the mass of the object fixed to the top of the rod. The rod, starting from rest, tips over and rotates downward. (a) What is the angular speed of the rod just before it strikes the floor? (Hint: Consider using the principle of conservation of mechanical...

When the flat open side of a charged coil was brought near the flat open side...

When the flat open side of a charged coil was brought near the flat open side of the coil connected to a galvanometer (both coils parallel to each other), the galvanometer deflects very little. How do you know they need to be parallel and why is this the case? Where is north and south if the coil is acting like a bar magnet?

Heat Q5 A vertical flat plate (1.5 m) height and (1 m) width ,with uniform temperature...

Heat Q5 A vertical flat plate (1.5 m) height and (1 m) width ,with uniform temperature (120 oC) one face of this plate expressed to the air with the velocity (6 m/s) to the up direction, the second face expressed to the static air ,the temperature of the air with two side (30oC) . Calculate the heat losses from the plate. The properties of the air at (75 oC),[ ρ=0.998 kg/m3 .Cp=1.009 kJ/kg.oC, υ =2.076 *10-5 m 2 /s ,...

A liquid flows tangentially past a flat plate of dimensions total length of 4 m (parallel...

A liquid flows tangentially past a flat plate of dimensions total length of 4 m (parallel to the flow direction) and width of 1.5 m. fluid velocity is 1 m/s (length wise). What is the skin friction drag (shear force) on both sides of the plate? liquid density = 1000 kg/m3, dynamic viscosity = 2 x 10-2 N*s/m2.

Consider a flat plate with parallel airflow (top and bottom) characterized by u∞ 5 m/s, T∞...

Consider a flat plate with parallel airflow (top and bottom) characterized by u∞ 5 m/s, T∞ 20°C. Determine the average convection heat transfer coefficient, convective heat transfer rate, and drag force associated with an 2.8-m-long, 2.8-m wide flat plate with a surface temperature of 50°C. Assume the critical Reynolds number is 5x105. Determine the average convection heat transfer coefficient, in W/m2·K. Determine the convective heat transfer rate, in W. Determine the drag force, in N.

Question