Question

In: Mechanical Engineering

. A steam main (outside diameter of 16.8 cm and inside diameter of 15.4 cm) is...

. A steam main (outside diameter of 16.8 cm and inside diameter of 15.4 cm) is covered with 5-cm of high temperature insulation (k = 0.095 W/m. K) and 3.8 cm of lower temperature insulation (k = 0.07W/m. K). Calculate the heat loss from 150 m pipe assuming that inner and outer surface temperatures of the insulation are 450 and 30 °C, respectively. Also determine the temperature at the interface between two layers of insulation (10 points).

Solutions

Expert Solution


Related Solutions

A cylindrical soil sample, 7.3 cm in diameter and 16.8 cm in height, is tested in...
A cylindrical soil sample, 7.3 cm in diameter and 16.8 cm in height, is tested in a constant-head permeability apparatus. A constant head of 75 cm is maintained during the test. After 1 minute of testing, a total of 945.7 gm of water was collected. The temperature was 20 oC. The void ratio of the soil was 0.43. Calculate the following: The hydraulic gradient The flow rate The discharge velocity The seepage force per unit volume The coefficient of permeability
The propeller shaft of a large ship has an outside diameter of 350 mm and inside...
The propeller shaft of a large ship has an outside diameter of 350 mm and inside diameter 250mm. the shaft is rated for a maximum of shear stress 62 MPa. 1) if the shaft is runnning at 500 rpm what is the maximum power that can be transmitted without exceeding allowable stress. 2) if the rotational speed of the shaft is doubled but the power requirements unchanged what happens to the shear stress in the shaft? calculate valures.
a- Water enters a house through a pipe with inside diameter of 3.0 cm at an...
a- Water enters a house through a pipe with inside diameter of 3.0 cm at an absolute pressure of 5.0 X 105 Pa. A 1.5 cm diameter pipe leads to the second-floor bathroom 6.0 m above. When the flow speed at the inlet pipe is 2.0 m/s find: - Flow speed (velocity) of the water in the bathroom - Pressure water in the bathroom? - Calculate the volume flow rate in the bathroom.
The inside diameter of a piston ring is normally distributed with a mean of 10 cm...
The inside diameter of a piston ring is normally distributed with a mean of 10 cm and a standard deviation of 0.04 cm. What is the probability that a piston ring will have an inside diameter less than 10.075 cm? What is the probability that a piston ring will have an inside diameter between 9.94 and 10.045 cm? What proportion of rings will have inside diameters exceeding 10.066 cm? Suppose that five piston rings are randomly selected. What is the...
A fire hose has an inside diameter of 6.40 cm. Suppose such a hose carries a...
A fire hose has an inside diameter of 6.40 cm. Suppose such a hose carries a flow of 40.0 L/s starting at a gauge pressure of 1.62×106N/m2 . The hose goes 10.0 m up a ladder to a nozzle having an inside diameter of 3.00 cm. Calculate the Reynolds numbers for flow in the fire hose and nozzle to show that the flow in each must be turbulent.
The outside diameter of the playing area of an optical Blu-ray disc is 11.75 cm, and...
The outside diameter of the playing area of an optical Blu-ray disc is 11.75 cm, and the inside diameter is 4.50 cm. When viewing movies, the disc rotates so that a laser maintains a constant linear speed relative to the disc of 6.70 m/s as it tracks over the playing area. What is the average angular acceleration of a Blu-ray disc as it plays an 3.5-h set of movies? (Assume the disk is scanned starting at its inner radius moving...
Cold water inside / outside diameter in the same axis two pipe heat exchanger used as...
Cold water inside / outside diameter in the same axis two pipe heat exchanger used as engine oil cooler It enters the 25/30 mm steel pipe at a temperature of 15 degrees at a speed of 0.5 m / s, Take off at a temperature of 25 degrees.Hot oil, on the inside / outside diameter of 40/46 mm steel pipe, at a temperature of 60 degrees with a speed of 0.25 m / s. enters.it is desired to cool the...
A neon sign is made of glass tubing whose inside diameter is 2.5 cm and whose...
A neon sign is made of glass tubing whose inside diameter is 2.5 cm and whose length is 5.5 m. If the sign contains neon at a pressure of 1.73 torr at 37 ∘C, how many grams of neon are in the sign? (The volume of a cylinder is πr2h.) Express your answer using two significant figures.
9. A stainless steel tube having an outside diameter of 0.6 cm and a wall thickness...
9. A stainless steel tube having an outside diameter of 0.6 cm and a wall thickness of 0.05 cm is to be insulated with a material having a thermal conductivity of 0.065 W/mK. If the inner and outer convective heat transfer coefficients are 5.9 W/m2K. what will be the heat loss per meter of length for insulation thicknesses of 0, 0.25, 0.5, 0.75, 1.00, and 1.25 cm if the inside temperature is 95 C and the outside temperature is 10...
Steam enters a horizontal 15-cm-diameter pipe as a saturated vapor at 5 bar with a velocity...
Steam enters a horizontal 15-cm-diameter pipe as a saturated vapor at 5 bar with a velocity of 10 m/s and exits at 4.5 bar with a quality of 95%. Heat transfer from the pipe to the surroundings at 300K takes place at an average outer surface temperature of 400 K. For operation at steady state, determine (a) the velocity at the exit, in m/s. (b) the rate of heat transfer from the pipe, in kW. (c) the rate of entropy...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT