Question

In: Chemistry

A lagoon with volume of 1200 m3 has been receiving a steady flow of a conservative...

A lagoon with volume of 1200 m3 has been receiving a steady flow of a conservative (inert) waste at a rate of 100 m3 /day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10 mg/L.

a) What would be the concentration of pollutant in the effluent leaving the lagoon?

b) If the input waste concentration suddenly increased to 100 mg/L, what would the concentration in the effluent be 7 days later?

Solutions

Expert Solution


Related Solutions

A CM basin with a volume of 475 m3 receives a flow of 2000 m3 d−1....
A CM basin with a volume of 475 m3 receives a flow of 2000 m3 d−1. The basin has a dead volume of 42 m3. Find the effluent tracer curve if a mass of 5 g of tracer is added instantaneously to the influent. Also plot the effluent tracer curve for the reactor without dead volume.
Water flows in a horizontal pipeline at a steady flow rate of 0.03 m3 s-1. The...
Water flows in a horizontal pipeline at a steady flow rate of 0.03 m3 s-1. The pipeline terminates with a reducing bend that deflects the water upwards at an angle of 45 degrees, as shown in Figure QB2. The water issues into the atmosphere. The area of the pipe is 150 x 10-4 m2 and the area at the exit to the bend is 25 x 10-4 m2. The gauge pressure at the inlet to the bend is 73.9 kN...
Volume of an activated sludge tank 12. The total design flow is 15,000 m3/day. The NPDES...
Volume of an activated sludge tank 12. The total design flow is 15,000 m3/day. The NPDES limit is 25/30. Assume that the waste strength is 170 mg/L BOD after primary clarification. Y = 0.55 kg/kg, X=MLSS = 2200 mg/L, XR = 6,600 mg/L, Recycle (R) = 0.25, kd = 0.05 day -1, qc = 8 days Make whatever other assumptions are needed. The volume the tank in m3 will be?
A container has 9.0 ml of liquid X with a density of 1200 kg/m3. How much...
A container has 9.0 ml of liquid X with a density of 1200 kg/m3. How much liquid Y with a density of 1400 kg/m3 should be added to the flask so that the density of the liquid mixture is 1280 kg/m3?
A physics lecture room has a volume of 237 m3. (a) For a gas pressure of...
A physics lecture room has a volume of 237 m3. (a) For a gas pressure of 1.00 atm and a temperature of 26.0 oC, use the ideal gas law to estimate the number of air molecules in the room. Assume all the air is N2. (b) Calculate the particle density ❝ that is, the number of N2 molecules per cubic centimeter. (c) Calculate the mass of the air in the room.
A helium-filled balloon has a volume of 0.010 m3. The temperature in the room and in...
A helium-filled balloon has a volume of 0.010 m3. The temperature in the room and in the balloon is 20 C What are the average speed of a particle of helium inside the balloon? What is the thermal energy of the helium in the balloon? Assume that due to stretching of the balloon the pressure inside it is 1.1 atm.
There has been a transition from receiving communications primarily in the mail to receiving them electronically...
There has been a transition from receiving communications primarily in the mail to receiving them electronically in the form of emails and advertisements on the web. The real question to consider is what are the most effective tools? In your initial post, discuss what you believe to be the most effective marketing tools for health and wellness initiatives and why.
A hot air balloon has a volume 3,223 m3 . It is filled with hot air...
A hot air balloon has a volume 3,223 m3 . It is filled with hot air of density 0.96 kg/m 3 . The total mass of cabin, envelope etc is 350 kg. Find the maximum load of the balloon in Newtons if the density of surrounding air is 1.29kg/ m3 Use g = 9.8 m/s2 Calculate answer to one decimal.
A cylinder fitted with a piston has an initial volume of 0.1 m3 and contains nitrogen...
A cylinder fitted with a piston has an initial volume of 0.1 m3 and contains nitrogen at 150 kPa, 25 0C. The piston is moved, compressing the nitrogen until the pressure is 1 MPa and the temperature is 150 0C. During this compression process heat is transferred from the nitrogen, and the work done on the nitrogen is 20 kJ. Determine the amount of this heat transfer.
A 52 year-old woman has been diagnosed with leukemia and has been receiving chemotherapy as an...
A 52 year-old woman has been diagnosed with leukemia and has been receiving chemotherapy as an outpatient. She tells the RN that she hasn’t been feeling well. The patient’s skin is warm to touch and she has a low-grade fever of 100.2 F. The neutrophil blood count is less than 1000/ul. The nurse is concerned about the possibility of infection, why? What is the diagnosis? How would you treat this patient?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT