Question

In: Physics

You have a wire of length L = 1.7 m for making a square coil of...

You have a wire of length L = 1.7 m for making a square coil of a dc motor. The current in the coil is I = 0.8 A, and the magnetic field of the motor has a magnitude of B = 0.31 T. Find the maximum torque exerted on the coil when the wire is used to make (a) a single-turn square coil and (b) a two-turn square coil.

Solutions

Expert Solution

Torque on a current carrying loop

Maximum torque is applied when are perpendicular to each other

a) When the wire is used to make one square loop,

side of square

             

             

b) When the wire is used to make two square loops,

side of square

  

             

             


Related Solutions

Suppose you have a wire of length L. You cut a length x to make a square and use the remaining
Suppose you have a wire of length L. You cut a length x to make a square and use the remaining length L - x to make a circle. Use MuPAD to find the length x that maximizes the sum of the areas enclosed by the square and the circle.
A square coil of thin wire with 4 turns and side-length 3 cm sits inside an...
A square coil of thin wire with 4 turns and side-length 3 cm sits inside an ideal solenoid.  The axis of the solenoid is along +k, but the axis of the coil is tilted at a fixed unknown angle θ from the +z-axis.  The solenoid has n = 5000 turns/meter, and carries current I(t) = 5t3– 4t2+ t + 5 [units of Amperes with t given in seconds] counterclockwise.  The wire of the coil has cross-sectional area A = 50 μm2, and the...
A coil is wrapped with 291 turns of wire on the perimeter of a square frame...
A coil is wrapped with 291 turns of wire on the perimeter of a square frame of sides 25.3 cm. Each turn has the same area, equal to that of the frame, and the total resistance of the coil is 2.05 Ohm. A uniform magnetic field is turned on perpendicular to the plane of the coil. If the field changes linearly from 0 to -0.0491 Wb/m2 in a time of 1.07 s, find the magnitude of the induced emf in...
A square coil of wire of side 3.00 cm is placed in a uniform magnetic field...
A square coil of wire of side 3.00 cm is placed in a uniform magnetic field of magnitude 1.75 T directed into the page as in the figure shown below. The coil has 38.0 turns and a resistance of 0.780 Ω. If the coil is rotated through an angle of 90.0° about the horizontal axis shown in 0.335 s, find the following. (a) the magnitude of the average emf induced in the coil during this rotation (b) the average current...
In the figure, a 53.3 kg uniform square sign, of edge length L = 1.67 m,...
In the figure, a 53.3 kg uniform square sign, of edge length L = 1.67 m, is hung from a horizontal rod of length dh = 2.71 m and negligible mass. A cable is attached to the end of the rod and to a point on the wall at distance dv = 4.41 m above the point where the rod is hinged to the wall. (a) What is the tension in the cable? (b) What is the horizontal component of...
You are given 13.0 mm of thin wire. You form the wire into a circular coil...
You are given 13.0 mm of thin wire. You form the wire into a circular coil with 40 turns. If this coil is placed with its axis parallel to a 0.19 TT magnetic field, what is the flux through the coil? Express your answer with the appropriate units.
A square coil with length 10cm and 10 turns in the external magnetic field directing in...
A square coil with length 10cm and 10 turns in the external magnetic field directing in to tge page. the field is indresing at a rate 0.05T. Find the emf induced in the coil. What is the direction
The electrical resistance of a wire varies directly as its length and inversely as the square...
The electrical resistance of a wire varies directly as its length and inversely as the square of its diameter. A wire with a length of 200 inches and a diameter of one-half of an inch has a resistance of 10 ohms. Find the electrical resistance in a 500 inch wire with the same diameter. Group of answer choices 25 ohms 50 ohms 200 ohms 400 ohms
A square loop of wire with sides of length 34 cm is in a uniform magnetic...
A square loop of wire with sides of length 34 cm is in a uniform magnetic field perpendicular to its area. Part A If the field's strength is initially 110 mT and it decays to zero in 0.011 s , what is the magnitude of the average emf induced in the loop? Part B What would be the average emf if the sides of the loop were only 17 cm ? Express your answer using two significant figures.
A square section wire of side L is traversed by a current I in the +z...
A square section wire of side L is traversed by a current I in the +z direction. The wire is embedded in a constant magnetic field B in the +y direction. You measure a voltage V across L in the horizontal direction. Find the number density of electrons in the metal and identify the direction of the electric field inside the wire.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT