Question

In: Physics

A square loop of wire with sides of length 34 cm is in a uniform magnetic...

A square loop of wire with sides of length 34 cm is in a uniform magnetic field perpendicular to its area.

Part A

If the field's strength is initially 110 mT and it decays to zero in 0.011 s , what is the magnitude of the average emf induced in the loop?

Part B

What would be the average emf if the sides of the loop were only 17 cm ?

Express your answer using two significant figures.

Solutions

Expert Solution


Related Solutions

A square coil of wire of side 3.00 cm is placed in a uniform magnetic field...
A square coil of wire of side 3.00 cm is placed in a uniform magnetic field of magnitude 1.75 T directed into the page as in the figure shown below. The coil has 38.0 turns and a resistance of 0.780 Ω. If the coil is rotated through an angle of 90.0° about the horizontal axis shown in 0.335 s, find the following. (a) the magnitude of the average emf induced in the coil during this rotation (b) the average current...
A square wire loop of side length a = 2.0 cm and resistance R = 10.0Ω...
A square wire loop of side length a = 2.0 cm and resistance R = 10.0Ω is inside a 1.00m long solenoid with 1000 windings such that the plane of the loop is perpendicular to the solenoid’s magnetic field. The solenoid initially carries a current I = 6.0 A, which is turned down to zero evenly over a period of 12.0 s. If the solenoid’s initial magnetic field is out of the page in the figure, what is the magnitude...
A rectangular loop of wire with sides H = 27 cm and W = 74 cm...
A rectangular loop of wire with sides H = 27 cm and W = 74 cm carries current I2 = 0.187 A. An infinite straight wire, located a distance L = 25 cm from segment ad of the loop as shown, carries current I1 = 0.781 A in the positive y-direction. 1) What is Fad,x, the x-component of the force exerted by the infinite wire on segment ad of the loop? N You currently have 0 submissions for this question....
A single loop of wire with an area of 0.0900m2 is in a uniform magnetic field...
A single loop of wire with an area of 0.0900m2 is in a uniform magnetic field that has an initial value of 3.8 T, is perpendicular to the plane of the loop, and is decreasing at a constant rate of 0.190 T/s. (a) What emf is induced in this loop? (b) If the loop has a resistance of 0.600O, find the current induced in the loop.
A loop of wire has a radius of 2.0 cm and is in a constant magnetic...
A loop of wire has a radius of 2.0 cm and is in a constant magnetic field of 0.88 T directed into the plane of the paper. If the loop collapses so the radius of the circle shrinks to zero in a time of 0.35 s, a) find the magnitude of the average induced emf in the loop. b) If the loop is part of a larger circuit, in which direction does the induced current flow as the loop closes.
A small loop of copper wire is inside and held perpindicular to a large, uniform magnetic...
A small loop of copper wire is inside and held perpindicular to a large, uniform magnetic field. You move the loop in circles and vary the speed. What do you observe? a. The faster the speed, the greater the current. b. As you decrease the radius of the path of the loop in the field the current increases. c. As you increase speed, the current decreases. d. Nothing. No current is induced.
An 80 cm by 80 cm square loop of wire lies in the xy-plane and has...
An 80 cm by 80 cm square loop of wire lies in the xy-plane and has a resistance of 0.2 Ω. It sits in a time-dependent uniform magnetic field of [0.6 sin (3π t)k] T. What is the largest value that the induced current takes on?
A square loop of wired with side length 2 cm is in the plane of the...
A square loop of wired with side length 2 cm is in the plane of the page. At time t= 0, a 9 T magnetic field is directed into the page. The field changes to 4 T directed into the page in 0.25 seconds. What is the magnetic flux through the loop of wire at time, t = 0? What is the magnetic flux through the loop of wire 0.25 seconds later?What is the emf induced in the loop of...
A circular wire loop of radius 1.4 cm is placed in a magnetic field of magnitude...
A circular wire loop of radius 1.4 cm is placed in a magnetic field of magnitude 2.3 T. If the magnetic field goes to zero in a time of 5 s, what is the magnitude of the current induced in the loop? The wire has a diameter of 2 mm, and the resistivity of copper is 1.7 x 10-8 Ohm-m.
A rectangular loop of wire is immersed in a non-uniform and time-varying magnetic field. The magnitude...
A rectangular loop of wire is immersed in a non-uniform and time-varying magnetic field. The magnitude of the field is given by B = 4t2x2 , where t is the time in seconds and x is one dimension of the loop. The direction of the field is always perpendicular to the plane of the loop. The loop extends from x = 0 to x = 3.0 m and from y = 0 to y = 2.0 m. What is the...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT