An aquifer has a T = 150 m²/day, S = 0.0001, and provides a flow of...

An aquifer has a T = 150 m²/day, S = 0.0001, and provides a flow of 25 L/s ( 400 gal/min) to a well. Find the drawdown at two observation wells located 20 m and 50 m from the producing well after 1 day, 30 days, 1 year, and 5 years

Expert Solution

in the given question drawdowns at different instances for two observation wells is asked to be determined and both of them have been determined successfully with best of my knowledge using cooper jacob method.

please be generous in rating thank you.

Ally Wells answered 1 day ago

M (g) M (kg) Delta t1(s) Delta t2(s) Delta t3(s) Delta t(s) avg. T (s) T2...

M (g) M (kg) Delta t1(s) Delta t2(s) Delta t3(s) Delta t(s) avg. T (s) T2 (s2) 60 0.06 6.53 6.55 6.31 6.46 0.646 0.42 80 0.08 6.63 6.60 6.64 6.62 0.662 0.44 100 0.10 6.99 6.87 7.08 6.98 0.698 0.49 120 0.12 8.12 8.36 8.46 8.31 0.831 0.69 140 0.14 8.35 8.11 8.15 8.20 0.820 0.67 find the slope (4pi^2)/k calculate the intercept ((4pi^2)/3k)m Equate the value of the slope found at point 5 with (4pi^2)/k and solve for...

7.11 Consider two cases involving parallel flow of dry air at V = 1 m/s, T∞...

7.11 Consider two cases involving parallel flow of dry air at V = 1 m/s, T∞ = 45°C, and atmospheric pressure over an isothermal plate at Ts = 20°C. In the first case, Rex,c = 5 × 105, while in the second case the flow is tripped to a turbulent state at x = 0 m. At what x‐location are the thermal boundary layer thicknesses of the two cases equal? What are the local heat fluxes at this location for...

A stream has a temperature of 20 degrees C, a velocity of 0.5 m/s, a flow...

A stream has a temperature of 20 degrees C, a velocity of 0.5 m/s, a flow rate of 3.0 m3/s, depth of 3.0 m, saturation dissolved oxygen (DO = 9.07 mg/L), and BODu = 5 mg/L. Assume the deoxygenation constant (k) = 0.24 d-1. Wastewater discharge flows into the stream at 0.6 m3/s and temperature of 20 degrees C, and the DO is 8.1 mg/L. The lowest DO downstream is 4.0 mg/L and it occurs at a distance of 20...

A 360-m-wide river has a uniform flow speed of 1.5 m/s through a jungle and toward...

A 360-m-wide river has a uniform flow speed of 1.5 m/s through a jungle and toward the east. An explorer wishes to leave a small clearing on the south bank and cross the river in a powerboat that moves at a constant speed of 5.8 m/s with respect to the water. There is a clearing on the north bank 65 m upstream from a point directly opposite the clearing on the south bank. (a) At what angle, measured relative to...

Let {W(t),t≥0} be a standard Brownian motion and let M(t)=max0≤s≤tW(s). Find P(M(9)≥3).

An unconfined aquifer made up of silt loam has an initial piezometric surface of 40 m....

An unconfined aquifer made up of silt loam has an initial piezometric surface of 40 m. If wells 28 m and 15 m away from the pumping well have drawdowns of 4 m and 8 m, respectively, what is the pumping rate (m3/d) of the well? Based on this, if you wanted to keep the same drawdowns at the observation wells, but needed a drawdown of 10 m in your pumping well, what diameter would the pumping well casing need...

[A], M [B], M Δ [C]/ Δ t (initial) M/s 0.215 0.150

[A], M [B], M Δ [C]/ Δ t (initial) M/s 0.215 0.150 5.81 x 10–4 0.215 0.300 1.16 x 10–3 0.430 0.150 2.32 x 10–3 Given the initial rate data for the reaction A + B ? C, determine the rate expression for the reaction. Please show steps and explain please

A projectile is fired with an initial speed of 150 m/s and angle of elevation 60°....

A projectile is fired with an initial speed of 150 m/s and angle of elevation 60°. The projectile is fired from a position 80 m above the ground. (Recall g ≈ 9.8 m/s2. Round your answers to the nearest whole number.) (a) Find the range of the projectile (b) Find the maximum height reached. (c) Find the speed at impact.

An aircraft is in level flight at airspeed v(t) m/s with thrust T(t) N at cruising...

An aircraft is in level flight at airspeed v(t) m/s with thrust T(t) N at cruising altitude. Suppose that at v0 = 250 m/s, the aerodynamic drag experienced by the aircraft at this altitude is: Fd(v) = 0.25v 2 . (1) Then, an extremely simplified model relating v(t) to T(t) is: mv˙(t) + Fd(v(t)) = T(t), (2) where m = 25000 kg. Assume v(t) is always positive. Question 1. Linearize (2) at v0 = 250 m/s, and an appropriate nominal...

A bulldozer’s velocity (in m/s) at a time t is given by v(t)=t^2-t+3. (a)Estimate the displacement...

A bulldozer’s velocity (in m/s) at a time t is given by v(t)=t^2-t+3. (a)Estimate the displacement of the bulldozer on the time interval using 0≤t≤5 Midpoint Riemann Sum with 10 subintervals. Specify the value of,n ,Δx, and the chosen sample points. (b)Find the exact displacement of the object on the time interval 0≤t≤5 using the limit definition of the definite integral. Thank you,

Question