Question

In: Electrical Engineering

Explain the operation of 12-pulse full controlled rectifier by sketching circuit schema and related waveforms and...

Explain the operation of 12-pulse full controlled rectifier by sketching circuit schema and related waveforms and by giving the fundamental equations. What are the advantages of that circuit?

Solutions

Expert Solution


Related Solutions

Give the Vs and Vo waveforms of a three phase bridge controlled rectifier. Draw different waveforms...
Give the Vs and Vo waveforms of a three phase bridge controlled rectifier. Draw different waveforms for angles 30,60,90,120 degrees for each a resistive load and then a RL load. Clearly label period in degrees on X axis.
For three-phase, Full-wave, Semi-controlled rectifier, sketch the waveforms for following at firing angle Alpha = 90...
For three-phase, Full-wave, Semi-controlled rectifier, sketch the waveforms for following at firing angle Alpha = 90 and over-lap angle Gama = 10 a- The positive and negative voltage relative to neutral. b- The input current for phase (a)
The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230...
The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230 Volt at 50 Hz. 24 Volt battery will be charged with 15A. An inductor, which is series connected to the battery, is used to limit the current ripple. Only The second harmonics of the output voltage is taken into account. The inductor R/L ratio is 50. The current ripple is allowed to be 4 amp peak to peak. Determine the firing angle and R...
- Single phase controlled bridge type rectifier circuits; a. Drawing circuit shapes, input voltage and wave...
- Single phase controlled bridge type rectifier circuits; a. Drawing circuit shapes, input voltage and wave current of load current and load voltage at pure resistive load Explain in the angular velocity axis. (10 points) b. Prove mathematically how load voltage values are calculated, (10 points) c. How the output waveforms will be affected if the R-L charge feeds instead of the pure resistive charge, and you explain the reasons for this with waveforms and mathematically. (10 points)
Derive the expressions of the average load voltage and current in single-phase full-wave controlled rectifier (bridge...
Derive the expressions of the average load voltage and current in single-phase full-wave controlled rectifier (bridge rectifier) and resistive load. Draw the waveforms of supply voltage, output voltage, output current and thyristor current.    In a single-phase full-wave controlled rectifier (bridge rectifier) and resistive load, it is desired to get an average load voltage of 50 V. Determine the firing angle if the ac supply voltage is 150 V. If the average load power is 300W, calculate the average load...
Draw the circuit of a Boost Regulator and explain the operation of this circuit with the...
Draw the circuit of a Boost Regulator and explain the operation of this circuit with the aid of waveforms.
Please use a transformer, bridge full-wave rectifier and filter capacitor to design a power supply circuit...
Please use a transformer, bridge full-wave rectifier and filter capacitor to design a power supply circuit that converts 60Hz-110V AC to 12V DC. Please (1) draw a circuit diagram, (2) calculate the value of the filter capacitor C so that the ripple at the output current of 2A needs to be less than 0.1V, (3) select the transformer output voltage and estimate the peak voltage of the DC power supply.
Construct a bridge-controlled rectifier with R-L loads using Matlab/Simulink software. Circuit parameters – can be either...
Construct a bridge-controlled rectifier with R-L loads using Matlab/Simulink software. Circuit parameters – can be either calculating, refer to any sources (textbook, journal, or technical manual) or assumption a. Describe the circuit designed, parameters selection and output signal outcomes b. Constant the firing angle, then discuss the effect of changing L to see the operation of CCM and DCM. c. Constant the L, then discuss the effect of changing the firing angle to see the operation of CCM and DCM....
1) Explain the oprerating principle of left-rotating, right rotating shift register by sketching the circuit and...
1) Explain the oprerating principle of left-rotating, right rotating shift register by sketching the circuit and timing diagram for 4-bit register configurations?
A battery charger with a series resistor is somewhat like a half-wave rectifier. Explain its operation.
A battery charger with a series resistor is somewhat like a half-wave rectifier. Explain its operation.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT