Question

In: Electrical Engineering

Construct a bridge-controlled rectifier with R-L loads using Matlab/Simulink software. Circuit parameters – can be either...

Construct a bridge-controlled rectifier with R-L loads using Matlab/Simulink software. Circuit parameters – can be either calculating, refer to any sources (textbook, journal, or technical manual) or assumption

a. Describe the circuit designed, parameters selection and output signal outcomes

b. Constant the firing angle, then discuss the effect of changing L to see the operation of CCM and DCM.

c. Constant the L, then discuss the effect of changing the firing angle to see the operation of CCM and DCM.

d. Change to use only R load and compare the outcomes with R-L loads.

e. Based on the simulation results, give one example could be used from this kind of rectifier in practical.

Solutions

Expert Solution


Related Solutions

- Single phase controlled bridge type rectifier circuits; a. Drawing circuit shapes, input voltage and wave...
- Single phase controlled bridge type rectifier circuits; a. Drawing circuit shapes, input voltage and wave current of load current and load voltage at pure resistive load Explain in the angular velocity axis. (10 points) b. Prove mathematically how load voltage values are calculated, (10 points) c. How the output waveforms will be affected if the R-L charge feeds instead of the pure resistive charge, and you explain the reasons for this with waveforms and mathematically. (10 points)
BY Using MATLAB software: Exercise 3: Calculation of the parameters of a dipole. % M-File: ML0804...
BY Using MATLAB software: Exercise 3: Calculation of the parameters of a dipole. % M-File: ML0804 % % Perform numerical integration to find % beam solid angle, directivity, and the % maximum power function for a given length % dipole. % % Variables % L dipole length (in wavelengths) % bL2 phase constant * length/2 % N number of theta points % th,thr angle theta in degrees,radians % dth differential theta % num,den temporary variables % F un-normalized power function...
Using all the data below, construct an empirical model using a computational tool (matlab, or R,...
Using all the data below, construct an empirical model using a computational tool (matlab, or R, any preferred). explain your model. Data Description: These data are from a NIST study involving calibration of ozone monitors. The response variable (y) is the customer's measurement of ozone concentration and the predictor variable (x) is NIST's measurement of ozone concentration. MATLAB Row Vectors: xLst = [0.2, 337.4, 118.2, 884.6, 10.1, 226.5, 666.3, 996.3, 448.6, 777.0, 558.2, 0.4, 0.6, 775.5, 666.9, 338.0, 447.5, 11.6,...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT