Question

In: Electrical Engineering

For three-phase, Full-wave, Semi-controlled rectifier, sketch the waveforms for following at firing angle Alpha = 90...

For three-phase, Full-wave, Semi-controlled rectifier, sketch the waveforms for following at firing angle Alpha = 90 and over-lap angle Gama = 10

a- The positive and negative voltage relative to neutral.

b- The input current for phase (a)

Solutions

Expert Solution


Related Solutions

Give the Vs and Vo waveforms of a three phase bridge controlled rectifier. Draw different waveforms...
Give the Vs and Vo waveforms of a three phase bridge controlled rectifier. Draw different waveforms for angles 30,60,90,120 degrees for each a resistive load and then a RL load. Clearly label period in degrees on X axis.
Derive the expressions of the average load voltage and current in single-phase full-wave controlled rectifier (bridge...
Derive the expressions of the average load voltage and current in single-phase full-wave controlled rectifier (bridge rectifier) and resistive load. Draw the waveforms of supply voltage, output voltage, output current and thyristor current.    In a single-phase full-wave controlled rectifier (bridge rectifier) and resistive load, it is desired to get an average load voltage of 50 V. Determine the firing angle if the ac supply voltage is 150 V. If the average load power is 300W, calculate the average load...
Explain the operation of 12-pulse full controlled rectifier by sketching circuit schema and related waveforms and...
Explain the operation of 12-pulse full controlled rectifier by sketching circuit schema and related waveforms and by giving the fundamental equations. What are the advantages of that circuit?
The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230...
The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230 Volt at 50 Hz. 24 Volt battery will be charged with 15A. An inductor, which is series connected to the battery, is used to limit the current ripple. Only The second harmonics of the output voltage is taken into account. The inductor R/L ratio is 50. The current ripple is allowed to be 4 amp peak to peak. Determine the firing angle and R...
A single- phase full- wave rectifier is used to control the speed of a 5- hp,...
A single- phase full- wave rectifier is used to control the speed of a 5- hp, 110- V, 1200- rpm, separately- excited dc motor. The converter is connected to a single- phase, 120- V, 60- Hz supply. The motor has a winding resistance of 0.4ohms and an inductance of 5 mH, and a voltage constant K=0.09V/rpm. a. During the motoring operation, the motor runs at 1000 rpm and receives an armature current of 30 A. Determine the corresponding firing angle...
- Single phase controlled bridge type rectifier circuits; a. Drawing circuit shapes, input voltage and wave...
- Single phase controlled bridge type rectifier circuits; a. Drawing circuit shapes, input voltage and wave current of load current and load voltage at pure resistive load Explain in the angular velocity axis. (10 points) b. Prove mathematically how load voltage values are calculated, (10 points) c. How the output waveforms will be affected if the R-L charge feeds instead of the pure resistive charge, and you explain the reasons for this with waveforms and mathematically. (10 points)
Derive the equations (for average value of load voltage) of three phase half controlled rectifier and...
Derive the equations (for average value of load voltage) of three phase half controlled rectifier and three phase full controlled rectifier ?
(b) Explain a 1-ф full wave controlled semi converter with freewheel diode for RLE load.
(b) Explain a 1-ф full wave controlled semi converter with freewheel diode for RLE load.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT