Question

In: Electrical Engineering

The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230...

The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230 Volt at 50 Hz. 24 Volt battery will be charged with 15A. An inductor, which is series connected to the battery, is used to limit the current ripple. Only The second harmonics of the output voltage is taken into account. The inductor R/L ratio is 50. The current ripple is allowed to be 4 amp peak to peak. Determine the firing angle and R for the circuit, for this design. Write the mat equations and Show the solution with detail.

a) alfa=? ( in rad ) b) R=?

Solutions

Expert Solution


Related Solutions

For a power supply with full wave bridge rectifier, input voltage is 230 V and required...
For a power supply with full wave bridge rectifier, input voltage is 230 V and required output voltage is 12 V DC Load resistance is of 100 . Determine output rms voltage, dc current, rms current, power, ac power, efficiency of the rectifier, form factor, ripple factor, transformer utilization factor, and size of the transformer Draw complete diagram of the supply circuit
Derive the expressions of the average load voltage and current in single-phase full-wave controlled rectifier (bridge...
Derive the expressions of the average load voltage and current in single-phase full-wave controlled rectifier (bridge rectifier) and resistive load. Draw the waveforms of supply voltage, output voltage, output current and thyristor current.    In a single-phase full-wave controlled rectifier (bridge rectifier) and resistive load, it is desired to get an average load voltage of 50 V. Determine the firing angle if the ac supply voltage is 150 V. If the average load power is 300W, calculate the average load...
An AC generator supplies an rms voltage of 230 V at 60.0 Hz. It is connected...
An AC generator supplies an rms voltage of 230 V at 60.0 Hz. It is connected in series with a 0.300 H inductor, a 4.30 μF capacitor and a 256 Ω resistor. What is the impedance of the circuit? What is the rms current through the resistor? What is the average power dissipated in the circuit? What is the peak current through the resistor? What is the peak voltage across the inductor? What is the peak voltage across the capacitor?...
An AC generator supplies an rms voltage of 230 V at 60.0 Hz. It is connected...
An AC generator supplies an rms voltage of 230 V at 60.0 Hz. It is connected in series with a 0.400 H inductor, a 3.40 μF capacitor and a 206 Ω resistor. What is the impedance of the circuit? Tries 0/20 What is the rms current through the resistor? Tries 0/20 What is the average power dissipated in the circuit? Tries 0/20 What is the peak current through the resistor? Tries 0/20 What is the peak voltage across the inductor?...
- Single phase controlled bridge type rectifier circuits; a. Drawing circuit shapes, input voltage and wave...
- Single phase controlled bridge type rectifier circuits; a. Drawing circuit shapes, input voltage and wave current of load current and load voltage at pure resistive load Explain in the angular velocity axis. (10 points) b. Prove mathematically how load voltage values are calculated, (10 points) c. How the output waveforms will be affected if the R-L charge feeds instead of the pure resistive charge, and you explain the reasons for this with waveforms and mathematically. (10 points)
For three-phase, Full-wave, Semi-controlled rectifier, sketch the waveforms for following at firing angle Alpha = 90...
For three-phase, Full-wave, Semi-controlled rectifier, sketch the waveforms for following at firing angle Alpha = 90 and over-lap angle Gama = 10 a- The positive and negative voltage relative to neutral. b- The input current for phase (a)
A generator with an rms voltage of 130 V is connected in series to a resistor...
A generator with an rms voltage of 130 V is connected in series to a resistor 3.65 kΩ and a capacitor 3.00 μF . 1. At what frequency must this circuit be operated for the current to lead the voltage by 29.0 ∘? (Answer Hz) 2. Using the frequency found in part A, find the average power consumed by this circuit. (Answer in W) ------------------------------------------ A 1.6-m wire is wound into a coil with a radius of 3.2 cm. 1....
A) The order of first 3 harmonics on the output voltage of a controlled 3-phase rectifier...
A) The order of first 3 harmonics on the output voltage of a controlled 3-phase rectifier in CCM operations are; B) The order of first 5 harmonics on the input current of a controlled 3-phase rectifier in CCM operations are;
An inductor is connected to a 17 kHz oscillator that produces an rms voltage of 7.0...
An inductor is connected to a 17 kHz oscillator that produces an rms voltage of 7.0 V . The peak current is 70 mA .What is the value of the inductance L? answer in mH.
Derive the equations (for average value of load voltage) of three phase half controlled rectifier and...
Derive the equations (for average value of load voltage) of three phase half controlled rectifier and three phase full controlled rectifier ?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT