If an engineer believes that a section of pipe is fully developed what are they claiming...

If an engineer believes that a section of pipe is fully developed what are they claiming in terms of

a) fluid velocity?

b) fluid forces?

Solutions

Expert Solution

samet mamat answered 1 year ago

Next > < Previous

Related Solutions

Fully developed (both hydrodynamic and thermal) laminar flow is pushed through a thin-walled circular pipe of...

Fully developed (both hydrodynamic and thermal) laminar flow is pushed through a thin-walled circular pipe of diameter 13 mm. The fluid flows through the pipe at a velocity of 0.1 m/sec, has a density of 1000 kg/m^3, a dynamic viscosity of 855 x 10^-6 Pa-sec, a specific heat of 4000 J/kg-K, a Prandtl number of 8, and a thermal conductivity of 0.613 W/(m-K). The outside of the pipe is subjected to uniform cross flow where the free-stream velocity is 5...

What are some challenges of the BRICS in becoming part of the fully developed world? How...

What are some challenges of the BRICS in becoming part of the fully developed world? How does geography influence their development?

Fully Functional Script written in BASH In this section, you will write a fully functional script...

Fully Functional Script written in BASH In this section, you will write a fully functional script to help your manager with an important project that will build upon what you learned from your script work in Milestone Four. After you have written the script, you will execute it to generate a report for all three users (once for Bob, once for Henry, and once for Frank). You should have three unique generated reports in your ~/scripts directory (or more if...

4. Suppose that you are the engineer in the charge of the gasification section of the...

4. Suppose that you are the engineer in the charge of the gasification section of the Acme Substitute Natural Gas Company. ASNG Co. runs fixed-bed, dry-ash gasifiers. The raw gas is cleaned, shifted, and sent to a methane synthesis unit. Every morning you receive a report from ASNG’s analytical laboratory on the characteristics of the coal that will be fed to the gasifiers during the next day’s operations. One important characteristic is the ash fusion temperature (AFT), i.e., the temperature...

A suspension of calcium carbonate particles in water flows through a pipe. An engineer was asked...

A suspension of calcium carbonate particles in water flows through a pipe. An engineer was asked to determine both the flow rate and the composition of this slurry. The engineer proceeded to collect the stream in a graduated cylinder for a time given in the table below. The engineer weighed the cylinder, evaporate the collected water, and reweighed the cylinder. The following results are obtained based on two occasion Item Sample 1 Sample 2 Time to collect 1 min 1...

An incompressible fluid is flowing through a vertical pipe with a constriction. The wide section is...

An incompressible fluid is flowing through a vertical pipe with a constriction. The wide section is 2.00 cm in diameter and is at the top of the pipe. The pressure of the fluid in the wide section at the top is 200 kPa. The velocity of the fluid in the wide section is 4.00 m/s. The narrow section is located 4.00 m below the wide section. What is the diameter of the narrow section for the pressure of the fluid...

(1) Describe briefly the definition of fully developed laminar flow. (2) From governing laws for fully...

(1) Describe briefly the definition of fully developed laminar flow. (2) From governing laws for fully developed laminar flow, derive an equation for fully developed laminar flow that shows the relation between flowrate and pressure gradient.

the city engineer asks you to compare the cost of installing water pipe with city employees...

the city engineer asks you to compare the cost of installing water pipe with city employees ( alternative A) versus contracting it out ( Alternative B). They need to lay 4000 lineal feet of pipe per month for 48 months. Use i=9% per year Alternative A: Buy equipment =$2,000,000 paid now Resale of equipment at EMO 48 = 10% of purchase price Equipment O & M, labor, Materials = $10/lineal foot for the first 12 months, increasing by $0.10/month for...

A long conducting pipe has a rectangular cross section with sides of lengths a and b....

A long conducting pipe has a rectangular cross section with sides of lengths a and b. One face of the pipe is maintained at a constant potential V = V0 while the other 3 faces are grounded (V = 0). Using separation of variables, find the potential for points inside the pipe V (x,y).

Why is it so important for an economy to have a fully developed financial markets?

Subjects