Water at 80°F and 20 psia is heated in a chamber by mixing it with saturated...

Water at 80°F and 20 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. If both streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. Include a heat loss rate of 200 kW and a net mass flow rate of the combined streams of 4 lbm/s.

Expert Solution

samet mamat answered 2 years ago

Water is heated in a mixing chamber by mixing it with hot water coming from a...

Water is heated in a mixing chamber by mixing it with hot water coming from a heater. The mixing chamber loses heat to the surroundings at a rate of 5 kW. The hot water enters the mixing chamber at a rate of 1 kg/s. The mixed water leaves the chamber fully mixed. - The cold water enters the mixing chamber at 200 kPa and 20°C at a velocity of 3 m/s - The hot water enters at a pressure of...

Water at 300kPa and 20oC is heated in a chamber by mixing it with superheated steam...

Water at 300kPa and 20oC is heated in a chamber by mixing it with superheated steam at 300kPa and 300oC. The cold water enters the chamber at a rate of 1.9 kg/s. Calculate the mass flow rate of the superheated steam, if the mixture leaves the chamber at 60oC. answer is ______kg/s If necessary, define system and energy flows shown on sketch. Complete solution shown analytically before numbers.

Liquid water at 15 ℃ is heated by mixing it with saturated steam at the same...

Liquid water at 15 ℃ is heated by mixing it with saturated steam at the same pressure. Liquid water enters a chamber at a rate of 4.3 kg/s and saturated steam enters at a rate of 0.17 kg/s. The mixture leaves the mixing chamber as a saturated liquid at 40℃. If the surroundings are at 15℃, determine (a) the temperature of the saturated steam entering the chamber, (b) the exergy destruction during this mixing process, and (c) the second-law efficiency...

In a thermally isolated mixing chamber cold water at 50oC and 1MPa is heated steadily by...

In a thermally isolated mixing chamber cold water at 50oC and 1MPa is heated steadily by a steam at 200oC and 1MPa. The mixture leaves the chamber at 150oC. 1.mass ratio of the hot and cold streams 2 entropy generation rate per unit cold water mass flow rate

R22 is compressed adiabatically and reversibly from saturated vapor at -20 deg F to 200 psia....

R22 is compressed adiabatically and reversibly from saturated vapor at -20 deg F to 200 psia. Find the final temperature and the specific work done.

120 kilograms of saturated water at 2.32 MPa pressure is heated to saturated vapor at same...

120 kilograms of saturated water at 2.32 MPa pressure is heated to saturated vapor at same pressure. Determine heat required for the process.

A sweet, water-saturated natural gas enters a compressor at 50 psia and 100F and leaves at...

A sweet, water-saturated natural gas enters a compressor at 50 psia and 100F and leaves at 200 psia and 300F. a. Is there any chance of water condensing in the compressor? If so, how much? Answer in lb H2O/MMscf gas compressed. b. Estimate the mole fraction of water vapor in the gas stream leaving the compressor. c. The natural gas is then cooled to 190 psia and 100F before entering the second stge of compression. Should a vapor-liquid scrubber be...

A mass of 5kg of saturated water vapor at 150 kpa is heated at a constant...

A mass of 5kg of saturated water vapor at 150 kpa is heated at a constant pressure until the temperature reaches 200 C. Calculate the work done by the steam during this process?

Saturated liquid Propane flows in to a valve. It enters at 375 psia, and leaves at 15 psia.

Saturated liquid Propane flows in to a valve. It enters at 375 psia, and leaves at 15 psia. Mass flow through the valve is 1.25 lbm/hr. Use EES and ‘Propane’ as your fluid. This new device replaces the valve with a ‘magic’ isentropic device. Assuming the device operates at steady state, and PE and KE terms are insignificant, calculate how much power could be generated by the device (hp)?

A mass of 5 kg of saturated water vapor at 150 kPa is heated at constant...

A mass of 5 kg of saturated water vapor at 150 kPa is heated at constant pressure until the temperature reaches 200°C, the the boundary work in KJ is done by the steam during this process is closest to?

Question