A reaction takes place in a balloon such that 425 J of heat are taken in...

A reaction takes place in a balloon such that 425 J of heat are taken in from the surroundings and 193 J of work are done by the surroundings.

What is ΔE for the system? in J

What is ΔH for the surroundings? in J

What is ΔE for the universe? in J

Expert Solution

1) ΔE for for the system = Q - W

= 425 - 193

= 232 J

2) ΔH for the surroundings = - Q = -425 J

3)

surronding internal energy = work done by the system

ΔEsurroundings = 193 J

ΔE universe = ΔEsystem + ΔEsurroundings

= 232 + 193

= 425 J

queen_honey_blossom answered 2 months ago

A balloon is heated by adding 1000 J of heat. It expands by about 5 liters...

A balloon is heated by adding 1000 J of heat. It expands by about 5 liters against a constant atmospheric pressure of 1 atm. Calculate the change in the internal energy of the system.

Convection heat transfer takes place owing to changes of density within the Fluid. Discusss convective heat...

Convection heat transfer takes place owing to changes of density within the Fluid. Discusss convective heat transfer in some detail. Your answer should include relavant sketches, equations and practical applications

For a given reaction, the heat capacity (CP) of the reactants is 50.0 J/mol K and...

For a given reaction, the heat capacity (CP) of the reactants is 50.0 J/mol K and for the products is 65.0 J/mol K. If the enthalpy of reaction is − 150.0 kJ/mol at 300K, what is the best estimate of ΔrxnH at 320K? The reaction in the previous question is carried out adiabatically starting at 300 K. What is the final temperature after the reaction goes to completion? ΔrxnH300 = -150.0 kJ/mol CP(reactants) = 50 J/molK CP(products) = 65 J/molK...

A reaction released 1256 J of heat and expands from 1.3L to 14.7L at a constant...

A reaction released 1256 J of heat and expands from 1.3L to 14.7L at a constant pressure of 1.04 kPa. What is the total energy change for the system in kJ. Include the correct sign with respect to the system. (1 kPa * L = 1 J)

A gas phase reaction takes place in a syringe at a constant temperature and pressure. If...

A gas phase reaction takes place in a syringe at a constant temperature and pressure. If the initial volume before reaction is 60 mL and the final volume after the reaction is complete is 40 mL, which of the following reactions took place. (Note: You can assume that you start with stoichiometric amounts of the reactants, the reaction goes to completion and that the gases behave ideally.) 2NO(g) + O2(g)->2NO2(g) 2NO2(g)->N2O4(g) 2NOBr(g)->2NO(g) + Br2(g) 2N2O5(g)->2N2O4(g) + O2(g) 2N2O5(g)->4NO2(g) + O2(g)

Experiment 2 – Light Independent Reaction After the light dependent reaction, the light independent takes place....

Experiment 2 – Light Independent Reaction After the light dependent reaction, the light independent takes place. During this phase, also known as the Calvin Cycle, the energy generated in the light independent phase is used to fixate the carbon atoms from carbon dioxide and glucose is produced. In this experiment you will use baby spinach leaves to demonstrate the utilization of carbon dioxide during the light independent reaction of photosynthesis. Phenol red is an organic dye that undergoes a color...

The irreversible elementary reaction 2A > B takes place in the gas phase in an isothermal...

The irreversible elementary reaction 2A > B takes place in the gas phase in an isothermal tubular reactor. The feed is one mole of A per one mole of C, an inert. The entering temperature and pressure are 427°C and 10 atm, respectively. The gas constant R = 0.08206 atm · L/mol · K. (a) Determine the concentration of A at the entrance to the reactor. (b) If CA0 = 1.0 mol/L, what is the concentration of A at 90%...

The liquid-phase reaction A---> B + C takes place in a series of two CSTRs...

The liquid-phase reaction A---> B + C takes place in a series of two CSTRs with an overall conversion of 0.75. Two newly purchased CSTRs are added to the series. The volumetric flow rate is then increased in order to keep the overall conversion at 0.75. (a) List all your assumptions. (b) If the original flow rate was 150 L/min, determine the new flow rate (L/min).

a. Draw the reaction that takes place when a disulfide bond is formed. What conditions are...

a. Draw the reaction that takes place when a disulfide bond is formed. What conditions are required for this to occur? What is the major role of disulfide bonds? What kinds of proteins normally have disulfide bonds? Where do you expect to find ribonuclease, the enzyme used in Anfinsen’s famous experiment? b. Ohm loops are also considered secondary structure. How does their structure differ from other secondary elements? What function do these loops serve? Where are loops typically found on...

Describe the process that takes place between the participants in the neutralization reaction between the strong...

Describe the process that takes place between the participants in the neutralization reaction between the strong acid hydrochloric acid, HCl(aq), and water insoluble chromium(III) hydroxide, Cr(OH)3(s), forming water and chromium(III) chloride, CrCl3(aq). Mention the nature of the particles in the solution before and after the reaction. (a) Because hydrochloric acid is ---Select--- an acid a base a binary covalent compound a binary ionic compound an oxyacid , it reacts with water to form ---Select--- hydrogen atoms hydronium ions hydroxide ions protons and ---Select---...

Question