Question

In: Other

Use the psychrometric chart to estimate (1) the absolute humidity, wet bulb temperature, humid volume, dew...

Use the psychrometric chart to estimate (1) the absolute humidity, wet bulb temperature, humid volume, dew point, and specific enthalpy of humid air at T =30 oC and 40 % relative humidity, and (2) the amount of water in 150 m3 or air at these conditions. Students must sketch the psychrometric chart and draw the path of determining the parameters of (1).

Solutions

Expert Solution

Amanda K answered 6 months ago
Next > < Previous

Related Solutions

Humid air at given : dry-bulb temperature, wet-bulb temperature and total pressure enters a drier at a given molar flow rate.
  Humid air at given : dry-bulb temperature, wet-bulb temperature and total pressure enters a drier at a given molar flow rate. Using psychometric chart to estimate :relative humidity, absolute humidity, dew point temperature and humid volume of air A- volumetric flow rate entering drier?B-mass flow rate BDA entering drier?C-Ha and Hm if more mass flow rate of water is added during passing through drier?D-molar composition air leaving drier?E-percentage humidity (Hp) air entering drier?
Air with a dry bulb temperature 75 F and a wet bulb temperature 65 F is...
Air with a dry bulb temperature 75 F and a wet bulb temperature 65 F is at a sea level pressure of 14.7 psia. Using equations to calculate (a) humidity ratio, (b) the relative humidity of the air, (c) enthalpy, (d) dew point, and (e) the mass density of the dry air. (50)
USE EXCEL OR MATLAB IF YOU NEED Given the dry-bulb temperature, Tdb and relative humidity, Φ,...
USE EXCEL OR MATLAB IF YOU NEED Given the dry-bulb temperature, Tdb and relative humidity, Φ, the wet-bulb, Twb temperature may be calculated from the psychrometric equation (Jones, 1994): PvsΦ – Pss = PatmA (Twb -Tdb )                                              (1) Use your input from the Table below. The input Twb and Tdb are in oC (used in Eqs. (2) and (3) in Kelvin).    Pss = saturated vapor pressure at Twb (kPa) Pvs = saturated vapor pressure at Tdb (kPa)    Pss =...
Please show steps 2.54 Using the ASHRAE Psychrometric Chart complete the following table: Dry Bulb, °F...
Please show steps 2.54 Using the ASHRAE Psychrometric Chart complete the following table: Dry Bulb, °F Wet Bulb, °F Dew Point, °F Humidity Ratio, lbv/lba Relative Humidity, % Enthalpy, Btu/lbair Specific Volume, ft3/lbair 80 13.8 70 55 100 70 40 40 0.01 13.8 60 40 40 20 60 30 85 0.012 80 80
electronic psychrometric plotting program, let’s consider atmospheric conditions at sea level with a dry bulb temperature...
electronic psychrometric plotting program, let’s consider atmospheric conditions at sea level with a dry bulb temperature (Tdry bulb ) of 23˚C and a relative humidity (RH) of 30%. Plot this state point on the pyschrometric chart available in PsycPro software. Use PsycPro to determine the following: a. Wet bulb temperature (WBT) of the air b. Dew point temperature (DPT) of the air c. Humidity ratio (specific humidity) d. Enthalpy e. Specific volume of the air (i) Provide the values for...
Air entering a dryer has a temperature (dry bulb) of 60°C and a dew point of...
Air entering a dryer has a temperature (dry bulb) of 60°C and a dew point of 26.7°C. Using the humidity chart, determine the actual humidity H, percentage humidity HP, humid heat cS and humid volume vH.
300% excess air having a dry bulb temperature of 25 degree celsius and relative humidity of...
300% excess air having a dry bulb temperature of 25 degree celsius and relative humidity of 60% is used to fully combust 1 kg/hr of methane in a boiler and the heat of reaction is used to generate steam. Hot water enters the boiler as a saturated liquid at 102 degree celsius and leaves as superheated at 40 bar and 400 degree celsius. The combusted gases leave the boiler at 450 degree celsius and are then cooled to 25 degree...
Moist air at 55 oF dry bulb temperature and 40% relative humidity is first heated through...
Moist air at 55 oF dry bulb temperature and 40% relative humidity is first heated through a heating coil. The air is then adiabatically humidified by saturated water vapor at 4.5 psia. The exit air has a dry bulb temperature of 90 oF and wet bulb temperature 65 oF. Air is supplied at a volume flow rate of 478.5 cfm. Assume sea level pressure throughout. Determine the following. a) Show the inlet and outlet air condition clearly on the psychrometric...
The atmospheric air 32 °C dry bulb temperature and 70% relative humidity supplied to the cooling...
The atmospheric air 32 °C dry bulb temperature and 70% relative humidity supplied to the cooling coil at a rate of 45m3 /min. The air cooling to the saturated state and leaving at a temperature of 16 °C. Determine: () a- Specific humidity at each state. b- Wet bulb and dew point temperatures at the final state c- Final relative humidity. d- Mass of water condensed. e- Rate of heat removed from the air in kW. f- Show the process...
The atmospheric air 32 °C dry bulb temperature and 70% relative humidity supplied to the cooling...
The atmospheric air 32 °C dry bulb temperature and 70% relative humidity supplied to the cooling coil at a rate of 45m3 /min. The air cooling to the saturated state and leaving at a temperature of 16 °C. Determine: (10 points) a- Specific humidity at each state. b- Wet bulb and dew point temperatures at the final state c- Final relative humidity. d- Mass of water condensed. e- Rate of heat removed from the air in kW. f- Show the...
ADVERTISEMENT
Subjects
ADVERTISEMENT
Latest Questions
ADVERTISEMENT