Question

In: Civil Engineering

A pipe of diameter 350mm at one end and the diameter at the other end is...

A pipe of diameter 350mm at one end and the diameter at the other end is 200mm. The datum head is same for both ends. Calculate (i) Intensity of pressure at the smaller end if the pressure at the bigger end is 40.5 N/cm2. (ii) Determine the head loss between smaller end and bigger end. Take discharge through the pipe as 40 litres/sec. (iii) Scope for this obtained results of head loss between both ends.

Solutions

Expert Solution

Ally Wells answered 8 months ago
Next > < Previous

Related Solutions

A pipe of diameter 350mm at one end and the diameter at the other end is...
A pipe of diameter 350mm at one end and the diameter at the other end is 200mm. The datum head is same for both ends. Calculate (i) Intensity of pressure at the smaller end if the pressure at the bigger end is 40.5 N/cm2. (ii) Determine the head loss between smaller end and bigger end. Take discharge through the pipe as 40 litres/sec. (iii) Scope for this obtained results of head loss between both ends the like that only!
given a 5.0m pipe measured end to end with an inner diameter of 15cm and a...
given a 5.0m pipe measured end to end with an inner diameter of 15cm and a variable frequency mini speaker. assumed an air temperature of 30°C(hot). a. one end of the pipe is closed by taping a circular wood cylinder over the hole at one end. the wood does not go inside the pipe,it covers its the hole. compute the lowest audible resonant frequency of the pipe. b. sketch the node antinode pattern in the pipe for the resonant frequency...
A drainage pipe running under a highway is 20 meters long. One end of the pipe...
A drainage pipe running under a highway is 20 meters long. One end of the pipe is open and the other is clogged by debris. The wind blowing across the open end causes oscillations in the pipe. a) If the speed of sound on that particular day is 340 meters per second, what will be the fundamental frequency of oscillation in the pipe? b) What will be the frequency of the highest harmonic audible to the human ear. (Assume that...
A horizontal pipe with a diameter of 4 inches abruptly connects to a larger pipe of...
A horizontal pipe with a diameter of 4 inches abruptly connects to a larger pipe of 12 inches in diameter in an industrial application. The flow is turbulent and the volume flow rate is 10 ft3/s in the smaller pipe and its pressure is 75 psia. The water temperature is 70-degrees Fahrenheit and the kinetic energy correction factor is 1.06 for the inlet and outlet connection. What is the loss coefficient, KL What is the head loss in feet What...
A one-meter pipe is open at one end only. Describe the locations of the nodes and...
A one-meter pipe is open at one end only. Describe the locations of the nodes and antinodes of the pressure wave. Of the wave in air movement.
A pipe with diameter 1.8cm splits into two even diameter pipes. There is no change in...
A pipe with diameter 1.8cm splits into two even diameter pipes. There is no change in flow speed before and after the split. What are the diameters of the pipes after the split?
Question 1) As water passes from a pipe of larger diameter to a pipe of smaller...
Question 1) As water passes from a pipe of larger diameter to a pipe of smaller diameter in converging section, the static pressure: Becomes half Increases Decreases Does not change Question 2) The following reading have to be recorded from the flow measurement apparatus to calculate the mass flow rate from the venturimeter? Pressures at the inlet and exit of the venturimeter Pressures at the inlet and throat of the venturimeter The rotameter reading venturimeter The pressure at the throat...
Water flows through a cast iron pipe with a diameter of 30 mm. The pipe is...
Water flows through a cast iron pipe with a diameter of 30 mm. The pipe is inclined at an angle of 3 degrees from horizontal and is 40 m long. The water flows due to gravity only. What is the maximum volume flow rate of the water? You may ignore any minor loses.
The end of a stopped pipe is to be cut off so that the pipe will...
The end of a stopped pipe is to be cut off so that the pipe will be open. If the stopped pipe has a total length L, what fraction of L should be cut off so that the fundamental mode of the resulting open pipe has the same frequency as the fifth harmonic (n=5) of the original stopped pipe? Express your answer in terms of L.
A. Find the length of an organ pipe closed at one end that produces a first...
A. Find the length of an organ pipe closed at one end that produces a first overtone frequency of 276 Hz when air temperature is 21.3ºC . B. Find the length of an organ pipe closed at one end that produces a first overtone frequency of 276 Hz when air temperature is 21.3ºC . C. Electromagnetic radiation having a 73.8 μm wavelength is classified as infrared radiation. What is its frequency in 1013 Hz? D. Find the intensity of an...
ADVERTISEMENT
Subjects
ADVERTISEMENT
Latest Questions
ADVERTISEMENT