Given the “As Received” analysis of a coal: Sulfur = 1.52% Hydrogen&

Given the “As Received” analysis of a coal:

Sulfur = 1.52% Hydrogen = 6.36%

Carbon = 79.56% Nitrogen = 1.42%

Oxygen = 5.02% Moisture = 2.51%

Ash = 6.12%

Using the ASH AND MOISTURE FREE ANALYSIS OF THE COAL, calculate the following:

a) Theoretical O/F ratio

b) Actual A/F ratio at 20% excess air

c) Gravimetric Analysis of wet gas

d) Volumetric Analysis of dry gas

e) LHV of the fuel in kJ/kg

Expert Solution

samet mamat answered 2 years ago

When coal is burned, the sulfur present in coal is converted to sulfur dioxide (SO2), which...

When coal is burned, the sulfur present in coal is converted to sulfur dioxide (SO2), which is responsible for the acid rain phenomenon. S(s) + O2(g) → SO2(g) If 4.82 kg of S are reacted with oxygen, calculate the volume of SO2 gas (in mL) formed at 29°C and 1.16 atm. . Calculate the mass in grams of hydrogen chloride produced when 5.65 L of molecular hydrogen measured at STP reacts with an excess of molecular chlorine gas. H2(g) +...

Sulfur Determination in Coal Samples experiment i)The coal sample being used in this experiment is assumed...

Sulfur Determination in Coal Samples experiment i)The coal sample being used in this experiment is assumed to have 3% sulfur in its composition. What percent of sulfate (SO42-) is present in the coal samples? ii) Knowing the percent of assumed sulfate from above in your coal samples, what would be the concentration of sulfate (in ppm) if the sample was placed in 250 mL of water? iii) The UV-Vis spectrophotometer and the Ion Chromatograph (IC) have both been introduced in...

A coal-fired power plant proposes to burn 3% sulfur coal with a heating value of 11,000...

A coal-fired power plant proposes to burn 3% sulfur coal with a heating value of 11,000 Btu/lb. If the plant is to meet the standard of performance given by EPA New Source Performance Standards (NSPS), what percent cleanup is required for SO2? What percent sulfur could the coal contain if the standards are to be met with no clean-up devices?

A coal fired plant burns 1000 metric tons of coal per day at 2% sulfur. (...

A coal fired plant burns 1000 metric tons of coal per day at 2% sulfur. ( 1 metric ton = 1000 kg). a. What is the SO2 emission rate? b. What is the SO2 concentration 1.0 km downwind (x = 1000m)? c. 0.1 km off centerline in y direction (y = 100m)? and d. At ground level (z = 0) wind speed is 4 m/s and it’s a cloudy day? Stability =D; σy = 68m; σz = 37m

in the hydrogen sulfide ion, SH^-, there is a single sigma-bond between hydrogen and Sulfur. considering...

in the hydrogen sulfide ion, SH^-, there is a single sigma-bond between hydrogen and Sulfur. considering the atomic orbital energies, which Sulfur atomic orbital does the hydrogen 1s orbital interact with in forming this bond? explain.

combustion of coal releases sulfur dioxide into the atmosphere the following process converts this gas into...

combustion of coal releases sulfur dioxide into the atmosphere the following process converts this gas into sulfuric acid a component of acid rain. If each tonne of coal produces 1.4 x 104 L of sulfur dioxide (measured at STP)what mass of sulfuric acid can result from combustion of each tonne of coal? (1 tonne = 1000 kg)

An organic compound contains carbon, hydrogen, and sulfur. A sample of it with a mass of...

An organic compound contains carbon, hydrogen, and sulfur. A sample of it with a mass of 2.712 g was burned in oxygen to give gaseous CO2, H2O, and SO2. These gases were passed through 311.2 mL of an acidified 0.0200 M KMnO4 solution, which caused the SO2 to be oxidized to SO42-. Only part of the available KMnO4 was reduced to Mn2+. Next, 31.12 mL of 0.0300 M SnCl2 was added to 31.12 mL portion of this solution, which still...

A power plant burns 220.0 metric tons of coal that contains 2.50 % (by mass) sulfur....

A power plant burns 220.0 metric tons of coal that contains 2.50 % (by mass) sulfur. The sulfur is converted to SO2 during combustion. How many metric tons of SO2 are produced? blank.png _____ metric tons When SO2 escapes into the atmosphere it may combine with O2 and H2O, forming sulfuric acid (H2SO4) as the only product. Write a balanced equation describing this reaction - you may ignore the states of matter.How many metric tons of sulfuric acid, a component...

A power plant burns 190.0 metric tons of coal that contains 3.80 % (by mass) sulfur....

A power plant burns 190.0 metric tons of coal that contains 3.80 % (by mass) sulfur. The sulfur is converted to SO2 during combustion. How many metric tons of SO2 are produced? How many metric tons of sulfuric acid, a component of acid rain, could be produced from the quantity of SO2 calculated in Part 1?

Burning sulfur-containing coal results in the redox reactions below: HgS + O2 ----> Hg + SO2...

Burning sulfur-containing coal results in the redox reactions below: HgS + O2 ----> Hg + SO2 Hg + O2 ----> HgO Explain why burning coal may involve redox reaction?

Question