Question

In: Chemistry

A power plant burns 190.0 metric tons of coal that contains 3.80 % (by mass) sulfur....


A power plant burns 190.0 metric tons of coal that contains 3.80 % (by mass) sulfur. The sulfur is converted to SO2 during combustion.

How many metric tons of SO2 are produced? How many metric tons of sulfuric acid, a component of acid rain, could be produced from the quantity of SO2 calculated in Part 1?

Solutions

Expert Solution


Related Solutions

A power plant burns 220.0 metric tons of coal that contains 2.50 % (by mass) sulfur....
A power plant burns 220.0 metric tons of coal that contains 2.50 % (by mass) sulfur. The sulfur is converted to SO2 during combustion. How many metric tons of SO2 are produced? blank.png _____ metric tons When SO2 escapes into the atmosphere it may combine with O2 and H2O, forming sulfuric acid (H2SO4) as the only product. Write a balanced equation describing this reaction - you may ignore the states of matter.​How many metric tons of sulfuric acid, a component...
A coal fired plant burns 1000 metric tons of coal per day at 2% sulfur. (...
A coal fired plant burns 1000 metric tons of coal per day at 2% sulfur. ( 1 metric ton = 1000 kg). a. What is the SO2 emission rate? b. What is the SO2 concentration 1.0 km downwind (x = 1000m)? c. 0.1 km off centerline in y direction (y = 100m)? and d. At ground level (z = 0) wind speed is 4 m/s and it’s a cloudy day? Stability =D; σy = 68m; σz = 37m
If a coal-fired power plant burns 2 kg of coal to produce electricity, and the electricity...
If a coal-fired power plant burns 2 kg of coal to produce electricity, and the electricity is used to power an elevator motor that is 60% efficient, how high can the elevator and passengers be lifted up if their total mess is 1500 kg? and then How many human workers using muscle power('energy servants") would be needed to lift the elevator up to the same height, if they had one minute to do so? Assuming that one energy servant is...
A typical coal-fired electric generating plant will burn about 3 metric tons of coal per hour....
A typical coal-fired electric generating plant will burn about 3 metric tons of coal per hour. Most of the coal burned in the United States contains 1 to 4 % by weight sulfur in the form of pyrite, which is oxidized as the coal burns: 4FeS2(s) + 11 O2(g) = 2 Fe2O3(s) + 8 SO2(g) Once in the atmosphere, the SO2 is oxidized to SO3, which then reacts with water in the atmosphere to form sulfuric acid: SO3(g) + H2O(l)...
A coal-fired power plant proposes to burn 3% sulfur coal with a heating value of 11,000...
A coal-fired power plant proposes to burn 3% sulfur coal with a heating value of 11,000 Btu/lb. If the plant is to meet the standard of performance given by EPA New Source Performance Standards (NSPS), what percent cleanup is required for SO2? What percent sulfur could the coal contain if the standards are to be met with no clean-up devices?
1) A power plant with an efficiency of 65% combusts 500,000 metric tons (MT) of anthracite...
1) A power plant with an efficiency of 65% combusts 500,000 metric tons (MT) of anthracite coal per year to generate electricity. It has been established that this type of coal has the capacity to generate electrical energy at 19 GJ/MT. a) How much energy in GJ (giga joules) does this plant generate in one year? b) Estimate the annual emissions of criteria pollutants including SO2, NOx, PM and greenhouse gases including CO2 and CO using the appropriate emission factors...
In 1986 an electrical power plant in Taylorsville, Georgia, burned 8,376,726 tons of coal, a national...
In 1986 an electrical power plant in Taylorsville, Georgia, burned 8,376,726 tons of coal, a national record at that time. Part A Assuming that the coal was 81.4 % carbon by mass and that combustion was complete, calculate the number of tons of carbon dioxide produced by the plant during the year. In 1986 an electrical power plant in Taylorsville, Georgia, burned 8,376,726 tons of coal, a national record at that time. Part B Assuming that the coal was 2.10...
A 1000- MW power plant burns coalwith a heating value of 25000Btu/kg, a sulfur content of...
A 1000- MW power plant burns coalwith a heating value of 25000Btu/kg, a sulfur content of 2.1%, and an ash content of 8%. The plant has an overall conversion efficiency of 30%. Calculate: a. The coal consumption rate in tons/hour. b. The ash generation rate in tons/hour. c. If a wet scrubber is added to remove 98% of the SO2, find the CaO consumption rate, also in tons/hour. 1W = 3.411Btu/hr 1hp = 746W = 2545 Btu/hr Molecular weights: S...
Explain how the sulfur dioxide released in a coal-fired power plant in the U.S. can decrease...
Explain how the sulfur dioxide released in a coal-fired power plant in the U.S. can decrease the pH of a lake in Canada. Describe how nitrogen oxides form HNO3 in the atmosphere.
A power plant burns 7.3 tonnes (i.e., 7.3*1000 =7300 Kg) coal per hour and discharges the...
A power plant burns 7.3 tonnes (i.e., 7.3*1000 =7300 Kg) coal per hour and discharges the combustion products through a stack of effective stack height of 75m. The coal has a sulfur content of 4.2% and the wind velocity at the top of the stack is 6 m/sec. The atmospheric conditions are moderately stable. Answer Determine SO2 concentrations for following locations: (0,0,0); (850m, 0,0); (850m, 0,75m); (850m, 0,-75m); (-850m, 0,75m); (0, 0,75m); (850m, ?y, ?z). (ii) Determine distance from stack...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT