Question

In: Civil Engineering

A coal-fired power plant proposes to burn 3% sulfur coal with a heating value of 11,000...

A coal-fired power plant proposes to burn 3% sulfur coal with a heating value of 11,000 Btu/lb. If the plant is to meet the standard of performance given by EPA New Source Performance Standards (NSPS), what percent cleanup is required for SO2? What percent sulfur could the coal contain if the standards are to be met with no clean-up devices?

Solutions

Expert Solution


Related Solutions

A typical coal-fired electric generating plant will burn about 3 metric tons of coal per hour....
A typical coal-fired electric generating plant will burn about 3 metric tons of coal per hour. Most of the coal burned in the United States contains 1 to 4 % by weight sulfur in the form of pyrite, which is oxidized as the coal burns: 4FeS2(s) + 11 O2(g) = 2 Fe2O3(s) + 8 SO2(g) Once in the atmosphere, the SO2 is oxidized to SO3, which then reacts with water in the atmosphere to form sulfuric acid: SO3(g) + H2O(l)...
A coal fired plant burns 1000 metric tons of coal per day at 2% sulfur. (...
A coal fired plant burns 1000 metric tons of coal per day at 2% sulfur. ( 1 metric ton = 1000 kg). a. What is the SO2 emission rate? b. What is the SO2 concentration 1.0 km downwind (x = 1000m)? c. 0.1 km off centerline in y direction (y = 100m)? and d. At ground level (z = 0) wind speed is 4 m/s and it’s a cloudy day? Stability =D; σy = 68m; σz = 37m
A coal-fired power plant produces power  with costs . Each unit of power earns the plant ....
A coal-fired power plant produces power  with costs . Each unit of power earns the plant . Burning coal releases particulate matter (PM2.5), a pollutant that is known to cause heart disease, lung disease, and birth defects. The coal plant borders a wildlife sanctuary which sells tourism visits  for a price $30. However, the sanctuary's animals are getting sick due to the negative externality of PM2.5, such that the costs to the sanctuary are . The local government decides to tax the...
At a coal-fired power plant, assume that lignite coal is being burned as shown in the...
At a coal-fired power plant, assume that lignite coal is being burned as shown in the following stoichiometric combustion reaction equation, which assumes that the nitrogen in the lignite and in the air is all converted to NO and that combustion is complete: CH0.96O0.18N0.016S0.012 + x (O2 + 3.78 N2) → CO2 + 0.48 H2O + 0.016 NO + 0.012 SO2 + 3.78x N2 (a) What is the value of the coefficient, x? (b) To ensure complete combustion, air must...
Consider a coal-fired steam power plant that produces 175 MW of electric power. The power plant...
Consider a coal-fired steam power plant that produces 175 MW of electric power. The power plant operates on a simple ideal Rankine cycle with turbine inlet conditions of 7 MPa and 550°C and a condenser pressure of 15 kPa. The coal has a heating value (energy released when the fuel is burned) of 29,300 kJ/kg. Assuming that 75% of this energy is transferred to the steam in the boiler and that the pump has an efficiency of 80% and the...
A 1000- MW power plant burns coalwith a heating value of 25000Btu/kg, a sulfur content of...
A 1000- MW power plant burns coalwith a heating value of 25000Btu/kg, a sulfur content of 2.1%, and an ash content of 8%. The plant has an overall conversion efficiency of 30%. Calculate: a. The coal consumption rate in tons/hour. b. The ash generation rate in tons/hour. c. If a wet scrubber is added to remove 98% of the SO2, find the CaO consumption rate, also in tons/hour. 1W = 3.411Btu/hr 1hp = 746W = 2545 Btu/hr Molecular weights: S...
If a coal-fired power plant burns 2 kg of coal to produce electricity, and the electricity...
If a coal-fired power plant burns 2 kg of coal to produce electricity, and the electricity is used to power an elevator motor that is 60% efficient, how high can the elevator and passengers be lifted up if their total mess is 1500 kg? and then How many human workers using muscle power('energy servants") would be needed to lift the elevator up to the same height, if they had one minute to do so? Assuming that one energy servant is...
A 600 MW pulverized coal-fired power plant of 40% efficiency uses coal with an ash content...
A 600 MW pulverized coal-fired power plant of 40% efficiency uses coal with an ash content of 15% and a heating value of 26,700 kJ/kg. Assume 35% of the ash content goes up the stack as particulate matter in the flue gas. The PM emission is controlled by an ESP which has the following efficiencies and weight distribution in the given size ranges. Find the fly ash emitted in g/s.
A power plant burns 220.0 metric tons of coal that contains 2.50 % (by mass) sulfur....
A power plant burns 220.0 metric tons of coal that contains 2.50 % (by mass) sulfur. The sulfur is converted to SO2 during combustion. How many metric tons of SO2 are produced? blank.png _____ metric tons When SO2 escapes into the atmosphere it may combine with O2 and H2O, forming sulfuric acid (H2SO4) as the only product. Write a balanced equation describing this reaction - you may ignore the states of matter.​How many metric tons of sulfuric acid, a component...
A power plant burns 190.0 metric tons of coal that contains 3.80 % (by mass) sulfur....
A power plant burns 190.0 metric tons of coal that contains 3.80 % (by mass) sulfur. The sulfur is converted to SO2 during combustion. How many metric tons of SO2 are produced? How many metric tons of sulfuric acid, a component of acid rain, could be produced from the quantity of SO2 calculated in Part 1?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT