Question

In: Physics

Assume that R1 = 44 Ω , R2 = 75 Ω , R3 = 19 Ω...

Assume that R1 = 44 Ω , R2 = 75 Ω , R3 = 19 Ω , R4 = 79 Ω , R5 = 20 Ω , and R6 = 23 Ω .

fig 1

no title provided

fig 2

no title provided

fig 3

no title provided

fig 4

no title provided

Part A

Find the equivalent resistance of the combination shown in the figure (Figure 1) .

Express your answer using two significant figures.

Req =______ Ω

Part B

Find the equivalent resistance of the combination shown in the figure (Figure 2) .

Express your answer using two significant figures.

Req =______ Ω

Part C

Find the equivalent resistance of the combination shown in the figure (Figure 3) .

Express your answer using two significant figures.

Req =______ Ω

Part D

Find the equivalent resistance of the combination shown in the figure (Figure 4) .

Express your answer using two significant figures.

Req =______ Ω

Solutions

Expert Solution


Related Solutions

Three resistors have values R1= 47Ω, R2 = 100Ω, and R3 = 10 Ω. There is...
Three resistors have values R1= 47Ω, R2 = 100Ω, and R3 = 10 Ω. There is a 1.5V battery. The battery and three resistors are all connected in various circuits described below. Calculate the equivalent (or total) resistance, and any currents for each of the following configurations: A) Series circuit B) Parallel circuit C) Series-parallel combination where R1 and R2 are in parallel and that combination is in series with R3.
Three resistors have values R1= 47Ω, R2 = 100Ω, and R3 = 10 Ω. There is...
Three resistors have values R1= 47Ω, R2 = 100Ω, and R3 = 10 Ω. There is a 5V battery. The battery and three resistors are all connected in various circuits described below. Calculate the equivalent (or total) resistance, and any currents for each of the following configurations: a. series circuit b. parallel circuit c. Series-parallel combination where R1 and R2 are in parallel and that combination is in series with R3.
An experiment was set up with the circuit diagram shown. Assume R1 = 12 Ω, R2...
An experiment was set up with the circuit diagram shown. Assume R1 = 12 Ω, R2 = R3 = 6 Ω, r = 0 Ω and E = 6 V. (a) One of the steps to examine the set-up is to test points with the same potential. Which of the following points can be tested? points b, c, and dpoints d, e, and f    points f, h, and jpoints a, h, and i (b) At which three points should the currents...
let r1 and r2 be the relations represented as r1 (ABC) and r2 (ADE) .Assume the...
let r1 and r2 be the relations represented as r1 (ABC) and r2 (ADE) .Assume the corresponding domains of both the tables are same.r1 has 2000 tuples and r2 has 4500 tuples 1.common tuples between r1 and r2 are 500, what would be the resultant number of tuples for r1-r2, justify your answer 2.assuming 500 as the common tuples between r1 and r2,what is the maximum number of tuples that results in ]] A( r1) U ]] A r2. justify...
If three resistors with resistance of R1, R2, R3 are wired in parralle, their combined combined...
If three resistors with resistance of R1, R2, R3 are wired in parralle, their combined combined resitance R is given by the following formula: 1/R= 1/R1 + 1/R2 +1/R3 The design of a voltmeter requires that the resitance R2 be 80 ohms greater than the restance of R1, that the restance of R3 be 5 ohms greater than R1, and that their combined restance be 10 ohms. Find the value of each resistance. R1=________ohms R2=________ohms R3=________ohms
For three resistors, R1, R2, and R3, sketch the schematic for the circuit if all three...
For three resistors, R1, R2, and R3, sketch the schematic for the circuit if all three are connected in parallel and determine in general the equivalent resistance. For three resistors, R1, R2, and R3, sketch the schematic for the circuit if all three are connected in series and determine in general the equivalent resistance. What will the equivalent resistance be for three 300 Ohm resistors connected in parallel?
Three resistors with resistances R1, R2, R3 are connected in parallel across a battery with voltage...
Three resistors with resistances R1, R2, R3 are connected in parallel across a battery with voltage V. By Ohm’s law, the current (amps) is I = V* [ (1/R1) + (1/R2) + (1/R3) ] Assume that R1, R2, R3, and V are independent random variables where R1 ~ Normal (m = 10 ohms, s = 1.5 ohm)             R2 ~ Normal (m = 15 ohms, s = 1.5 ohm)             R3 ~ Normal (m =20 ohms, s = 1.0 ohms)...
What is the arithmetic mean for the following stock returns: R1=6.3%, R2=4%, R3=7.2%?
You bought a bond for $950 1 year ago. You have received a coupon of $60. You can sell the bond for $977 today. What is your total dollar return?What is the arithmetic mean for the following stock returns: R1=6.3%, R2=4%, R3=7.2%?
The consecutive liquid phase reactions k1 ,r1 k2 ,r2 k3 ,r3 . Estimate A −−→ B...
The consecutive liquid phase reactions k1 ,r1 k2 ,r2 k3 ,r3 . Estimate A −−→ B −−→ C −−→ D with first-order kinetics occur in a steady state CSTR. The feed composition for the CSTR is: CA0 > 0, CJ0 = 0, J = B, C, D. (a). Write mass balances for A, B, C, and D. From these, deduce that CJ’s, J = A, B, C, D, are related by a linear equation. Obtain expressions for CJ, J =...
Problem Description: Given Machine Instruction 1. LD R1, 50(R2) 2. ADD R3, R1, R4 3. LD...
Problem Description: Given Machine Instruction 1. LD R1, 50(R2) 2. ADD R3, R1, R4 3. LD R5, 100(R3) 4. MUL R6, R5, R7 5. ADD R1, R1, #100 6. SUB R2, R2, #8 Font type: Times New Roman and Size 12 Task to do: a) Draw the four-stage pipeline for the above Instruction. b) Calculate the total clock cycles for all the above-mentioned instructions need to be completed. c) Explain how to handle structural hazards the pipeline instruction. d) Explain...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT