Thermal properties A bar has an initial length of 100 mm at room temperature of 27oC....

Thermal properties

A bar has an initial length of 100 mm at room temperature of 27oC. The tensile test indicates that the bar yields when it reaches is the stress level of 145 MPa and the strain value of 2.071 x 10-3. The bar is later placed in an oven and heated from room temperature to 100 oC. The linear coefficient of thermal expansion of the material is 23 x 10-6 oC-1 at 27oC, and 34 x 10-6 oC-1 at 527oC. Determine:

a. What is the linear coefficient of thermal expansion at 100 oC?

b. What is the length of the bar in millimeter at 100 oC?

c. Does the heating from room temperature to 100 oC the cause the bar to yield

Expert Solution

The solution is shown below

If any doubts please post in comment section

samet mamat answered 1 year ago

A cylinder 100 mm in diameter and 80 mm long with an initial temperature of 527...

A cylinder 100 mm in diameter and 80 mm long with an initial temperature of 527 C is suddenly exposed to water at 27 C giving a convective heat transfer coefficient of 400 W/m2-K. Determine the temperature at the center of the cylinder after 10 minutes. Assume density is 8050 kg/m3, specific heat is 536 kJ/kg-K, and thermal conductivity is 18.6 W/m-K. **** Not lumped Capacitance Problem. ****

: A suspension of colloids at room temperature (25°C) contains CaS04 in (a) 3 mM and...

: A suspension of colloids at room temperature (25°C) contains CaS04 in (a) 3 mM and (b) 30 mM concentration. Find the Debye length (in nm) for both the cases. Use relevant data given in lecture 12-13. (c) Why do you suppose the Debye length changes with change in salt concentration? Provide reasoning from colloidal science to support your answer. (d) If NaCI was used instead of CaS04, how would the Debye length values change for cases (a) and (b)?...

A camera lens has a focal length of 100 mm (thick lens). The photographer first adjusts...

A camera lens has a focal length of 100 mm (thick lens). The photographer first adjusts the location of the lens to look at an object very far away (infinite distance). Then he tries to take a picture of a person 2 meters away from the lens. How is he going to adjust (move) the lens relative to its original position? What is the distance of the adjustment?

a) A cylindrical length of wire has a radius of 4 mm and a length of...

a) A cylindrical length of wire has a radius of 4 mm and a length of 10 cm. If the length is growing at a rate of 2 cm/sec and the radius is shrinking at a rate of 1 mm/sec, what is the rate of change of the volume in cm3/sec at that point in time. (Be careful of units) b) Consider the same length of wire as before (radius of 4 mm and length of 10 cm). This time...

A gallon of water is heated-up from room temperature (20oC) to its boiling temperature of 100...

A gallon of water is heated-up from room temperature (20oC) to its boiling temperature of 100 oC at atmospheric pressure. The water is further heated and completely transforms into vapor at which point the heating is stopped. What is the temperature of the steam? A)T=100oC B) T > 100 oC C) T < 100 oC

A steel ruler (100 mm) is used for measuring the length of a block. The ambient...

A steel ruler (100 mm) is used for measuring the length of a block. The ambient temperature is found likely to vary in between 24 °C and 25 °C. The temperature is likely to be anywhere within these limits. The temperature variation follows square distribution, with expected value to be 24.5 °C. Determine the degree of uncertainty that will be registered when measurement is done using steel scale? CTE = 11.5 x 10-6 / °C

100 people enter a room that is initially at a temperature of 15 C and pressure...

100 people enter a room that is initially at a temperature of 15 C and pressure of 1bar. Each person losses heat to the air in the room at a constant rate of 300 W at a constant temperature of 37 C. The air mass in the room is 750 Kg, remains constant and its cv = 0.79 kJ/(Kg K), cp = 1.08 kJ/(Kg K) and the gas constant is 0.287 kJ/(Kg K). Air enters the room at a temperature...

A metal bar (23.5 x 10-6oC-1) has a final length of 5.5800 m after its temperature...

A metal bar (23.5 x 10-6oC-1) has a final length of 5.5800 m after its temperature changes from 64.459 oF to -27.674 oC. a) Convert the initial temperature to oC. 18.03 21.82 20.55 16.59 11.90 26.14 In 100 words or less, explain how to calibrate a new and otherwise unmarked mercury or alcohol filled, glass thermometer.

A refrigerator has an internal temperature of 17.52oC in a room at temperature 30.63oC. It consumes...

A refrigerator has an internal temperature of 17.52oC in a room at temperature 30.63oC. It consumes an average of 305.26 W electrical power while continuously removing 405.35 W thermal (heat) from the interior to keep its insides cold. (a) What is it's ideality factor? The ideality factor is the ratio of the actual coefficient of performance of the refigerator to the maximum phyically possible. (b) If it was replaced with an idealized perfect refrigerator operating between those temperatures and still...

A camera lens has a focal length of 224.0 mm, an aperture diameter of 14 mm,...

A camera lens has a focal length of 224.0 mm, an aperture diameter of 14 mm, and the shutter speed is set to 1/10 s. What f-number setting would be required in order that the same camera sensor receive the same light intensity (brightness) if the shutter speed is now set to 1/40 s?

Question