A 6 inch diameter water main in your town has become very rough due to rust...

A 6 inch diameter water main in your town has become very rough due to rust and corrosion. It has been suggested that the flowrate through this pipe can be increased by inserting a smooth plastic liner into the pipe. Although the new diameter will be smaller, the pipe will be smoother. Will such a procedure produce a greater flowrate? List all assumptions and all calculations.

IMPORTANT NOTE: Please have the answer complete, CLEAR and computer generated!!

Expert Solution

samet mamat answered 2 years ago

Water at 68 deg F flows in a 6 inch diameter smooth pipe. What flowrate in...

Water at 68 deg F flows in a 6 inch diameter smooth pipe. What flowrate in gallons per minute is flowing if the pressure drop across a 3 in diameter long radius nozzle is .525 psi? What is the Cd (Coefficient of Discharge)? GPM>?

A solid cylinder of 6 inch diameter and 4 inch high is compressed axisymmetrically to 2...

A solid cylinder of 6 inch diameter and 4 inch high is compressed axisymmetrically to 2 inch high. a) Calculate the final diameter of the product, the three orthogonal strains and the Von Mises strain. b) Estimate the maximum total force required for this operation. Assume: coefficient of fricition 0.2; Use Ludwik's Law to find the pressure at maximum axial strain; the strength coefficient of the workpiece: K is 147 ksi, strain hardening exponent is 0.17.

A venturi tube is measuring the flow of water; it has a main diameter of 4.5...

A venturi tube is measuring the flow of water; it has a main diameter of 4.5 cm tapering down to a throat diameter of 1.1 cm . If the pressure difference is measured to be 80 mm-Hg, what is the velocity of the water?

Water flows upward and then is discharged to the right through a 3 inch diameter pipe...

Water flows upward and then is discharged to the right through a 3 inch diameter pipe elbow, at a steady flow rate of 1 cubic foot per second, the gage pressure at the entrance to the elbow is 30 psi. What vertical and horizontal force is necessary to hold the elbow stationary, neglecting any required torque.

In the plumbing of an old house water enters a copper pipe of 1 inch diameter...

In the plumbing of an old house water enters a copper pipe of 1 inch diameter and with a flow rate of 0.25 gal/s. A) After several bends the pipe reaches a joint where the diameter is reduce to 3/4 inches. What is the flow rate of water in this constricted section of pipe? B) In Which section of the pipe is the water pressure greater , where the diameter is 1 inch or 3/4 inches ?

Water flows through a 3 inch diameter pipe at a velocity of 10 ft/s. Find the...

Water flows through a 3 inch diameter pipe at a velocity of 10 ft/s. Find the a) volume flow rate in cfs(cubic feet per second) and gpm(gallons per minute) b) mass flow rate in slug/second.

Water flows between two reservoirs through 800 ft of 12-inch diameter welded-steel pipe. The water surface...

Water flows between two reservoirs through 800 ft of 12-inch diameter welded-steel pipe. The water surface elevation difference between the two reservoirs is 16 ft. Find the flowrate (a) assuming head loss is only due to pipe friction, and (b) Accounting for both friction losses and minor losses due to a flush square-edged pipe entrance, the pipe exit, and a half-open gate valve in the line. Assume the water temperature is 60°F.

A 32 inch diameter pump handling 22000 GPM flow of water coming from an atmospheric tank...

A 32 inch diameter pump handling 22000 GPM flow of water coming from an atmospheric tank storage is running at 1170 rpm. The water temperature can be taken at 25 C. The suction line is 20 meter long at 6 inch diameter. The pump suction is 0.4 meter above ground level. The tank storage is elevated on a 1 meter high platform. Assume friction factor of 0.02. Specific Gravity of water at 25 C is 0.9967. NPSH required is 34...

Define the system, control volume, and control surface for a 4-foot, 6-inch diameter section of pipe....

Define the system, control volume, and control surface for a 4-foot, 6-inch diameter section of pipe. Is the system Lagrangian or Eulerian? Why?

An aerial camera has a 9½-inch square film format and a 6-inch focal length lens. What...

An aerial camera has a 9½-inch square film format and a 6-inch focal length lens. What must the flying height (in meter) be to obtain a scale of 1/2000? (Hint: 1 inch=2.54 cm)

Question