Question

In: Chemistry

A student makes three plots of their data and finds that a plot of [A] vs...

A student makes three plots of their data and finds that a plot of [A] vs t is non-linear, a plot of ln[A] vs t is non-linear, and a plot of 1/[A] vs t is linear. What is the rate law of the reaction?

Solutions

Expert Solution


Related Solutions

Frequency Plots: a) How do you draw a frequency plot given a data set? b) What...
Frequency Plots: a) How do you draw a frequency plot given a data set? b) What information about a data set do you get from a frequency plot of that set? c) What is the difference between theoretical and experimental frequency plots? i. When is it a safe bet to say that experimental frequency plots will begin to look like theoretical frequency plots? d) How does the frequency plot relate to the cumulative distribution plot? i. How do you draw...
The yield data (kg/plot) were collected from 20 plots. Each fertilizer (A or B) was randomly...
The yield data (kg/plot) were collected from 20 plots. Each fertilizer (A or B) was randomly assigned to 10 plots. Fertilizer A 17.5 17.9 18.2 16.9 17.2 17.5 17.3 18.9 16.8 17.1 Fertilizer B 18.4 17.9 18.2 17.6 17.6 18.8 18.1 17.4 17.8 17.6 a. State the null and alternative hypotheses. b. Conduct 2 tailed, paired t-test c. Make a conclusion based on a 10% significance level. Briefly explain how do you make this conclusion.
A) What is the order of reaction for the plot above? (The plot of ln[NO2Cl] vs....
A) What is the order of reaction for the plot above? (The plot of ln[NO2Cl] vs. time in seconds gave a straight line with the equation y = −3.250 × 10−3 x − 2.947). B) What was the initial concentration of NO2Cl? (The plot of ln[NO2Cl] vs. time in seconds gave a straight line with the equation y = −3.250 × 10−3 x − 2.947). C) Write the rate law expression. (For example: Rate=k[A][B]2 [C]3 ) Note: For exponents, write...
a)Develop an estimated regression equation for the data of the form ŷ = b0+b1x. Plot the standardized residuals againstŷand the normal probability plot. Do the plots support the assumptions about ε? Explain.
x y 9 10 32 20 18 21 15 16 26 22 a)Develop an estimated regression equation for the data of the form ŷ = b0+b1x. Plot the standardized residuals againstŷand the normal probability plot. Do the plots support the assumptions about ε? Explain. b)Develop an estimated regression equation for the data of the form ŷ =b0+b1x+b2x2. Plot the standardized residuals againstŷand the normal probability plot. Do the plots support the assumptions about ε? Explain. c)Use the estimated regression equation...
In the reaction, A → Products, a plot of ln[A] vs. time is linear and the...
In the reaction, A → Products, a plot of ln[A] vs. time is linear and the slope is equal to -0.860 s-1. How long will it take one-half of the initial amount of A to react? 0.693 s 0.860 s 0.500 s 0.806 s
plot 1/Vo Vs 1/[S] (Lineweaver-Burk plot) and calculate the values of Km and Vmax from the...
plot 1/Vo Vs 1/[S] (Lineweaver-Burk plot) and calculate the values of Km and Vmax from the intercepts .Give units
why is it important to force the trendline in the plot of absorbance vs concentration through...
why is it important to force the trendline in the plot of absorbance vs concentration through the origin? Would adding the point (0,0) have had the same effect? Why or why not? how low of a concentration do you think this technique can reliably measure?
Using the data provided: Plot the data. What does the plot tell you about the appropriateness...
Using the data provided: Plot the data. What does the plot tell you about the appropriateness of using a trend and seasonally adjusted model for your data? Develop a forecast model that incorporates both a trend and seasonal adjustment (even if its not necessarily there). Develop a forecast for the four periods beyond your data. Calculate a MAD and Bias based on the last 12 periods of known data. What do the MAD and bias indicate about your model? Overall,...
1.In the labratory a student finds that it takes 120 Joules to increase the temperature of...
1.In the labratory a student finds that it takes 120 Joules to increase the temperature of 12.3 grams of solid sulfur from 22.9 to 37.3 degrees Celsius. The specific heat of sulfur calcualted from her data is ___ J/g C. 2. the labratory a student finds that it takes 89.8 Joules to increase the temperature of 10.8 grams of solid graphite from 22.9 to 35.4 degrees Celsius. The specific heat of sulfur calcualted from her data is ___ J/g C.
1A student reads a barometer in the laboratory and finds the prevailing atmospheric pressure to be...
1A student reads a barometer in the laboratory and finds the prevailing atmospheric pressure to be 746 mm Hg. Express this pressure in atmospheres, kilopascals, torrs, pounds per square inch, and pascals. Hint: 1 atm = 101.3 kPa = 760 torr = 760 mm Hg = 14.69 psi = 1.013×105 Pa mm Hg atm kPa torr psi Pa   746   2.An automobile tire is inflated to a pressure of 30.3 psi. Express this pressure in atmospheres, kilopascals, inches Hg, millimeters Hg...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT