A conical tank of diameter 6 m and height 10 m is filled with water. Compute...

A conical tank of diameter 6 m and height 10 m is filled with water. Compute for the work needed to pump all the water 2 m above the tank. The water has a density of 1000 kg per cubic meter.

Expert Solution

milcah answered 2 years ago

a) A full conical water tank has height 3 m and diameter across the top 2...

a) A full conical water tank has height 3 m and diameter across the top 2 m. It is leaking water at a rate of 10,000 cm^3 per minute. How fast is the height of the water decreasing when the volume of water is 3,000,000 cm^3 ? b) Two planes are approaching the same air traffic control tower at equal and constant altitude. Plane A is heading due north at 200 mph, while Plane B is heading due west at...

A conical tank has height 9 m and radius 4 m at the base. Water flows...

A conical tank has height 9 m and radius 4 m at the base. Water flows at a rate of 3 m^3/min. How fast is the water level rising when the level is 1 m and 2 m? (Use symbolic notation and fractions where needed.) When the water level is 1 m, the water level is rising at a rate of _ .When the water level is 2 m, the water level is rising at a rate of _.

A 4 m-wide tank with height of 1.8 m filled with water is pulled with a...

A 4 m-wide tank with height of 1.8 m filled with water is pulled with a cable inclined at 30o to the horizontal. The constant acceleration value in the cable direction is 4 m/s². The water depth is measured as 1.5 m before the motion starts.  Determine the angle between the water surface and the horizontal.  Compute the maximum and minimum pressure values on the bottom of the tank.  How many volume of water are spilled?

Consider a typical settling tank of 10 m diameter and 10 m height. Inlet pipe is...

Consider a typical settling tank of 10 m diameter and 10 m height. Inlet pipe is approximately 2 m deep from the top of the tank. Perform following preliminary calculations. a. For a water-sand flowrate of 1500 m 3 /hr with 1000 ppm of sand, calculate sand particle size than can be settled in the tank. (Water: density = 1000 kg/m3 , viscosity = 1 cP; Sand: density = 2500 kg/m3 ) (6-marks) b. Consider settling of different sizes (50,...

Water is being pumped into a leaky inverted conical tank at a rate of 10 m^3/h....

Water is being pumped into a leaky inverted conical tank at a rate of 10 m^3/h. The tank has a height of 9 m and the diameter at the top is 6 m. If the water level is rising at a rate of 0.2 m/h when the height of the water is 6 m, how fast is the water leaking out at that time?

A conical container of radius 10ft and height 40ft is filled to a height of 38...

A conical container of radius 10ft and height 40ft is filled to a height of 38 ft of a liquid weighing 62.4 lb/ft^3. How much work will it take to pump the contents to the rim? How much work will it take to pump the liquid to a level of 2 ft. above the cone's rim?

A pond 2 m in diameter is to be filled with water by a flow that...

A pond 2 m in diameter is to be filled with water by a flow that varies linearly with the level of the pond so that it reaches the maximum value of 217 lt/h when the pond is empty and is zero when the level reaches 2 m. Calculate: a) Time it takes to reach the level of 1 m. b) Time it takes to fill up completely. Discuss this last result.

The 1.3-m-diameter tank is initially filled with gasoline. There is a 3.2-cm-diameter orifice in the bottom....

The 1.3-m-diameter tank is initially filled with gasoline. There is a 3.2-cm-diameter orifice in the bottom. If the orifice is suddenly opened, estimate the time (minutes) for the fluid level to drop from 2m to 1.2 m. Use SG (gas) = 0.66, Cd = 0.63

An 800-gallon, 1.2 m wide cylindrical water tank is filled to the brim. The tank has...

An 800-gallon, 1.2 m wide cylindrical water tank is filled to the brim. The tank has a hole formed at 13.3 cm above the ground. It is observed that water leaks out of the reservoir at a speed that reduces by 3.2 m.s-1 in 1 minute 39 seconds. If the tank was initially filled to the brim how much water leaked out of the tank, and 8.2 by how much shall the point, at which water lands, change? (1 gallon...

A large storage tank with an open top is filled to a height h0. The tank...

A large storage tank with an open top is filled to a height h0. The tank is punctured at a height h above the bottom of the tank. Find an expression for how far from the tank the exiting stream lands. (Let d be the horizontal distance the stream of water travels. Use any variable or symbol stated above as necessary. ? for the density of water and g. Do not substitute numerical values; use variables only.)

Question