Question

In: Mechanical Engineering

The paper rolls, shown in the figure below, are 0.9 m OD x 0.22 m ID...

The paper rolls, shown in the figure below, are 0.9 m OD x 0.22 m ID x 3.23 m long and have a density of 984 kg/m3 . The rolls are transferred from the machine conveyor (not shown) to the forklift truck by the V-linkage of the off-loading system, which isrotated through 90o by an air cylinder. The paper then rolls onto the waiting forks of the truck.

Question: Assume that the crank arm is a solid rectangularsection. Working on a factor ofsafety of 5, determine suitable dimensions for this arm. Select (providing reasons) a material for this crank arm. b) Due the misalignment of the loading (refer 2c), the force is offset from the loading axis by 15o . Determine the bending stresses at each of the four corners of the arm cross section. Also determine the position of the neutral axis. Illustrate the stress distribution and neutral axis on a sketch of the section.

Solutions

Expert Solution


Related Solutions

A hollow cylinder of ID 0.12 m and OD 0.14082 has a heat generation rate of...
A hollow cylinder of ID 0.12 m and OD 0.14082 has a heat generation rate of 5 × 106 W/m3. The conductivity of the material is 30 W/mK. The outside surface is insulated and heat is removed by convection over the inside surface by a fluid at 130°C with a convection coefficient of 226.26 W/m2K. Determine the temperature on the outside surface.
As shown in the figure below, a box of mass m = 68.0 kg (initially at...
As shown in the figure below, a box of mass m = 68.0 kg (initially at rest) is pushed a distance d = 91.0 m across a rough warehouse floor by an applied force of FA = 226 N directed at an angle of 30.0° below the horizontal. The coefficient of kinetic friction between the floor and the box is 0.100. Determine the following. (For parts (a) through (d), give your answer to the nearest multiple of 10.) (d) work...
Two radio antennas separated by d = 272 m as shown in the figure below simultaneously...
Two radio antennas separated by d = 272 m as shown in the figure below simultaneously broadcast identical signals at the same wavelength. A car travels due north along a straight line at position x = 1 330 m from the center point between the antennas, and its radio receives the signals. Note: Do not use the small-angle approximation in this problem. (a) If the car is at the position of the second maximum after that at point O when...
As shown in the figure (Figure 1) , a superball with mass m equal to 50...
As shown in the figure (Figure 1) , a superball with mass m equal to 50 grams is dropped from a height of hi=1.5m . It collides with a table, then bounces up to a height of  hf=1.0m . The duration of the collision (the time during which the superball is in contact with the table) is tc=15ms . In this problem, take the positive y direction to be upward, and use g=9.8m/s2 for the magnitude of the acceleration due to...
For the shape shown below, calculate the moment of inertia about the x axis. (Figure 8)The...
For the shape shown below, calculate the moment of inertia about the x axis. (Figure 8)The dimensions are d1=345 mm, d2=160 mm, d3=120 mm, and r=80 mm. For the shape from Part C (shown again here for reference), calculate the moment of inertia about the y axis.(Figure 8)The dimensions
The radius of the roll of paper shown in the figure is 7.6 cm and its...
The radius of the roll of paper shown in the figure is 7.6 cm and its moment of inertia is I = 2.9 × 10-3 kg·m2. A force of 2.9 N is exerted on the end of the roll for 1.1 s, but the paper does not tear so it begins to unroll. A constant friction torque of 0.11 m·N is exerted on the roll which gradually brings it to a stop. Assume that the paper's thickness is negligible. (a)...
For the system of capacitors shown in the the figure below(Figure 1) , a potential difference...
For the system of capacitors shown in the figure below(Figure 1), a potential difference of 25.0V is maintained across ab.Part (a): What is the equivalent capacitance of this system between a and b in nF?Part (b): How much charge is stored by this system in nC?Part (c): How much charge does the 6.50 nF capacitor store in nC?Part (d): What is the potential difference across the 7.50 nF capacitor in V?
Consider the system of capacitors shown in the figure below
Consider the system of capacitors shown in the figure below (C1 = 4.00 μF,C2 = 2.00 μF). (a) Find the equivalent capacitance of the system.  (b) Find the charge on each capacitor.  (c) Find the potential difference across each capacitor (d) Find the total energy stored by the group.
​Two concentric spheres are shown in the figure below.
Two concentric spheres are shown in the figure below. The inner sphere is a solid conductor and carries a charge of +5.00 μC uniformly distributed over its outer surface. The outer sphere is a conducting shell that carries a net charge of -8.00 μC. No other charges are present. The radii shown in the figure have the values R1 = 10.0cm, R2 = 20.0cm, and R3 = 30.0 cm. (a) (10 points) Find the total excess charge on the inner and...
Find the measure of angle A in the figure shown below
Find the measure of angle A in the figure shown below
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT