A circumferential aluminum fin is attached to an electronic resistor having 1/4 inch diameter. The fin...

A circumferential aluminum fin is attached to an electronic resistor having 1/4 inch diameter. The fin is 1/8 inch long and .001 inches thick. The convective heat transfer coefficient to the surrounding media, air at 60^oF, is 10 Btu/h ft^2
oF when the fin is at 120^oF. Estimate the fin efficiency and the heat transfer from the fin.

Expert Solution

samet mamat answered 2 years ago

A solid cylinder of 6 inch diameter and 4 inch high is compressed axisymmetrically to 2...

A solid cylinder of 6 inch diameter and 4 inch high is compressed axisymmetrically to 2 inch high. a) Calculate the final diameter of the product, the three orthogonal strains and the Von Mises strain. b) Estimate the maximum total force required for this operation. Assume: coefficient of fricition 0.2; Use Ludwik's Law to find the pressure at maximum axial strain; the strength coefficient of the workpiece: K is 147 ksi, strain hardening exponent is 0.17.

A cylindrical specimen of aluminum having a diameter of 0.75 inches and a length of 8...

A cylindrical specimen of aluminum having a diameter of 0.75 inches and a length of 8 inches is deformed elastically in tension with a force of 11,000 lb. Assume the following properties: Modulus of Elasticity: 10 Mpsi; Yield Strength: 40 kpsi; Tensile Strenght: 50 kpsi; Percent Elongation: 17; Poisson's Ratio: .33 Determine the following: (a) The amount by which this specimen will elongate in the direction of the applied stress (b) The change in diameter of the specimen. Will the...

In the plumbing of an old house water enters a copper pipe of 1 inch diameter...

In the plumbing of an old house water enters a copper pipe of 1 inch diameter and with a flow rate of 0.25 gal/s. A) After several bends the pipe reaches a joint where the diameter is reduce to 3/4 inches. What is the flow rate of water in this constricted section of pipe? B) In Which section of the pipe is the water pressure greater , where the diameter is 1 inch or 3/4 inches ?

Define the system, control volume, and control surface for a 4-foot, 6-inch diameter section of pipe....

Define the system, control volume, and control surface for a 4-foot, 6-inch diameter section of pipe. Is the system Lagrangian or Eulerian? Why?

1. Given: A 4-inch cube with all 6 faces painted is cut up into 64 1-inch...

1. Given: A 4-inch cube with all 6 faces painted is cut up into 64 1-inch cubes. A cube is picked at random. What is the probability that (a) It is unpainted: ________________________________ (b) It has at most 1 face painted: _________________________

1. An 8-inch diameter (I.D.) pipe is filled to a depth equal to one-third of its...

1. An 8-inch diameter (I.D.) pipe is filled to a depth equal to one-third of its diameter. What is the area in flow? 2. Find the area of a washer formed by two concentric circles whose chord outside the small circle is 10 cm. 3. A goat is tied to a corner of a 30 ft by 35 ft building. If the rope is 40 ft. long and the goat can reach 1 ft. farther than the rope length, what...

Engine oil at a hundred degrees Fahrenheit passes through 1/8 inch diameter tube at a volume...

Engine oil at a hundred degrees Fahrenheit passes through 1/8 inch diameter tube at a volume flow rate of 50ft3/m . If the surface temperature is 150 degrees F, what is the heat transfer rate Q. Q = ?????? Btu/h. Assume a smooth surface and the tube length is 5 meters. From the book use p (density) = 54.24 lbm/ft3,, Specific heat = 0.4809 Btu/(lbm*R) R=Rankin, Thermal conductivity = k= 0.08207 Btu/(h*ft*R) u = 7.617 * 10 -2 lbm/ft*s,...

Suppose a 1-m length of aluminum wire 0.001 m in diameter is held in a horizontal...

Suppose a 1-m length of aluminum wire 0.001 m in diameter is held in a horizontal east-west position (in vertical equilibrium) by an external magnetic eld directed north of strength 1 G = 10-4 T. The density aluminum = 2:70 103 kg/m3 and the resistivity aluminum = 2:65 10?8 m. Also note the volume of a cylinder is Vcyl = r2h. (a) Find the resistance RAl of the aluminum wire. (b) Find the volume VAl of the aluminum wire. (c)...

A test was conducted on a 4-stroke four cylinder engine having 6.9 cm diameter and 8.9...

A test was conducted on a 4-stroke four cylinder engine having 6.9 cm diameter and 8.9 cm stroke. The fuel supply to the engine is 0.065 kg/min. The B.P measurements are given below with constant engine speed of 300 rpm: With all cylinder firing = 16.9 kW Cut off at 1st cylinder = 8.46 kW Cut off at 2nd cylinder = 8.56 kW Cut off at 3rd cylinder = 8.6 kW Cut off at 1st cylinder = 8.46 kW If...

Turpentine flows by gravity from tank 1 to tank 2 through 24 m of 1.5-inch diameter...

Turpentine flows by gravity from tank 1 to tank 2 through 24 m of 1.5-inch diameter commercial steel pipe. Both tanks are open to atmosphere. The tanks are large, so assume that the level of turpentine in both tanks remains the same with time. The level of tank 1 is 15 m higher than the level of tank 2 (indicated on the schematic as z1 and z2). There are two standard 90° elbows and one open gate valve in the...

Question