Question

When one action potential is traveling along an unmyelinated axon from cell body side and another action potential is traveling along the axon from synaptic terminal side, these two action potentials are going to collide with each other at the center of the axon. What is going to happen to these action potentials after the collision?

Answer 1

ans:) Brain cells called neurons send information and instructions throughout the brain and body. The information is sent via electro-chemical signals known as action potentials that travel down the length of the neuron. These neurons are then triggered to release chemical messengers called neurotransmitters which help trigger action potentials in nearby cells, and so help spread the signal all over

A neuron can receive input from other neurons via a chemical called a neurotransmitter. If this input is strong enough, the neuron will pass the signal to downstream neurons. Transmission of a signal within a neuron (in one direction only, from dendrite to axon terminal) is carried out by the opening and closing of voltage-gated ion channels, which cause a brief reversal of the resting membrane potential to create an action potential. As an action potential travels down the axon, the polarity changes across the membrane. Once the signal reaches the axon terminal, it stimulates other neurons.

For an action potential to communicate information to another neuron, it must travel along the axon and reach the axon terminals where it can initiate neurotransmitter release. The speed of conduction of an action potential along an axon is influenced by both the diameter of the axon and the axon’s resistance to current leak. Myelin acts as an insulator that prevents current from leaving the axon, increasing the speed of action potential .

A node of Ranvier is a natural gap in the myelin sheath along the axon. These unmyelinated spaces are about one micrometer long and contain voltage gated Na⁺ and K⁺ channels. The flow of ions through these channels, particularly the Na⁺ channels, regenerates the action potential over and over again along the axon. Action potential “jumps” from one node to the next in saltatory conduction. If nodes of Ranvier were not present along an axon, the action potential would propagate very slowly; Na⁺ and K⁺ channels would have to continuously regenerate action potentials at every point along the axon. Nodes of Ranvier also save energy for the neuron since the channels only need to be present at the nodes and not along the entire axon.

In a chemical synapse, the pre and post synaptic membranes are separated by a synaptic cleft, a fluid filled space. The chemical event is involved in the transmission of the impulse via release, diffusion, receptor binding of neurotransmitter molecules and unidirectional communication between neurons.

Neurotransmission at a chemical synapse begins with the arrival of an action potential at the presynaptic axon terminal. When an action potential reaches the axon terminal, it depolarizes the membrane and opens voltage-gated Na⁺ channels. Na⁺ ions enter the cell, further depolarizing the presynaptic membrane. This depolarization causes voltage-gated Ca²⁺ channels to open. Calcium ions entering the cell initiate a signaling cascade. A calcium sensing protein binds calcium and interacts with SNARE proteins. These SNARE proteins are involved in the membrane fusion. The synaptic vesicles fuse with the presynaptic axon terminal membrane and empty their contents by exocytosis into the synaptic cleft. Calcium is quickly removed from the terminal.

This is the final result of collosion.