Question

In: Mechanical Engineering

During an experiment to simple vapour compresion cycles in the HVAC lab at Faculty of Engineering,...



During an experiment to simple vapour compresion cycles in the HVAC lab at Faculty of Engineering, Rabigh , the following data are obtained:-
• The temperature enter to the compressor is "saturated vapor condition".
• The temperature exit the compressor is 55 0C.
• The temperature enter to the expansion device is 18.5 0C.
• The evaporator gauge pressure is 3.05 bar.
• The condenser gauge pressure is 10.7 bar.
• The volume flow rate at the evaporator entrance is 1.5 lit,/min
Complete the thermos-fluid Lab. Experiment #1 (attached file) that include the following exercises:-
Exercise No.1
Representation of the refrigeration cycle on the p-h diagram
Complete the table for inlet and exit conditions from each component (compressor, condenser, expansion device, and evaporator).
.
Exercise No.2
Energy analysis of compressor

Exercise No.3
Energy analysis of condenser

Exercise No.4
Energy analysis of evaporator

Exercise No.5
Calculate the coefficient of performance and refrigeration capacity?

Solutions

Expert Solution


Related Solutions

If you were the Head of Engineering Faculty, comment on the suitability and the eligibility of...
If you were the Head of Engineering Faculty, comment on the suitability and the eligibility of TzeMay to the position based on her personality traits.
Lab Report-Simple Pendulum- Physics 1401 and 2425 Describe and perform an experiment to investigate the relationship...
Lab Report-Simple Pendulum- Physics 1401 and 2425 Describe and perform an experiment to investigate the relationship between the length of a simple pendulum -l and its oscillation period- T . Your lab report will be graded using the following rubric. Use paragraph form rather than bullet points. I. Explanation of Issues: a. Introduction/Hypothesis 20p i. State your hypothesis. Formulate what you expect the experiments to show. ii. Identify the measurable quantities in each of your experiments. iii. Introduce/define the major...
Lab Report-Simple Pendulum- Physics 1401 and 2425 Describe and perform an experiment to investigate the relationship...
Lab Report-Simple Pendulum- Physics 1401 and 2425 Describe and perform an experiment to investigate the relationship between the length of a simple pendulum -l and its oscillation period- T . Your lab report will be graded using the following rubric. Use paragraph form rather than bullet points. I. Explanation of Issues: a. Introduction/Hypothesis 20p i. State your hypothesis. Formulate what you expect the experiments to show. ii. Identify the measurable quantities in each of your experiments. iii. Introduce/define the major...
(a) The students from the Faculty of Computing will go for an internship during the last...
(a) The students from the Faculty of Computing will go for an internship during the last semester. Each student has information including the student ID, name, phone number, email, and address. All students need to find at least one company before going for an internship. Although they get many offers from companies, the student needs to choose only one company for their internship. Each company has the company ID, company name, company email, company address, company phone number, and company...
This is a Lab Report about an experiment. The experiment should be about HEAT and TEMPERATURE...
This is a Lab Report about an experiment. The experiment should be about HEAT and TEMPERATURE with any example. Title: Hypothesis: Statement that the experiment is going to test, prove, or disprove. What is the point of the experiment? (Make a statement that the experiment will either prove or disprove.) Overview: Brief summary of what occurred in the experiment or what was tested and how. Uncertainty&Error: Can you trust your data? Considerations: 1) What factors may have affected or biased...
CyberRat experiment lab #2  on stimulus presentation
CyberRat experiment lab #2  on stimulus presentation
There is only an Experiment 1 in this lab. Experiment 1: Double Replacement Precipitation Reaction between...
There is only an Experiment 1 in this lab. Experiment 1: Double Replacement Precipitation Reaction between Calcium Chloride and Sodium Carbonate In this experiment you will precipitate calcium carbonate from the reaction between sodium carbonate and calcium chloride. The reaction is: Procedure Place a weigh boat on the scale. Once you have the mass of your weigh boat, press the button on the right hand side (0/T). Your scale should now read 0.0 g.Use your metal spatula to weigh out...
Database Systems Lab Exercises Create a table Faculty based on the following chart: Column Data type...
Database Systems Lab Exercises Create a table Faculty based on the following chart: Column Data type Constraints Faculty_Id Number (6) Primary Key => faculty_pk Last_Name Varchar2(15) Not NULL First_Name Varchar2(15) Not NULL Dept Char(3) Save the SQL statement as ex1.sql. Confirm and validate the creation of the new table. Create a table Dept based on the following chart: Column Data type Constraints Dept_Code Char (3) Primary Key => dept_pk Dept_Name Varchar2(20) Not NULL Save the SQL statement as ex2.sql. Confirm...
in a lab experiment to test the change in temperature of NaCl and the change in...
in a lab experiment to test the change in temperature of NaCl and the change in temperature of water: Specific heat of NaCl is 0.88 specific heat of DI water is 4.2 in the experiment, the change in temperature for the water was much greater than the change in temperature of the table salt as well as the change in energy. (when using equation E = g C × change in T) why did this occur?
LAB: The purpose of this experiment is to study the conditions that must be satisfied for...
LAB: The purpose of this experiment is to study the conditions that must be satisfied for a rigid object to be in static equilibrium. This is done by computing the total torque acting on a meter stick by means of weights suspended at specific locations on the ruler. If a baseball bat (thicker on one side than the other) is cut at the location where it balances, with both side be of equal weight? Can the meter stick be balanced...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT