Suppose that the specification limits for a production process
are LSL = 0.02 and USL = 0.10, with the nominal specification being
0.06.
a)_____________ What is the sigma level if the process standard
deviation is 0.01.
b)_____________ If the process is centered, what is the
DPMO?
A process has a Cpk = 1.35 and is centered between the
specification limits. (a) What is the DPM of the process? (b) If
the mean of the process increases by 1.5σ the DPM would be?
A process is in control and normally distributed with ?
control chart limits of 45 and 15. The subgroup size is 4. Suppose
the process variance suddenly triples while process mean remains
unchanged. What is the probability that the first subsequent
subgroup average will fall outside the control limits? What are the
? probability and ARL? Suppose the process variance suddenly
triples while process mean shifts downward to 10. What are the β
probability and ARL now?
Suppose that a control chart is used to monitor ? ̅ where the
control limits are set to 3?? ̅ and the warning limits are set to
2?? ̅. Answer the following: (a) If the false alarm cost per
occurrence is $1000. What is the expected false alarm cost every
100 samples. (b) If the warning inspection cost is $100. What is
the expected warning inspection cost every 100 samples. (c) Suppose
the current sample size of 10 is quadrupled,...
The upper and lower control limits on control charts are usually
set at a distance of +/- three times the standard deviation from
the center line of the control chart. Use independent research to
find the reasons why. Make sure you use the concept of type I and
type II error in your discussion. Under what circumstances might a
manager consider the use of limits at two times the standard
deviation. What should the manager keep in mind when setting...
Which of the following statements about the upper and lower
control limits of a control chart is true?
Group of answer choices
The upper and lower control limits for a p chart depend on the
sample size.
The lower control limit of a p chart will ALWAYS be a negative
value.
The upper control limit of an X-bar chart does NOT depend on the
average range R-bar.
The upper and lower control limits of an R chart are always the...
Briefly discuss the prevention of contamination and the
restriction of growth in the control microbial contamination of
products and processing environments.
a process in statistical control has a mean of .3119
and specification limit of .307 to .317. if the standard deviation
of the process is .0013, what percent of the process output is
expected to be below the specification limit?
Briefly discuss the seven broad principles of internal control.
At what stage in the development of a business do internal control
procedures become especially critical?