Question

In: Physics

For an electrical power plant of your choice: (a) How would the thermal efficiency change if...

For an electrical power plant of your choice:

(a) How would the thermal efficiency change if T-Low were decreased by one degree while keeping T-High constant? Assume Carnot cycle.

(b) How would the change in the thermal efficiency (resulting from the lower T-Low) affect W-net? Assume a thermal efficiency of 32.5 % and a capacity factor of 100 %, and give your answer in kWh per year.

(c) What would the difference in revenue (in $) be per year? Take 12.5 cent/kWh.

Solutions

Expert Solution

You need to provide the value for Qh and Th.

a.

b.

c.


Related Solutions

a.) What is the thermal efficiency of a steam power plant operating on the Rankine cycle...
a.) What is the thermal efficiency of a steam power plant operating on the Rankine cycle if saturated steam is supplied to the turbine at 1000 psia, and the condenser is at 1 psia. Use a turbine efficiency of 95% and a pump efficiency of 85%. Refer to Chapter 9, Sections 10-11, as necessary. b.) Determine the thermal efficiency if the steam is superheated to 1000 F, assuming all else equal.
A 1000 MW power plant of 35% thermal efficiency is proposed. The plant burns 3% sulphur...
A 1000 MW power plant of 35% thermal efficiency is proposed. The plant burns 3% sulphur coal with a heating value of 6000 Kcal/kg and emits 64000 m3/min of flue gas. What is the concentration of SO2 in the flue gas in ppm? Assume that the density of SO2 is 1920 g/m3.
A 400-MW steam power plant, which is cooled by a nearby river, has a thermal efficiency...
A 400-MW steam power plant, which is cooled by a nearby river, has a thermal efficiency of 33 percent. (i) Sketch an appropriate illustration for this heat engine clearly showing the heat source and sink. (ii) Determine the rate of heat transfer to the river water. (iii) Will the actual heat transfer rate be higher or lower than this value? Why?
1. The thermal efficiency of a Rankine power cycle may be improved by i. Superheating the...
1. The thermal efficiency of a Rankine power cycle may be improved by i. Superheating the steam ii. Reheating the steam between high and lower pressure sections of the turbine iii. Regenerative Feedwater Heating iv. Insulating the turbine and decreasing the entropy production during the expansion process v. Incorporating a Rankine cycle power system as part of a cogeneration system a. Items i), ii), and iv) only b. Items i), iii), and v) only c. Items ii), iv) and v)...
1. The thermal efficiency of a Rankine power cycle may be improved by i. Superheating the...
1. The thermal efficiency of a Rankine power cycle may be improved by i. Superheating the steam ii. Reheating the steam between high and lower pressure sections of the turbine iii. Regenerative Feedwater Heating iv. Insulating the turbine and decreasing the entropy production during the expansion process v. Incorporating a Rankine cycle power system as part of a cogeneration system a. Items i), ii), and iv) only b. Items i), iii), and v) only c. Items ii), iv) and v)...
A nuclear power plant has an overall efficiency of 31% and a power output of 800MW....
A nuclear power plant has an overall efficiency of 31% and a power output of 800MW. For one year operating at full capacity, calculate a) the number of joules produced; b) the number of fission events that were required to produce those joules; c) the mass of uranium oxide (UO2) that has been used in fission; and d) the market cost of that uranium oxide if it was all high quality.
Design a steam power cycle that can achieve a cycle thermal efficiency of at least 40%...
Design a steam power cycle that can achieve a cycle thermal efficiency of at least 40% under the conditions that all turbines have isentropic efficiencies of 80% and all pumps have isentropic efficiencies of 65%. Prepare an engineering report describing your design. Your design report must include, but is not limited to, the following: 1. Discussion of various cycles attempted to meet the goal as well as the positive and negative aspects of your design. 2. System figures and T-s...
Taichung thermal power station wants to change their steam generator with a new steam generator that...
Taichung thermal power station wants to change their steam generator with a new steam generator that has a better efficiency. The existing steam generator operating with Rankine cycle with reheat and has a thermal efficiency of 30%. Taichung thermal power station has been offered by Patron Company that supplies new steam generators that are more environmentally friendly. The specifications of the new steam generator are as follow: maximum pressure is 15MPa, minimum pressure is 10kPa Temperature entering the turbine is...
Taichung thermal power station wants to change their steam generator with a new steam generator that...
Taichung thermal power station wants to change their steam generator with a new steam generator that has a better efficiency. The existing steam generator operating with Rankine cycle with reheat and has a thermal efficiency of 30%. Taichung thermal power station has been offered by Patron Company that supplies new steam generators that are more environmentally friendly. The specifications of the new steam generator are as follow: maximum pressure is 15MPa, minimum pressure is 10kPa Temperature entering the turbine is...
A nuclear power plant operates at 40.0% efficiency with a continuous production of 1202 MW of...
A nuclear power plant operates at 40.0% efficiency with a continuous production of 1202 MW of usable power in 1.00 year and consumes 1.23×106 g of uranium-235 in this time period. What is the energy in joules released by the fission of a single uranium-235 atom?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT