Question

In: Chemistry

a stream consisting of 44.6 mole% benzene and 55.4% toluene is fed at a constant rate...

a stream consisting of 44.6 mole% benzene and 55.4% toluene is fed at a constant rate to a process unit that produces two product streams, one a vapor and the other a liquid. The vapor flow rate is initially zero and asymptotically approaches half of the molar flow rate of the feed stream. Throughout this entire period, no material accumulates in the unit. When the vapor flow rate has become constant, the liquid is analyzed and found to be 28.0 mole% benzene.

(a)  

Sketch a plot of liquid and vapor flow rates versus time from startup to when the flow rates become constant.

(b)  

Is this process batch or continuous? Is it transient or steady-state before the vapor flow rate reaches its asymptotic limit? What about after it becomes constant?

(c)  

For a feed rate of 100 mol/min, draw and fully label a flowchart for the process after the vapor flow rate has reached its limiting value, and then use balances to calculate the molar flow rate of the liquid and the composition of the vapor in mole fractions.

Solutions

Expert Solution

queen_honey_blossom answered 2 years ago
Next > < Previous

Related Solutions

A benzene/toluene liquid mixture consisting of 31 mole% benzene is fed to a reboiler, where 1250...
A benzene/toluene liquid mixture consisting of 31 mole% benzene is fed to a reboiler, where 1250 KW of heat is provided causing the mixture to partially vaporize. The vapor output has a flowrate of 80 kmol/hr and consists of 40 mole% benzene. The liquid output has a flowrate of 100 kmol/hr. The two output streams are in equilibrium and exit the reboiler at 130 oC. Determine the temperature of the feed stream. Neglect the effect of pressure and consider the...
In the hydrodealkylation of toluene to produce benzene, a stream of toluene is mixed with a...
In the hydrodealkylation of toluene to produce benzene, a stream of toluene is mixed with a recycle stream and enters a reactor along with a stream of pure hydrogen. The reaction products at 530°C enter a condenser where they are cooled to 45.0°C. A vapor stream containing 0.55 mol CH4/mol leaves the process, and a liquid stream containing 0.75 mol benzene/mol and 0.25 mol toluene/mol enters a distillation column. The distillate of the column leaves the process at 800.0 mol/hr...
A stream containing toluene (T), heptane (H) and benzene (Z) is fed into a distillation column...
A stream containing toluene (T), heptane (H) and benzene (Z) is fed into a distillation column at a rate of 200kmol/hr. The composition of the feed has molar fractions for T of 0.4, H of 0.2, Z of 0.4. The amount of toluene in the bottoms is 60% the amount of toluene in the distillate. The molar fraction of hexane in the bottom stream is 1/21 and the molar fraction of benzene in the distillate is 2/19. Solve for the...
Toluene Chiller A stream of liquid toluene at 100°C is fed to a chiller at a...
Toluene Chiller A stream of liquid toluene at 100°C is fed to a chiller at a flow rate of 4.00 kg/min. The stream exits the chiller at 15°C. The heat capacity for liquid toluene can be estimated from the following equation (Cp in kJ/(mol*°C) and T in °C): = 0.1488 + (32.4 10−5) a) Draw a flow sheet for this problem, labeling all known variables; b) State assumptions required to solve the energy balance; c) Write the mass balance for...
one mole of a liquid solution containing 60.0 mole% benzene and the remainder toluene enters a...
one mole of a liquid solution containing 60.0 mole% benzene and the remainder toluene enters a flash column.The liquid product stream contains 47.0 mole% benzene and the vapor product stream contains 69.0 mole % benzene.The temperature of both output stream is at 93oC.If the operation is adiabatic,what is the temperature of the input stream that enters the flash column?
A mixture of benzene and toluene is in equilibrium with its vapor at 50oC. What mole...
A mixture of benzene and toluene is in equilibrium with its vapor at 50oC. What mole fraction of benzene is in the vapor phase? You may assume that this system follows Raoult's Law. Note: when solving Antoine's equation it is best to keep all sig figs through calculation and then truncate them at the end. Question options: 0.687, 0.807, 0.572, 0.614, 0.746, 0.913
A mixture of benzene and toluene is in equilibrium with its vapor at 50oC. What mole...
A mixture of benzene and toluene is in equilibrium with its vapor at 50oC. What mole fraction of benzene is in the vapor phase? You may assume that this system follows Raoult's Law. Note: when solving Antoine's equation it is best to keep all sig figs through calculation and then truncate them at the end.
An equimolar liquid mixture of benzene and toluene at 10C is fed continuously to a vessel...
An equimolar liquid mixture of benzene and toluene at 10C is fed continuously to a vessel in which mixture is heated to 50C. The liquid product is 40 mole%B and the vapor product is 68.4% B. How much heat must be transferred to the mixture per mol of feed?
An equimolar liquid mixture of Benzene (B) and Toluene (T) at 20oC is fed continuously to...
An equimolar liquid mixture of Benzene (B) and Toluene (T) at 20oC is fed continuously to a flash drum in which is heated to 60 oC. The liquid product is 40 mole % B and the vapour product is 60 mole % B. How much heat must be transferred to the mixture 100 mol of feed.
1. Consider a feed containing benzene, toluene, and cumene with mole fractions of 0.25, 0.5, and...
1. Consider a feed containing benzene, toluene, and cumene with mole fractions of 0.25, 0.5, and 0.25, respectively. The relative volatilities of these components with respect to toluene is 2.25, 1,and 0.21. If the fractional recovery of benzene in the distillate is 0.9 and that of toluene in the bottoms is 0.9, solve for the component flow rates in the bottoms and distillate using the Fenske equation. Assume that the feed flow rate is 100 kmol/hr. 2. Assume that the...
ADVERTISEMENT
Subjects
ADVERTISEMENT
Latest Questions
ADVERTISEMENT