Design a half wave rectifier where the input source is 220 Vrms, frequency 50Hz, the load...

Design a half wave rectifier where the input source is 220 Vrms, frequency 50Hz, the load is 20Ω. Determine the following , in order to have ∆Vo =1%.

Find the equation for the output voltage.
Find the Fourier series for the output before adding a capacitor to the circuit.
Find the equation for the output current after adding the capacitor.
Find the capacitor in order to meet this specification.

and this all information for this question

Expert Solution

In the half wave rectifier the output can be calculated by using fourier series

genius_generous answered 2 years ago

Given an unfiltered half-wave rectifier circuit with an input ac voltage of 115 Vrms

Given an unfiltered half-wave rectifier circuit with an input ac voltage of 115 Vrms, a turns ratio of 4:1 (Npri:Nsec) and a load resistance of 50 Ω. Determine (a) peak value of the primary voltage, (b)peak value of the secondary voltage, (c) peak value of the load voltage, (d) dc load voltage, and (e) dc load current.

In a half-wave rectifier, the amplitude of the positive half of the input waveform and the...

In a half-wave rectifier, the amplitude of the positive half of the input waveform and the output waveform differ slightly in reading. What accounts for the difference in value and why?

An Uncontrolled Full-Wave full-bridge rectifier with RL-Source load and Discontinuous load current is to be designed...

An Uncontrolled Full-Wave full-bridge rectifier with RL-Source load and Discontinuous load current is to be designed based on the following assumptions and constraints. Design the circuit and calculate the parameters of the rectifier based on the following assumptions and constraints. Simulate the designed rectifier in PsPice and compare the simulated and the calculated results. a) The AC source is 220 V rms at 50 Hz. Vdc= 65 V, power absorbed by the resistor is 360 W. b) The AC source...

Design and simulate a Half and Full wave rectifier for a 12V AC supply with 60...

Design and simulate a Half and Full wave rectifier for a 12V AC supply with 60 Hz frequency. Please use online multisim and calculation

A 3.5 current source is connected to a 220 ohms load. The source resistance is 6kohms....

A 3.5 current source is connected to a 220 ohms load. The source resistance is 6kohms. Solve for the equivalent voltage source (E and Rs) for this practical source.

For a single phase bridge rectifier, the source is 200Vrms/60sssHz. The load is 2000W. the winding...

For a single phase bridge rectifier, the source is 200Vrms/60sssHz. The load is 2000W. the winding resistances of the transformer secondary is 0.5Ω and the forward drop resistance of each of the used diodes is 0.2 Ω. 1. What would be the load resistance. 2. Calculate the following: o TUF o Rectifier power efficiency o Rectification efficiency o Input power factor 3. Simulate the circuit and show the following: o Input and output voltage and current waveforms o Diode current...

Source Problem: Design a grounded-load v-I converter that converts a 0V to 10V input to a...

Source Problem: Design a grounded-load v-I converter that converts a 0V to 10V input to a 4mA to 20mA output. The circuit is to be powered from +/-15V regulated supplies. My Question: What does it mean by a grounded-load? I am not really familiar with this term.

Derive the equations (for average value of load voltage) of three phase half controlled rectifier and...

Derive the equations (for average value of load voltage) of three phase half controlled rectifier and three phase full controlled rectifier ?

For a power supply with full wave bridge rectifier, input voltage is 230 V and required...

For a power supply with full wave bridge rectifier, input voltage is 230 V and required output voltage is 12 V DC Load resistance is of 100 . Determine output rms voltage, dc current, rms current, power, ac power, efficiency of the rectifier, form factor, ripple factor, transformer utilization factor, and size of the transformer Draw complete diagram of the supply circuit

A battery charger with a series resistor is somewhat like a half-wave rectifier. Explain its operation.

Question