Question

In: Physics

If the temperature stayed the same but the dew point decreased, would the lifted condensation level...

If the temperature stayed the same but the dew point decreased, would the lifted condensation level (LCL) height increase or decrease? (ii) If the temperature decreased, but the dew point stayed the same, would the LCL height increase or decrease? (iii) Based on your answers above, how does relative humidity relate to the LCL height? Explain your answer.

Solutions

Expert Solution

The lifted condensation level or lifting condensation level (LCL) is formally defined as the height at which the relative humidity (RH) of an air parcel will reach 100% with respect to liquid water when it is cooled by dry adiabatic lifting. The RH of air increases when it is cooled, since the amount of water vapor in the air (i.e., its specific humidity) remains constant, while the saturation vapor pressure decreases almost exponentially with decreasing temperature. If the air parcel is lifting further beyond the LCL, water vapor in the air parcel will begin condensing, forming cloud droplets. (In the real atmosphere, it is usually necessary for air to be slightly supersaturated, normally by around 0.5%, before condensation occurs; this translates into about 10 meters or so of additional lifting above the LCL.) The LCL is a good approximation of the height of the cloud base which will be observed on days when air is lifted mechanically from the surface to the cloud base (e.g., due to convergence of airmasses).


Related Solutions

The dew point depression (Tdd) is defined as the difference between the temperature and dew point...
The dew point depression (Tdd) is defined as the difference between the temperature and dew point temperature at a given level: Tdd = T – Td. Using the expression given in lecture (slide 19 of lecture 4), plot on a graph the height of the LCL (Liding Condensation  level) (y-axis; units of km) vs. the surface dew point depression (x-axis; units of ˚C). Do this for dew point depression values ranging from 0˚C to 15˚C. You may code this or do...
How would you determine whether the morphological diversity of animals has increased, decreased, or stayed the...
How would you determine whether the morphological diversity of animals has increased, decreased, or stayed the same since the Cambrian? Explain what kind of data you would collect, how you would analyze it, and what sorts of biases you might need to correct for. Choose three species of wild organisms (not domesticated species or humans) and predict how their populations and geographic ranges will change in the future, assuming that global climate change continues at its current rate. please answer...
Calculate the dew point temperature (to the nearest ºC); the corresponding vapor pressures of ethanol and...
Calculate the dew point temperature (to the nearest ºC); the corresponding vapor pressures of ethanol and methanol (units of mm Hg); and the equilibrium liquid molar compositions associated with a saturated vapor mixture containing 30% by mole ethanol and the balance methanol. Pressure of the system is 1 atm(abs).
Air entering a dryer has a temperature (dry bulb) of 60°C and a dew point of...
Air entering a dryer has a temperature (dry bulb) of 60°C and a dew point of 26.7°C. Using the humidity chart, determine the actual humidity H, percentage humidity HP, humid heat cS and humid volume vH.
A8. For air with temperature and dew-point values given below in °C, find the LCL value...
A8. For air with temperature and dew-point values given below in °C, find the LCL value (km). T, Td T, Td a. 15, 12 g. 5, 4 b. 15, 10 h. 5, 0 c. 15, 8 i. 5, –5
Air enters a counter-flow drier at 70˚C dry bulb temperature and 20˚C dew point temperature. Air...
Air enters a counter-flow drier at 70˚C dry bulb temperature and 20˚C dew point temperature. Air leaves the drier at 40˚C and 60% relative humidity. The initial moisture content of the product is 82% (wet basis). The amount of air moving through the drier is 2000kg of dry air per hour. The mass flow rate of the product is 10kg dry solid per hour. What is the final moisture content of the dried product in wet basis?
Air enters a counter-flow drier at 70˚C dry bulb temperature and 20˚C dew point temperature. Air...
Air enters a counter-flow drier at 70˚C dry bulb temperature and 20˚C dew point temperature. Air leaves the drier at 40˚C and 60% relative humidity. The initial moisture content of the product is 82% (wet basis). The amount of air moving through the drier is 2000kg of dry air per hour. The mass flow rate of the product is 10kg dry solid per hour. What is the final moisture content of the dried product in wet basis?
The dew-point temperature of a gas mixture with a molar composition of 40.0% n-hexane, 25.0% n-heptane,...
The dew-point temperature of a gas mixture with a molar composition of 40.0% n-hexane, 25.0% n-heptane, and 35.0% air at 1.00 atm.
Assuming standard atmospheric pressure and tdb=25 C and 90% RH. Compute (a) dew point temperature (b)...
Assuming standard atmospheric pressure and tdb=25 C and 90% RH. Compute (a) dew point temperature (b) specific humidity (c) enthalpy (d) wet bulb temperature
Post a comment I would support Beverly's point of view, and would also express the same...
Post a comment I would support Beverly's point of view, and would also express the same concern he has regarding the growing obsolescence inventory. This problem could affect economically to a company like Bright-lite and reduced their profits because this is money that the company is loosing just by the inventory sitting in the factory. I think the company should focus in efficiently fulfill customer orders quickly, minimize the obsolescence inventory and create strategies to move this inventory at reduced...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT