Question

In: Physics

Voltage, Current, Resistance The rod shown below is made of two materials. The figure is not...

Voltage, Current, Resistance

The rod shown below is made of two materials. The figure is not drawn to scale. Each conductor has a square cross section 10.00 mm on a side. The first material has a resistivity of 4.00×10-8Ω∙m and is 50.0 cm long, while the second material has a resistivity of 6.00×10-8 Ω · m and is 80.0 cm long. If a potential difference of 100V is applied between the front and the back faces, determine the following physical quantities:

  1. total amount of charge that would pass through the rod in 1minute.
  2.             The current density passing through each section.
  3.             The electric field inside the rod
  4. Determine the drift speed of the charges through each side if the left and the right sides carry 4×10^28 and 8×10^28 free electrons per cubic meter.

Solutions

Expert Solution

genius_generous answered 2 years ago
Next > < Previous

Related Solutions

The rod shown below is made of two materials. The figure is not drawn to scale....
The rod shown below is made of two materials. The figure is not drawn to scale. Each conductor has a square cross section 10.00 mm on a side. The first material has a resistivity of 4.00×10-8Ω∙m and is 50.0 cm long, while the second material has a resistivity of 6.00×10-8 Ω · m and is 80.0 cm long. If a potential difference of 100V is applied between the front and the back faces, determine the following physical quantities: total amount...
Two balls connected by a rod, as shown in the figure below (Ignore rod’s mass).
Two balls connected by a rod, as shown in the figure below (Ignore rod’s mass). Mass of ball X is 8kg and the mass of ball Y is 5 kg  What is the moment of inertia of the system about AB?   
The loop in the figure has an induced current as shown. The loophas a resistance...
The loop in the figure has an induced current as shown. The loop has a resistance of 0.30 Ω .(Figure 1)The figure shows a square loop with two horizontal and two vertical sides. The loop has side of 8.0 centimeters. The current of 150 milliamperes flows through the loop counterclockwise. Magnetic field inside the loop is directed into the page.Part AIs the magnetic field strength increasing or decreasing?Is the magnetic field strength increasing or decreasing?Part BWhat is the rate of...
Two balls connected by a rod as shown in the figure below (Ignore rod’s mass). What is the moment of inertia of the system?
  Two balls connected by a rod as shown in the figure below (Ignore rod’s mass). What is the moment of inertia of the system? Given :  mX = 400 grams = 0.4kg   mY = 500 grams = 0.5 kg   rX = 0cm = 0m   rY = 30cm = 0.3m
What is the equivalent resistance for the circuit shown in the figure? (Figure 1) For the...
What is the equivalent resistance for the circuit shown in the figure? (Figure 1) For the circuit shown in the figure, find the current through resistor R1=6.0?(left). (Figure 1) For the circuit shown in the figure, find the potential difference across resistor R1=6.0?(left). For the circuit shown in the figure, find the current through resistor R2=15?. For the circuit shown in the figure, find the potential difference across resistor R2=15?. For the circuit shown in the figure, find the current...
A 3 kg collar slides with frictionless along a vertical rod is shown in below Figure....
A 3 kg collar slides with frictionless along a vertical rod is shown in below Figure. The spring is under-formed when the collar A is at the same elevation as point O. The collar is released from rest at y1 = 0.4 m. Determine the velocities of the collar as it first passes a) y2 = 0.0 m, and b) y3 = − 0.4m
​Two concentric spheres are shown in the figure below.
Two concentric spheres are shown in the figure below. The inner sphere is a solid conductor and carries a charge of +5.00 μC uniformly distributed over its outer surface. The outer sphere is a conducting shell that carries a net charge of -8.00 μC. No other charges are present. The radii shown in the figure have the values R1 = 10.0cm, R2 = 20.0cm, and R3 = 30.0 cm. (a) (10 points) Find the total excess charge on the inner and...
When a magnet is plunged into a coil at speed v, as shown in the figure, a voltage is induced in the coil and a current flows in the circuit.(Figure 1)
When a magnet is plunged into a coil at speed v, as shown in the figure, a voltage is induced in the coil and a current flows in the circuit. (Figure 1) Part A If the speed of the magnet is doubled, the induced voltage is ________. a.) twice as great b.) four times as great c.) half as great d.) unchanged  
When a magnet is plunged into a coil at speed v, as shown in the figure, a voltage is induced in the coil and a current flows in the circuit.(Figure 1)
When a magnet is plunged into a coil at speed v, as shown in the figure, a voltage is induced in the coil and a current flows in the circuit. (Figure 1) Part A If the speed of the magnet is doubled, the induced voltage is ________. a.) twice as great b.) four times as great c.) half as great d.) unchanged  
Two identical uniform solid spheres are attached by a solid uniform thin rod, as shown in the figure.
Two identical uniform solid spheres are attached by a solid uniform thin rod, as shown in the figure. The rod lies on a line connecting the centers of mass of the two spheres. The axes A, B, C, and D are in the plane of the page (which also contains the centers of mass of the spheres and the rod), while axes E and F (represented by black dots) are perpendicular to the page. (Figure 1).Rank the moments of inertia...
ADVERTISEMENT
Subjects
ADVERTISEMENT
Latest Questions
ADVERTISEMENT