Question

In: Mechanical Engineering

Cold air at temperature of 10 C and velocity of 3 m/s is moving parallel to...

Cold air at temperature of 10 C and velocity of 3 m/s is moving parallel to a flat plate with the length of 6 m and surface temperature of 75 C. A) Find the transition location on the plate and the heat loss from the plate. B) Repeat part (A) for water at the same velocity and temperature. The flat plate is made from copper.

Solutions

Expert Solution


Related Solutions

Water at a temperature of 80 °C and velocity of 1.2 m/s is flowing parallel to...
Water at a temperature of 80 °C and velocity of 1.2 m/s is flowing parallel to one side of a smooth flat plate. The plate is maintained at a constant temperature of 24 °C and is 0.8 m long and 0.5 m wide. Determine the following: The heat flux at a distance x = 0.6m from the front edge of the plate, q” = ____________ The location of the maximum heat flux on the plate, x = _________ The total...
Consider atmospheric air at a velocity of V = 20 m/s and a temperature of T=...
Consider atmospheric air at a velocity of V = 20 m/s and a temperature of T= 20C, in cross flow over 10 mm square tube at 45 degrees, maintained at 50C. Sketch Assumptions Calculate the air properties (show the interpolation steps) Re = ? Nu = ? (reference the table number where the equation is obtained) H = ? Calculate the rate of heat transfer per unit length, q.
A particle with charge q= 7.80?C is moving with velocity v= -3.8 E 3 j [m/s]....
A particle with charge q= 7.80?C is moving with velocity v= -3.8 E 3 j [m/s]. The magnetic force is measured to be F= (+7.60 E -3 i - 5.20 E -3 k) [N]. Calculate the components of the magnetic field Can there be components of the magnetic field that are not determined by the Force? Calculate the vector dot product F*B, what is the angle between F and B?
Air at 25°C flows over a 10-mm-diameter sphere with a velocity of 20 m/s, while the...
Air at 25°C flows over a 10-mm-diameter sphere with a velocity of 20 m/s, while the surface of the sphere is maintained at 75°C. What is the rate of heat transfer from the sphere? q = ___ W ? Please provide correct final answer for guaranteed thumbs up rating !
Air at 20°C and a velocity of 8 m/s flows over the 4-m length of a...
Air at 20°C and a velocity of 8 m/s flows over the 4-m length of a 4-m wide single surface of a square plate whose temperature is 80°C. (For properties of air, use k = 0.02735 W/m·K, Pr = 0.7228, ν = 1.798 x 10-5 m2 /s ) Given the above information, do the calculations to answer the two MC questions below. Please clearly show/discuss your solution method and calculations. A. __________The rate of heat transfer, Q̇ , from this...
Water at a mean temperature of 80 °C and a mean velocity of 0.15 m/s flows...
Water at a mean temperature of 80 °C and a mean velocity of 0.15 m/s flows inside a 2.5 cm ID and 3.3 cm OD, copper tube. Atmospheric air at 20 °C and a velocity of 10 m/s flows across the tube. Calculate the overall heat transfer coefficient based on the outer surface and the rate of heat loss per 1 m length of the tube for inside and outside fouling factor 0.00018 m2. What is the percent reduction in...
A stream has a temperature of 20 degrees C, a velocity of 0.5 m/s, a flow...
A stream has a temperature of 20 degrees C, a velocity of 0.5 m/s, a flow rate of 3.0 m3/s, depth of 3.0 m, saturation dissolved oxygen (DO = 9.07 mg/L), and BODu = 5 mg/L. Assume the deoxygenation constant (k) = 0.24 d-1. Wastewater discharge flows into the stream at 0.6 m3/s and temperature of 20 degrees C, and the DO is 8.1 mg/L. The lowest DO downstream is 4.0 mg/L and it occurs at a distance of 20...
Air at a pressure of 1 atm and a temperature of 50°C is in parallel flow...
Air at a pressure of 1 atm and a temperature of 50°C is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 100°C. The plate has a length of 0.24 m (in the flow direction) and a width of 0.12 m. The Reynolds number based on the plate length is 30,000. (a) What is the rate of heat transfer from the plate to the air? (b) If the free stream...
Air enters a nozzle steadily at 280 kPa and 77°C with a velocity of 70 m/s...
Air enters a nozzle steadily at 280 kPa and 77°C with a velocity of 70 m/s and exits at 85 kPa and 320 m/s. The heat losses from the nozzle to the surrounding medium at 20°C are estimated to be 3.2 kJ/kg. The table for the ideal-gas properties of air is given below. Determine the exit temperature. (Round the final answer to one decimal). The exit temperature is ______K Determine the total entropy change for this process. (Round the final...
Moving with proton i = (2i + 3j - k) m / s velocity in a...
Moving with proton i = (2i + 3j - k) m / s velocity in a region where uniform magnetic field B = (21i + 4j + k) T and uniform electric field E = (4i-j-2k) V / m It is. a) Calculate the electrical, magnetic and total force acting on the particle? b) How much angle does the total force vector with the positive x-axis? c) What is the acceleration of the proton? (mp = 1.6x10 ^ 27kg for...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT