Question

In: Mechanical Engineering

Air at a pressure of 1 atm and a temperature of 50°C is in parallel flow...

Air at a pressure of 1 atm and a temperature of 50°C is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 100°C. The plate has a length of 0.24 m (in the flow direction) and a width of 0.12 m. The Reynolds number based on the plate length is 30,000. (a) What is the rate of heat transfer from the plate to the air? (b) If the free stream velocity of the air is doubled and the pressure is increased to 10 atm, what is the rate of heat transfer? Assume the critical Reynolds number is 5 x 105.

Determine the rate of heat transfer for (a), in W.
q a =  

Determine the rate of heat transfer for (b), in W.
q b =  

Solutions

Expert Solution

samet mamat answered 2 years ago
Next > < Previous

Related Solutions

The air in a room has a pressure of 1 atm, a dry-bulb temperature of 24°C,...
The air in a room has a pressure of 1 atm, a dry-bulb temperature of 24°C, and a wetbulb temperature of 17°C. Using the psychrometric chart, determine (a) The specific humidity, (b) The enthalpy, in kJ/kg dry air, (c) The relative humidity, (d) The dew-point temperature, and (e) The specific volume of the air, in m3/kg dry air.
Air, at p = 1 atm and a temperature of 60 ° C enters a thin-walled...
Air, at p = 1 atm and a temperature of 60 ° C enters a thin-walled (d = 5.0 mm) and long (l = 3 m) tube. A constant thermal flow is applied to the air from the tube walls. The mass air flow is 1.5x10^(-04) kg / s. If the temperature on the surface of the tube at its outlet is 120 ° C, determine the rate of heat transfer entering the tube. Use the air properties for 400...
Temperature of Distilled H2O = 22 *C Room (or regional) Pressure (atm) = 0.04 atm Initial...
Temperature of Distilled H2O = 22 *C Room (or regional) Pressure (atm) = 0.04 atm Initial Volume of Air (mL) = 10 mL Final Volume of Air (after reaction) (mL) = 40 mL Volume of O2 Collected (Final Volume - Initial Volume) = 30 mL w/ 5 mL H2O2 solution used. Given the above variables, determine the percentage of hydrogen peroxide in your solution.
Use: Air at a temperature of 293 K, with 50% saturation pressure for water in the...
Use: Air at a temperature of 293 K, with 50% saturation pressure for water in the air far above the pool and a velocity of 0.5 m/sec. The vapor pressure of water at this temperature is 2.3388 kPa. The length is 10 m and the width is 4 m. How fast will the level drop in a day? The kinematic viscosity of air is 1.51 x 10-5m2/sec. The gas constant is 8.314 Pa.m3/(mol.K). The diffusion coefficient is 0.25 cm2/sec. Show...
1. A sample of nitrogen gas at a pressure of 0.947 atm and a temperature of...
1. A sample of nitrogen gas at a pressure of 0.947 atm and a temperature of 213 °C, occupies a volume of 687 mL. If the gas is cooled at constant pressure until its volume is 570 mL, the temperature of the gas sample will be 2. A helium-filled weather balloon has a volume of 615 L at 23 °C and 754 mm Hg. It is released and rises to an altitude of 7.93 km, where the pressure is 323...
Air enters a counter-flow drier at 70˚C dry bulb temperature and 20˚C dew point temperature. Air...
Air enters a counter-flow drier at 70˚C dry bulb temperature and 20˚C dew point temperature. Air leaves the drier at 40˚C and 60% relative humidity. The initial moisture content of the product is 82% (wet basis). The amount of air moving through the drier is 2000kg of dry air per hour. The mass flow rate of the product is 10kg dry solid per hour. What is the final moisture content of the dried product in wet basis?
Air enters a counter-flow drier at 70˚C dry bulb temperature and 20˚C dew point temperature. Air...
Air enters a counter-flow drier at 70˚C dry bulb temperature and 20˚C dew point temperature. Air leaves the drier at 40˚C and 60% relative humidity. The initial moisture content of the product is 82% (wet basis). The amount of air moving through the drier is 2000kg of dry air per hour. The mass flow rate of the product is 10kg dry solid per hour. What is the final moisture content of the dried product in wet basis?
Air at a pressure of 350 kPa, a temperature of 80°C, and a velocity of 180...
Air at a pressure of 350 kPa, a temperature of 80°C, and a velocity of 180 m/s enters a convergent–divergent nozzle. A normal shock occurs in the nozzle at a location where the Mach number is 2. If the air mass flow rate through the nozzle is 0.7 kg/s, and if the pressure on the nozzle exit plane is 260 kPa, find the nozzle throat area, the nozzle exit area, the temperatures upstream and downstream of the shock wave, and...
Gas is confined in a tank at a pressure of 11.5 atm and a temperature of...
Gas is confined in a tank at a pressure of 11.5 atm and a temperature of 22.0°C. If two-thirds of the gas is withdrawn and the temperature is raised to 60.0°C, what is the pressure of the gas remaining in the tank?
A mass of 0.07 kg of air at a temperature of 30°C and pressure 100 kPa...
A mass of 0.07 kg of air at a temperature of 30°C and pressure 100 kPa is compressed to a pressure of 600 kPa, according to the law: (i.e. Polytropic process, n=1.3). Determine: i.The final volume ii.The final temperature iii.The work transfer iv.The change in internal energy v.The heat transfer
ADVERTISEMENT
Subjects
ADVERTISEMENT
Latest Questions
ADVERTISEMENT