Question

In: Civil Engineering

A stream has a temperature of 20 degrees C, a velocity of 0.5 m/s, a flow...

A stream has a temperature of 20 degrees C, a velocity of 0.5 m/s, a flow rate of 3.0 m3/s, depth of 3.0 m, saturation dissolved oxygen (DO = 9.07 mg/L), and BODu = 5 mg/L. Assume the deoxygenation constant (k) = 0.24 d-1. Wastewater discharge flows into the stream at 0.6 m3/s and temperature of 20 degrees C, and the DO is 8.1 mg/L. The lowest DO downstream is 4.0 mg/L and it occurs at a distance of 20 km. (Assume reaeration rate, (k)2 = 0.30 d-1)

What is the DO concentration in the wastewater discharge (mg/L)?

What is the BODu in the wastewater discharge (mg/L)?

Solutions

Expert Solution

you have already gave the dissolve oxygen for waste water which is equal to 8.1mg/L....if there is any problem in date please comment me...thank you


Related Solutions

Consider atmospheric air at a velocity of V = 20 m/s and a temperature of T=...
Consider atmospheric air at a velocity of V = 20 m/s and a temperature of T= 20C, in cross flow over 10 mm square tube at 45 degrees, maintained at 50C. Sketch Assumptions Calculate the air properties (show the interpolation steps) Re = ? Nu = ? (reference the table number where the equation is obtained) H = ? Calculate the rate of heat transfer per unit length, q.
Water at a temperature of 80 °C and velocity of 1.2 m/s is flowing parallel to...
Water at a temperature of 80 °C and velocity of 1.2 m/s is flowing parallel to one side of a smooth flat plate. The plate is maintained at a constant temperature of 24 °C and is 0.8 m long and 0.5 m wide. Determine the following: The heat flux at a distance x = 0.6m from the front edge of the plate, q” = ____________ The location of the maximum heat flux on the plate, x = _________ The total...
A large stream with a velocity of 0.85 m/s, saturated with oxygen, has a reoxygenation constant...
A large stream with a velocity of 0.85 m/s, saturated with oxygen, has a reoxygenation constant k2 = 0.4 day−1 and a temperature of T = 12oC, with an ultimate BOD = 13.6 mg/L and a flow rate Q = 2.2 m3 /s. Into this stream flows a wastewater stream with a flow rate of 0.5 m3/s, T = 26oC, L = 220 mg/L and oxygen level = 1.5 mg/L. Downstream the deoxygenation constant is k1 = 0.2 day−1 ....
Water at a mean temperature of 80 °C and a mean velocity of 0.15 m/s flows...
Water at a mean temperature of 80 °C and a mean velocity of 0.15 m/s flows inside a 2.5 cm ID and 3.3 cm OD, copper tube. Atmospheric air at 20 °C and a velocity of 10 m/s flows across the tube. Calculate the overall heat transfer coefficient based on the outer surface and the rate of heat loss per 1 m length of the tube for inside and outside fouling factor 0.00018 m2. What is the percent reduction in...
Air at 20°C and a velocity of 8 m/s flows over the 4-m length of a...
Air at 20°C and a velocity of 8 m/s flows over the 4-m length of a 4-m wide single surface of a square plate whose temperature is 80°C. (For properties of air, use k = 0.02735 W/m·K, Pr = 0.7228, ν = 1.798 x 10-5 m2 /s ) Given the above information, do the calculations to answer the two MC questions below. Please clearly show/discuss your solution method and calculations. A. __________The rate of heat transfer, Q̇ , from this...
Water at a mean velocity of 0.2 m/s is heated from 20 to 40°C by passing...
Water at a mean velocity of 0.2 m/s is heated from 20 to 40°C by passing it through a 0.5-cm-ID tube. The 2 surface is heated with a uniform heat flux of 6000 W/m . Find the following: a) The length required to heat the water to a given temperature.,b) the surface temperature at the inlet of the tube. Given that the following information: The physical properties of liquid at 30 °C: ?? =4182?⁄??.°?,?=0.6405?⁄?.°?,??=3.57,?=0.5537×10−6?2⁄?,?=988??⁄?3
An object has initial position r0 = (-1,1) meters, initial velocity v0 = (-0.5, 2) m/s,...
An object has initial position r0 = (-1,1) meters, initial velocity v0 = (-0.5, 2) m/s, and  acceleration a = (0.1, -0.5) m/s. In the following questions, if there is more than one possible answer, use the positive answer. a) At what time is the y component of the velocity equal to 0? b) At what time is the y component of the position equal to 0? c) At what time is the x component of the velocity equal to 0?...
A projectile is launched with initial velocity of 11 m/s at 30.5 degrees above the horizontal....
A projectile is launched with initial velocity of 11 m/s at 30.5 degrees above the horizontal. - find the x-component of the initial velocity: - find the y-component of the initial velocity:
Air at 25°C flows over a 10-mm-diameter sphere with a velocity of 20 m/s, while the...
Air at 25°C flows over a 10-mm-diameter sphere with a velocity of 20 m/s, while the surface of the sphere is maintained at 75°C. What is the rate of heat transfer from the sphere? q = ___ W ? Please provide correct final answer for guaranteed thumbs up rating !
A) a roller coaster it's traveling with a velocity of 20 m/s at the top of...
A) a roller coaster it's traveling with a velocity of 20 m/s at the top of an incline. If the incline has a height of 10m, determine the coasters velocity at the middle of the incline. Neglect friction and use 10 m/s^2 for gravity B) a vehicle weighing 15000 nt is traveling at 50 m/s in the i direction. It collides with a wall and stops in 1/10 second. If the collision was inelastic, determine the average force of the...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT