Minimize the function with K-Map- F(A,B,C,D)= ПM(0,2,4,5,6,7,9,12).d(3,14)   

Design full adder with 4:1 MUX gates

1) What is the minimum value of random samples generated by the following MATLAB code?: 5*(2*rand-1)

2) What is the mean value of random samples generated by the following MATLAB code?:  3*randn-2

3) What is the mean value of random samples generated by the following MATLAB code?: 5*(2*rand-1)

Problem 8 ( please write neatly and in full )

a) Draw the block diagram with feed-forward. What are its advantages?
b) Why are limiters used and what are their effects?
c) What is the integrator windup and how can it be avoided?

A 500-kV, 60 Hz, three-phase completely transposed overhead line has three ASCR 1113-kcmil conductors per bundle, with 0.5 m between conductors in the bundle. The horizontal phase spacing between bundle centers are 10, 10, and 20 m. With a length of 190 km, the line delivers 1800 MW at 475 kV and at 0.90 power factor leading to the receiving end at full load. Using the nominal π circuit, calculate the: (a) ABCD parameters, (b) sending-end voltage and current, (c) sending-end power and power factor, and (d) the full load line losses and efficiency. Assume a 50 ̊C conductor temperature to determine the resistance of this line.

Problem 8 ( please answer neatly )

a) Draw the dc-motor equivalent circuit and its representation in Laplace domain. Is
this representation linear?
b) What is the transfer function of a proportional-integral (PI) controller?
c) Draw the block diagram of the torque loop.

Problem 8 ( please answer neatly )

i) What are the various blocks of a motor drive?
ii) What is a cascaded control, and what are its advantages?
iii) Draw the average models of a PWM controller and a dc-dc converter.

i need a design for a robot to be placed in swimming pools that detects drowning , in case drowning is detected it will automatically inflate an airbag to rescue the swimmer NOTE we need a design without using cameras and image processing the robot will be in the swimming pool

for this set of assignment, Moore state machine

Design a sequence detector to detect "001", where 0 arrives first, then 0, then 1. You need to show the test sequences you used to confirm that your state diagram is operating correctly. When the complete "001" sequence has been detected, the output goes high. Otherwise, the output stays at zero.
Shows your state diagram, state table, encoded state table (use minimized bit encoding), logic equations, and logic circuit. (30 points)

3. Re-do (2) using one-hot encoding

An NMOS transistor has KP = 80 μA/V2, Vto = 1V, L = 4μm, and W = 100 μm. Carefully sketch to scale the drain characteristics for vDS ranging from 0 to 10V and vGS = 0.5 and 4V

Draw a high frequency small signal model for BJT and MOSFET, for common gate, common source and common drain amplifiers

. Discuss the factory lighting

In a single design, implement 3 wave generators by means of operational amplifiers: wave
square, triangle wave, sine wave.

IMPORTANT
The wave generating equipment has to be activated by means of an external AC source,
that being activated by a switch, allows the activation of the system.

SIMULATION is required in the MULTISIM Software. Attach screenshot of the entire circuit and the waves.
and also the calculations.

Prepare the calculations of each case, which support the output signal obtained by
use any of the generators.

The MULTISIM simulation of the project with the three circuits in a single diagram.

Describe the Pinch off condition in JFETs and its impact over the drain current. Draw
the N channel JFET with proper regions?

What is the smallest size conductor allowed to be used in a building for branch circuits?

What is the smallest size conductor allowed to be connected in parallel?

There are three current-carrying conductors in a raceway that is to be installed in an area with an ambient temperature of 86°F. It is necessary to

There are six current-carrying conductors in a raceway that is to be installed in an area with an ambient temperature of 96°F. It is necessary to