Question
In: Civil Engineering
Calculate the monthly average evaporation to occur from the surface of the water in open July,...
Calculate the monthly average evaporation to occur
from the surface of the water in open July, taking into account the
following data for a lake,
£ using the Penman method.£
Latitude: 40.5 N.
Monthly Avg. Temperature: 21.3 C.
Real daylight hours: 9.8 hours
.2m wind speed: 145 km / h.
Albedo: 7%.
Relative Humidity: 55%
no sir it is homework I have to solve it by penman rules
Solutions
Ally Wells answered 8 months agoRelated Solutions
The average area of the circle on the surface of the water was calculated to be...
The average area of the circle on the surface of the water was
calculated to be 521 cm^2 for the ethyl alcohol and 881 cm^2 for
the ethyl alcohol solution of naphthalene. What is the area
occupied by one molecule of naphthalene?
Calculate the average thickness of copper on the surface of a penny (produced after 1983) in...
Calculate the average thickness of copper on the surface of a
penny (produced after 1983) in units of a.) mm and b.) atoms of Cu.
Show all calculations, including unit analysis.
Design a system to move 100 gpm of water from a river with surface water elevation...
Design a system to move 100 gpm of water from a river with
surface water elevation of 201.35 ft msl to a tank with surface
water elevation = 246.55 ft msl. The tank is pressurized; the air
pressure in the tank is 60 psig. The total length of pipe is 125 ft
with 6 standard elbows all made of Sch 40 steel pipe. Your design
should specify the nominal diameter of pipe (use only commercially
available sizes) and the power...
Water will be pumped from a reservoir free surface of which is at an elevation of...
Water will be pumped from a reservoir free surface of which is
at an elevation of “z1” to reservoir the free water surface of
which is at “z2”. Both of the reservoirs’ free surfaces at
atmospheric pressures.Design a piping system that transmits water
from the lower reservoir to the upper reservoir at a volumetric
flow rate of Q (m3 /h).
Q = 200 (m3/h) Za = 10(m) Zb= 60 (m) Zc = 75 (m) L1=200 (m)
L2=125 (m) "Pipe material...
Water will be pumped from a reservoir free surface of which is at an elevation of...
Water will be pumped from a reservoir free surface of which is
at an elevation of “z1” to reservoir the free water surface of
which is at “z2”. Both of the reservoirs’ free surfaces at
atmospheric pressures.Design a piping system that transmits water
from the lower reservoir to the upper reservoir at a volumetric
flow rate of Q (m3 /h).
Q = 200 (m3/h) Za = 10(m) Zb= 60 (m) Zc = 75 (m) L1=200 (m)
L2=125 (m) "Pipe material...
Assume that the surface tension of water is γ=70 mN/m. (a) Calculate the internal pressure of...
Assume that the surface tension of water is γ=70 mN/m.
(a) Calculate the internal pressure of a water droplet of radius
1μm suspended in air at atmospheric pressure.
(b) Show that if a pure fluid is assumed to be incompressible,
the chemical potential of a fluid molecule can be written as
μ(T,P) = μ0(T)+vP,
where v is the specific volume of the molecule, and P is the
pressure.
(c) The vapour pressure of bulk water is 0.02atm at temperature
20...
Water flows steadily from an open tank as shown in the figure
Water Flowing from a Tank
Water flows steadily from an open tank as shown in the figure. (Figure 1) The elevation of point 1 is \(10.0 \mathrm{~m},\) anc the elevation of points 2 and 3 is \(2.00 \mathrm{~m}\). The crosssectional area at point 2 is \(4.80 \times 10^{-2} \mathrm{~m}^{2} ;\) at point 3 where the water is discharged, it is \(1.60 \times 10^{-2} \mathrm{~m}^{2}\). The cross-sectional area of the tank is very large compared with the cross-sectional area of the...
Water flows steadily from an open tank as shown in the figure.
Water flows steadily from an open tank as shown in the figure. (Figure 1) The elevation of point 1 is 10.0 m, and the elevation of points 2 and 3 is 2.00 m. The cross-sectional area at point 2 is 4.80 × 10-2m2; at point 3, where the water is discharged, it is 1.60 × 10-2m2. The cross-sectional area of the tank is very large compared with the cross-sectional area of the pipe.Part BWhat is the gauge pressure Pgauge at point...
When scuba diving, it is important to come back to the surface of the water from...
When scuba diving, it is important to come back to the surface
of the water from deep dives slowly. If this does not happen, then
the diver can get the “bends”. Using the information provided
below, determine the moles of N2 and O2
dissolved in 7.5 L of blood at 298 K at a depth of 100.0 feet below
the surface of the water and at the surface of the ocean. If the
diver were to suddenly return to the...
A city planner wants to estimate the average monthly residential water usage in the city. He...
A city planner wants to estimate the average monthly residential
water usage in the city. He selected a random sample of 40
households from the city, which gave the mean water usage to be
3411.10 gallons over a one-month period. Based on earlier data, the
population standard deviation of the monthly residential water
usage in this city is 387.70 gallons. Make a 95% confidence
interval for the average monthly residential water usage for all
households in this city.
Round your...
ADVERTISEMENT
ADVERTISEMENT
Latest Questions
- You are tasked with assessing the health department’s intervention program in preventing recurrence of acute alcohol...
- Compare the MOSFET, JFET , and BJT and identify the reasons these devices behave differently. What...
- How would you use SAS Enterprise Miner to create a neural network model of your example?
- Explain the use of neural networking modeling in predictive analytics.
- Current Market Mix of Netflix, as detail as possible, please.
- This is all one question, thank you so much in advance! You must evaluate a proposal...
- X Company is considering the purchase of a new processor that costs $200,000. Shipping and setup...
ADVERTISEMENT