Question

In: Physics

Water flows steadily from an open tank as shown in the figure.

Water flows steadily from an open tank as shown in the figure. (Figure 1) The elevation of point 1 is 10.0 m, and the elevation of points 2 and 3 is 2.00 m. The cross-sectional area at point 2 is 4.80 × 10-2m2; at point 3, where the water is discharged, it is 1.60 ×  10-2m2. The cross-sectional area of the tank is very large compared with the cross-sectional area of the pipe.

image.png

Part B

What is the gauge pressure Pgauge at point 2?

Express your answer numerically in pascals.

Solutions

Expert Solution

genius_generous answered 2 years ago
Next > < Previous

Related Solutions

Water flows steadily from an open tank as shown in the figure
Water Flowing from a Tank Water flows steadily from an open tank as shown in the figure. (Figure 1) The elevation of point 1 is \(10.0 \mathrm{~m},\) anc the elevation of points 2 and 3 is \(2.00 \mathrm{~m}\). The crosssectional area at point 2 is \(4.80 \times 10^{-2} \mathrm{~m}^{2} ;\) at point 3 where the water is discharged, it is \(1.60 \times 10^{-2} \mathrm{~m}^{2}\). The cross-sectional area of the tank is very large compared with the cross-sectional area of the...
Water flows steadily from an open tank as shown in the figure. (Figure 1) The elevation...
Water flows steadily from an open tank as shown in the figure. (Figure 1) The elevation of point 1 is 10.0m , and the elevation of points 2 and 3 is 2.00 m . The cross-sectional area at point 2 is 4.80x10^-2m ; at point 3, where the water is discharged, it is 1.60?10^?2m. The cross-sectional area of the tank is very large compared with the cross-sectional area of the pipe. Part A Assuming that Bernoulli's equation applies, compute the...
Water flows steadily through a splitter as shown in the figure with Q, = 0.08 m³...
Water flows steadily through a splitter as shown in the figure with Q, = 0.08 m³ / sec, Q, = 0.05 m3 / sec, D, = D2 = 12 cm, D3 = 10 cm. If the pressure readings at the inlet and outlets of the splitter are P, = 100 KPa, P2 = 90 KPa and P3 = 80 KPa, determine external force needed to hold the splitter. Disregard the weight effects.
In the figure, the top tank, which is open to the atmosphere, contains water and the...
In the figure, the top tank, which is open to the atmosphere, contains water and the bottom tank contains oil covered by a piston. The tank on the right has a freely movable partition that keeps the oil and water separate. The partition is a vertical distance 0.10 m below the open surface of the water. If the piston in the bottom tank is 0.50 m below the open surface of the water and has a surface area of 8.3...
Water flow steadily from a large closed tank. The deflection in mercury manometer is 1 inches...
Water flow steadily from a large closed tank. The deflection in mercury manometer is 1 inches or ( 0.0254-m) and viscous effects are negligible. 1). If the tank of water is maintained at 8.50 c(celsius) and the ambient air temperature is 34 c (celsius), determine the volume flow rate in (m^3/s) leaving the 3-inch or (0.0762-m) diameter outlet from the tank, the pressure differential (delta P) between the pitot tube entrance (across from the discharge outlet) & the fluid pressure...
An insulated tank is divided into two parts by a partition as shown in the figure....
An insulated tank is divided into two parts by a partition as shown in the figure. One part of the tank contains 2.5 kg of compressed liquid water at 60°C and 600 kPa while the other part is evacuated. The partition is now removed, and the water expands to fill the entire tank. Determine the final temperature of the water and the volume of the tank for a final pressure of 3 kPa. (Round the final temperature to two decimal...
Water flows through a shower head steadily at a rate of 8 kg/min. The water is...
Water flows through a shower head steadily at a rate of 8 kg/min. The water is heated in an electric water heater from 158C to 458C. In an attempt to conserve energy, it is proposed to pass the drained warm water at a temperature of 388C through a heat exchanger to preheat the incoming cold water. Design a heat exchanger that is suitable for this task, and discuss the potential savings in energy and money for your area.
A large storage tank, open to the atmosphere at the top and filled with water, develops...
A large storage tank, open to the atmosphere at the top and filled with water, develops a small hole in its side at a point 17.1 m below the water level. If the rate of flow from the leak is 2.30 ? 10?3 m3/min, determine the following. (a) Determine the speed at which the water leaves the hole. m/s (b) Determine the diameter of the hole. mm
A large storage tank, open to the atmosphere at the top and filled with water, develops...
A large storage tank, open to the atmosphere at the top and filled with water, develops a small hole in its side at a point 13.9 m below the water level. If the rate of flow from the leak is3.00 ✕ 10−3 m3/min, determine the following. (a) Determine the speed at which the water leaves the hole. m/s (b) Determine the diameter of the hole. mm
A large storage tank, open to the atmosphere at the top and filled with water, develops...
A large storage tank, open to the atmosphere at the top and filled with water, develops a small hole in its side at a point 13.9 m below the water level. If the rate of flow from the leak is3.00 ✕ 10−3 m3/min, determine the following. (a) Determine the speed at which the water leaves the hole. m/s (b) Determine the diameter of the hole. mm
ADVERTISEMENT
Subjects
ADVERTISEMENT
Latest Questions
ADVERTISEMENT