A 2-lane highway is to be constructed across a 6-ft diameter metal culvert which is oriented...

A 2-lane highway is to be constructed across a 6-ft diameter metal culvert which is oriented perpendecular to the highway center line. The culvert is located at station 33+00, and the invert (bottom) of the culvert has an elevation of 150 ft. The elevation of station 21+00 on the tangent alignment is 140 ft. The alignment gradient is +4.0% from station 21+00 to station 29+00, and the gradient from station 29+00 to 37+00 is –3%.

Find the longest full station vertical curve that will give approximately 3 ft (3 ± 0.5 ft) of cover over the top of the culvert.
Compute the station and elevation of the PVC and PVT and the elevation of each full station on the vertical curve.

Expert Solution

Ally Wells answered 1 year ago

A circular concrete culvert has a diameter D = 4 ft, bottom slope S = 0.01,...

A circular concrete culvert has a diameter D = 4 ft, bottom slope S = 0.01, and length L = 100 ft. The culvert inlet is grooved with a headwall and is not mitered. Determine the maximum discharge this culvert can convey under inlet control conditions if the headwater depth, HW, is not to exceed 6.0 ft.

A six-lane recreational freeway has the following characteristics: 12 ft lanes, 6 ft lateral clearances, 2...

A six-lane recreational freeway has the following characteristics: 12 ft lanes, 6 ft lateral clearances, 2 ramps/mi, 10% trucks (standard mix), peak-hour factor=0.95, level terrain, peak-hour demand=4,000 veh/h. Because the facility serves recreational users to a nearby ski area, the peak period occurs on weekends, and light to moderate snow is the normal weather pattern. If virtually all users of the facility are unfamiliar with the roadway, what is the expected LOS during the peak period?

a 3-barrel culvert is constructed of identical 60-inch diameter concrete pipes the entrance has a headwall...

a 3-barrel culvert is constructed of identical 60-inch diameter concrete pipes the entrance has a headwall and square edges the culvert length is 200 ft with a slope of .010 assuming the culvert does not overtop a) if the total flow rate is 780 cfs calculate the headwater elevation

A horizontal curve along a two-lane highway with 12-ft lanes is designed with a central angle...

A horizontal curve along a two-lane highway with 12-ft lanes is designed with a central angle of 29.93 degrees and a superelevation rate of 8 percent. The station of the PC and PI are 100+00.00 and 103+22.36, respectively. Given this information: a. Determine the design speed of this curve. (12 points) b. Calculate the distance that must be cleared from the center of the inside lane in order to provide sufficient stopping sight distance (8 points)

TRP 631: HIGHWAY TRAFFIC OPERATIONS An older four-lane freeway has the following characteristics: 11 ft lanes...

TRP 631: HIGHWAY TRAFFIC OPERATIONS An older four-lane freeway has the following characteristics: 11 ft lanes No lateral clearance 4.5 ramps/mile 5% truck( standard mix) Peak-hour factor = 0.90 Rolling Terrain The present peak-hour demand on the facility is 2,100 veh/h, and anticipated growth is expected to be 3% per year. What is the present LOS? What is the expected LOS in 5 years? 10 years? 20 years?. To avoid breakdown (LOS F), when will substantial improvements be needed to...

Problem 1 The volume at a section of a 2 lane highway is 2000vph in each...

Problem 1 The volume at a section of a 2 lane highway is 2000vph in each direction and the density is 50 vehicles per mile. A truck joins the traffic stream and travels a length of 5 miles at 20 mph before exiting the highway. The vehicles behind the truck produce a density of 110 vehicles/ mile and the flow rate is 1000 vph. How many vehicles are behind the truck before it leaves the highway. Problem 2 Using Greenberg...

An existing rural 4-lane freeway (2 lanes in each direction) has 11-ft lanes and 2-ft lateral...

An existing rural 4-lane freeway (2 lanes in each direction) has 11-ft lanes and 2-ft lateral clearance. The freeway hasa peak-hour volume of 1,800 veh/h in one direction, 5% trucks in the traffic stream, and a PHF of 0.92. The freeway has 1 cloverleaf interchange within three miles of the midpoint of segment, and runs through level terrain. No recent field speed data is available. a) Using HCS7, determine the LOS during the peak hour. b) What is the capacity...

A four-lane urban freeway is rolling on rolling terrain with 12-ft lanes, obstructions 2-ft from the...

A four-lane urban freeway is rolling on rolling terrain with 12-ft lanes, obstructions 2-ft from the right edge of the traveled pavement, and nine ramps within three miles upstream and three miles downstream of the midpoint of the analysis segment. The traffic stream consists primarily of commuters. A directional weekday peak-hour volume of 2400 vehicles is observed with 800 vehicles arriving in the most congested 15-min period. If the traffic stream has 10% large trucks and buses and recreational vehicles,...

Draw a sketch of a draw a typical cross-section of a 2-lane rural highway in a...

Draw a sketch of a draw a typical cross-section of a 2-lane rural highway in a cut section and label all the components.

A closed rigid cylindrical vessel (internal diameter = 2 ft and internal height = 10 ft)...

A closed rigid cylindrical vessel (internal diameter = 2 ft and internal height = 10 ft) has R-134a at x = 0.95 and 40 oF. The vessel is heated up to 100 oF. Assume that heat loss from the vessel is negligible. Kinetic and potential effects are negligible. Determine 1) the final pressure in psi [lbf/in2], 2) the mass of R-134a in lbm, 3) the heat transfer in Btu for this process and discuss its direction (if the heat is...

Question