334) An Arduino analog input voltage is 4.320 volts. The Arduino PWM output pin drives a...

334) An Arduino analog input voltage is 4.320 volts. The Arduino PWM output

pin drives a low-pass filter, which converts the PWM signal back to an

average-DC voltage. Arduino specifications include: I/O voltage ranges

of 0 to 5VDC; 10-bit A/D; and 8-bit D/A PWM output. The analog voltage DC

input results in an analog output DC volage at the low-pass filter.

Determine (Vout - Vin). Arduino functions include: analogRead(), map(),

and analogWrite(). The analogRead() and map() use integer I/O.

Solutions

Expert Solution

Manojponduru answered 6 months ago

Next > < Previous

Related Solutions

Consider a 12-bit ADC with an analog input voltage range of 0 to 3 volts. a)...

Consider a 12-bit ADC with an analog input voltage range of 0 to 3 volts. a) Compute the ADC precision, ADC ranges for input and output, and ADC resolution. b) What is the binary value computed by the ADC for an analog input voltage of 1.0 volt? c) Write an ADC0_In function in C that uses busy-wait synchronization to sample the ADC. The function reads the ADC output, and returns the 12-bit binary number. Assume the ADC has already been...

explain the following, enhance will sketches and describe the output voltage. - Sinusoidal PWM - Full...

explain the following, enhance will sketches and describe the output voltage. - Sinusoidal PWM - Full bridge inverter single phase - Bipolar PWM single phase inverter - Uni-polar WM single phase inverter - three phase inverter

Input pin(s): inputw [1], sysclock [1] Output pin(s): outputq [1] Design a 3-bit parity generator using...

Input pin(s): inputw [1], sysclock [1] Output pin(s): outputq [1] Design a 3-bit parity generator using a minimal state table for a Moore model FSM. For every three bits that are observed on inputw during three consecutive clock cycles, the FSM generates the parity bit outputq = 1 if the number of 1s received in the sequence so far is odd. Must use a maximum of 3 flip flops.

Determine the coding efficiency of PCM max analog input f=4KHz, max decoded voltage at receiver =±4V,...

Determine the coding efficiency of PCM max analog input f=4KHz, max decoded voltage at receiver =±4V, Minimum dynamic range of 80Db

The circuit shown in Fig. 4.17a is a precision differential voltage-gain device. It is used to provide a single-ended input for an analog-to-digital converter. We wish to derive an expression for the output of the circuit in terms of the two inputs.

The circuit shown in Fig. 4.17a is a precision differential voltage-gain device. It is used to provide a single-ended input for an analog-to-digital converter. We wish to derive an expression for the output of the circuit in terms of the two inputs.

Subjects