Question

In: Electrical Engineering

Propose an adjustable voltage source based on LM7805. Requirements: Adjustment from 5 to 15V. Maximum current...

Propose an adjustable voltage source based on LM7805.
Requirements:
Adjustment from 5 to 15V. Maximum current 3A.
Short protection for the 7805 when> 1A.
Draw the complete circuit with the requirements

Solutions

Expert Solution


Related Solutions

An RLC circuit consists of an AC voltage source with a maximum voltage of 122 Volts...
An RLC circuit consists of an AC voltage source with a maximum voltage of 122 Volts connected in series to a resistor, a capacitor, and an inductor. At the resonant frequency, the inductive reactance is 13 Ohms and the total impedance of the circuit is 23 Ohms. What is the average power produced by the battery at 2.6 times the resonant frequency in Watts?
An RLC circuit consists of an AC voltage source with a maximum voltage of 135 Volts...
An RLC circuit consists of an AC voltage source with a maximum voltage of 135 Volts connected in series to a resistor, a capacitor, and an inductor. At the resonant frequency, the inductive reactance is 15 Ohms and the total impedance of the circuit is 24 Ohms. What is the average power produced by the battery at 2.6 times the resonant frequency in Watts?
A voltage source and a current source both supply current on an electrical system. So why...
A voltage source and a current source both supply current on an electrical system. So why do we call a voltage source a voltage source? What is the difference between the two?
For a capacitor with AC voltage source, it is said that the current can be split...
For a capacitor with AC voltage source, it is said that the current can be split into a capacitive current component and resistive current. My professor says the displacement and capacitive current is not the same, what is the difference between them?
1. With the same voltage source and same parameters for current, which metal will be the...
1. With the same voltage source and same parameters for current, which metal will be the fastest to have 5g deposited on a cathode? Ag (from a AgCl solution) Pb (from a PbCl2) Au (from an AuCl3 solution) 2. Balance the following redox reaction in basic solution. MnO4⁻(aq) + H2C2O4(aq) → Mn2+(aq) + CO2(g) How many moles of H+ are in the balanced equation? a)8 b)2 C)0 D)6 3. We know that the reaction A --> 2C has an average...
3.- Design a variable voltage source from 1.25 to 20V with the LM317 voltage regulator. This...
3.- Design a variable voltage source from 1.25 to 20V with the LM317 voltage regulator. This source will be powered by 127Vac @ 60HZ from CFE. Determine the following: a) complete schematic circuit. b) Diodes that support VPI and load current. c) required transformer (turns ratio), not to exceed the regulator's maximum input voltage. (See data sheet. d) Filter C. Uses an RF of 1% e) LM 317 regulator circuit. Consider the following: calculate the adjustment resistances, and that, when...
A series RC circuit is connected in parallel to a 5 volt DC voltage source, where...
A series RC circuit is connected in parallel to a 5 volt DC voltage source, where resistance R=1 M ohm and capacitance C= 1 microfarad. If at the start of operation, voltage across the capacitor is 5 volts, calculate the voltage across the capacitor at t=2 seconds. Also sketch the instantaneous voltage across the resistor. using differential equation.
Q20 (a) A step down chopper circuit is supplied with power from an ideal voltage source...
Q20 (a) A step down chopper circuit is supplied with power from an ideal voltage source of terminal voltage 100 V. The load voltage waveform consist of rectangular pulses across a 1kΩ resistor of duration 1ms in one cycle of 2.5 ms. Calculate the average value.rms value & ripple factor   (b) Explain a 1-ф full wave controlled semi converter with freewheel diode for RLE load. (12 Mark)
What is the maximum current that can be drawn from the battery?
The storage battery of a car has an emf of 12 Volt. If the internal resistance of the battery is 0.4 Ω, what is the maximum current that can be drawn from the battery?
(Transient Current) An RLC series circuit has a voltage source given by E(t) = 20sin(t) V,...
(Transient Current) An RLC series circuit has a voltage source given by E(t) = 20sin(t) V, an inductor of 3 H, a resistor 6 Ω, and a capacitor of 1/3 F. Find the current I(t) in this circuit for t > 0 if I(0) = 2, I'(0) = 0. Find the moment of time when the transient current is equal to zero
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT