A series RC circuit is connected in parallel to a 5 volt DC voltage source, where...

A series RC circuit is connected in parallel to a 5 volt DC voltage source, where resistance R=1 M ohm and capacitance C= 1 microfarad. If at the start of operation, voltage across the capacitor is 5 volts, calculate the voltage across the capacitor at t=2 seconds. Also sketch the instantaneous voltage across the resistor. using differential equation.

Expert Solution

Since we have supplied an initially charged capacitor with the same value of dc voltage as with amount of voltage with which it was charged initially. So there will be no flow of current in the circuit.

Manojponduru answered 2 years ago

A 10-volt voltage source is connected in a series arrangement with two resistors (R1 = 7...

A 10-volt voltage source is connected in a series arrangement with two resistors (R1 = 7 ohms, R2 = 3 ohms). The current flowing in each resistor is: a) 1.8 amperes b) 45 amperes c) 0.05 amperes d) 1 ampere e) 3.5 amperes What is the voltage across R2 in the above circuit? a) 2 volts b) 10 volts c) 3 volts d) 0.25 volts e) 5 volts 3. If R1 and R2 are now connected in parallel, what...

A series RC circuit with R = 5 W and C = 0.02 F is connected...

A series RC circuit with R = 5 W and C = 0.02 F is connected with a battery of E = 100 V. At t = 0, the voltage across the capacitor is zero. (a) Obtain the subsequent voltage across the capacitor. (b) As t → ∞, find the charge in the capacitor. (DIFFERENTIAL EQUATIONS) SOLVE THIS USING MATLAB SOLVE THIS USING MATLAB SOLVE THIS USING MATLAB SOLVE THIS USING MATLAB SOLVE THIS USING MATLAB SOLVE THIS USING MATLAB...

Driven RC circuit in parallel. A capacitor C is connected in parallel to a resistor R...

Driven RC circuit in parallel. A capacitor C is connected in parallel to a resistor R and an AC source providing a voltage v(t) = V sin(ωt). (a) Make a phasor diagram at time t showing all relevant based on Kirchhoff’s rules. (b) Find the impedance of this circuit and make a plot of Z vs. ω. (c) What are the small and large frequency behaviors of the peak capacitor and resistor currents? (d) What is the phase difference between...

If the capacitor in an RC circuit is replaced by two identical capacitors connected in series,...

If the capacitor in an RC circuit is replaced by two identical capacitors connected in series, then find the CORRECT statement. Select one: a. The time constant will be tripled b. The time constant will decrease by a factor of 2 c. The time constant will be unchanged d. The time constant will decrease by a factor of 4 e. The time constant will be doubled

A light bulb, a capacitor, and a nine-volt battery are wired up in series in a simple RC circuit.

A light bulb, a capacitor, and a nine-volt battery are wired up in series in a simple RC circuit. The light bulb has a resistance of 2.0 kΩ and the capacitor has a capacitance of 950 μF.(a) What is the electric current in the circuit at the exact moment the battery is connected (at t = 0)?(b) What is the electric current in the circuit 1 second after the battery was connected?(c) What is the electric current in the circuit...

A device connected in a parallel circuit will undergo a higher voltage drop compared to the...

A device connected in a parallel circuit will undergo a higher voltage drop compared to the same device connected in a series circuit. is this true or false, and also why does this occur?

Develop a series RLC circuit that increases the capacitor voltage to the source voltage as fast...

Develop a series RLC circuit that increases the capacitor voltage to the source voltage as fast as possible with no more than a 20% overshoot. The source voltage is 99V, the capacitance is 9F the and the inductance is 23 H. You can adjust the resistance since that the inductance are the two easiest parameters to adjust. I suggest you find ω0 for your circuit and the value of R that results in a critically damped circuit. Plot this vs....

Given a RC circuit in series , at time t=0, power supply 4v is connected to...

Given a RC circuit in series , at time t=0, power supply 4v is connected to the circuit causing charging of capacitor, determine at instant 8 seconds : Where C = 10 mF, R = 4 kOhms, and consider all initial values equal to ZERO. a) Tension on capacitor; b) Tension on resistor; c) total current.

A 500 nF capacitor is initially connected to a 100 V DC voltage source. At some...

A 500 nF capacitor is initially connected to a 100 V DC voltage source. At some long time later, the switch is flipped and the capacitor is now connected to a 120 mH inductor. a) What is the frequency of oscillation in the circuit after the switch is flipped. b) After the switch is filpped, what would the peak current value be? c) What is the maximum possible value for the energy stored in the inductor? d) The energy in...

10.An AC voltage source is connected in series to an inductor, a capacitor, and a resistor...

10.An AC voltage source is connected in series to an inductor, a capacitor, and a resistor of 8 Ohms. At the frequency when the phase angle is zero, capacitive reactance is 7 Ohms. What is the phase angle between the current and voltage at a frequency which is a factor of 3.2 times less than this frequency? answer in degresss and if negative 6. the resistance of a coil spun in a generator is 2 Ohms. the coil is in...

Question