THESE QUESTONS ARE FROM THE SUBJECT POWER SYSTEM FUNDAMENTALS AND FROM THE TOPIC ELECTRICAL DESIGN OF...

THESE QUESTONS ARE FROM THE SUBJECT POWER SYSTEM FUNDAMENTALS AND FROM THE TOPIC ELECTRICAL DESIGN OF OVER HEAD TRANSMISSION LINES AND MAKE SURE THAT YOUR ANSWER IS CORRECT

Problem-4

Find the inductance per km per phase of a 3-phase overhead transmission line using 2 cm diameter conductor when these are placed at the corners of an equilateral triangle of side 4 meters.

Problem-5

The three conductors of 3-phase overhead line are arranged in a horizontal plane with a spacing of 4 m between adjacent conductors. The diameter of each conductor is 2 cm. Determine the inductance per km per phase of the line assuming that the lines are transposed.

Solutions

Expert Solution

Manojponduru answered 7 months ago

Next > < Previous

Related Solutions

THESE QUESTONS ARE FROM THE SUBJECT POWER SYSTEM FUNDAMENTALS AND FROM THE TOPIC ELECTRICAL DESIGN OF...

THESE QUESTONS ARE FROM THE SUBJECT POWER SYSTEM FUNDAMENTALS AND FROM THE TOPIC ELECTRICAL DESIGN OF OVER HEAD TRANSMISSION LINES AND MAKE SURE THAT YOUR ANSWER IS CORRECT Problem-1 A single phase transmission line has two parallel conductors 1·5 meters apart, the diameter of each conductor being 0·5 cm. Calculate line to neutral capacitance for a line 80 km long. Problem-2 A 200 km, 3-phase transmission line has its conductors placed at the corners of an equilateral triangle of 2·5...

THESE ARE THE QUESTIONS FROM THE SUBJECT POWER SYSTEM FUNDAMENTALS AND THE TOPIC IS MECHANICAL DESIGN...

THESE ARE THE QUESTIONS FROM THE SUBJECT POWER SYSTEM FUNDAMENTALS AND THE TOPIC IS MECHANICAL DESIGN OF OVER HEAD LINES AND THE ANSWERS ARE IN BRCKETS 1) Estimate the corona loss for a three-phase, 110 kV, 50 Hz, 150 km long transmission line consisting of three conductors each of 10 mm diameter and spaced 2·5 m apart in an equilateral triangle formation. The temperature of air is 30ºC and the atmospheric pressure is 750 mm of mercury. Take irregularity factor...

THESE ARE QUESTION FROM THE TOPIC VARIABLE LOAD ON POWER STATIONS FROM THE SUBJECT POWER SYSTEM...

THESE ARE QUESTION FROM THE TOPIC VARIABLE LOAD ON POWER STATIONS FROM THE SUBJECT POWER SYSTEM FUNDAMENTALS PLEASE DO THE QUESTIONS STEP BY STEP AND IN NEAT HAND WRITTING THE ANSWERS ARE GIVEN WITH THE QUESTIONS 1) A generating station has a connected load of 40 MW and a maximum demand of 20 MW : the units generated being 60 × 106. Calculate (i) the demand factor (ii) the load factor. ANS [(i) 0·5 (ii) 34·25%] 2) A 100 MW...

Research on this topic and at least 2 paragraph Investing Fundamentals

ASSIGNMENT: A CRITIQUE OF THE DELIVERY OF HOLISTIC SUSTAINABILITY IN ELECTRICAL SYSTEM DESIGN PLEASE note a...

ASSIGNMENT: A CRITIQUE OF THE DELIVERY OF HOLISTIC SUSTAINABILITY IN ELECTRICAL SYSTEM DESIGN PLEASE note a key phrase in the brief is: It is important that the student takes the perspective of their prospective profession in this assignment. They should consider to what extent their chosen profession can or cannot influence the delivery of holistic sustainable solutions. Some aspects may be beyond the profession’s control, others within its sphere of influence. The barriers to delivery of holistic sustainability solution in...

The synchronous generator or alternator is an electrical machine that converts the mechanical power from a...

The synchronous generator or alternator is an electrical machine that converts the mechanical power from a prime mover into an AC electrical power at a particular voltage and frequency. The synchronous motor always runs at a constant speed called synchronous speed. A three phase, 8 pole, synchronous Generator is coupled to a diesel engine running at 500 rpm. It supplies an induction motor which has a full load speed of 1440 rpm. Find the percentage slip and number of poles...

Design a geothermal source power generation system; a) Describe the type of geothermal power plant (Total...

Design a geothermal source power generation system; a) Describe the type of geothermal power plant (Total Flow / Flash / Binary) b) Describe the turbine isentropic efficiency c) Show the entire cycle in the T-s diagram. d) Calculate the power produced. answer for expert: Not all , just one of theese three ( Total flow / flash or binary)

macroeconomic power point presentation 13 slides about a topic from this any topic

Electrical power is to be produced from a steam turbine connected to a nuclear reactor. Steam...

Electrical power is to be produced from a steam turbine connected to a nuclear reactor. Steam is obtained from the ractor at 540 K and 36 bar, the turbine exit pressure is 1.0 bar, and the turbine is adiabatic. a) Compute the maximum work per kilogram of steam that can be obtained from the turbine. A clever chemical engineer has suggested that the single-stage turbine considered here be replaced by a two-stage adiabatic turbine, and that the steam exiting from...

security surge Protection Surge protectors and uninterruptible power supplies offer protection from electrical power surges, as...

security surge Protection Surge protectors and uninterruptible power supplies offer protection from electrical power surges, as you learned in the Protecting Hardware section of this module. While these surges are part of everyday life, they are more likely to occur during thunderstorms and peak energy consumption periods. These unavoidable occurrences can damage or ruin sensitiveelectronic equipment. The processor in a computer is particularly sensitive to the fluctuations in current. When shopping for a surge protector, purchase the best product you...

Subjects